主要的技术特点是采用了底部加热区。
The major quality feature is that thermal oil runs through the boiler rear wall, and simultaneously cools it.
炉体分为预热区、加热区、保温区、缓冷区。
It is divided into preheating zone, heating zone, heat preservation zone and natural cooling.
试验结果表明：在加热区中，试样与热装置之间的传热主要受热辐射控制。
The experimental result shows that heat radiation is the major means of heat transfer between the sample and the heating device in heated area.
并通过对线聚焦加热区的温度场测量分析推断颗粒硅带的物理化学形成过程。
The performance characterization of SSP by SEM, and estimation of physical and chemical forming process of SSP by temperature field of line focused area are analyzed.
无氧化段由入口密封室，废气预热区，直接加热区，炉喉，废气排放系统组成。
The non-oxidizing zone is consisted of entry sealed room, waste gas preheating zone, direct heating zone, and furnace nozzle and flue gas exhausting system.
本文运用商用流体动力学软件CF X数值模拟了非加热区对窄缝流道内流场和温场的影响。
With the commercial computational fluid dynamics code CFX, the effect of unheated region of narrow side on flow field and temperature field of a narrow channel is simulated in this paper.
在他的全球变暖实验中，他按照格子状悬挂加热器，以组成加热区和非加热区，来来回回，这样来判款交互影响。
In his global warming experiment, he suspended heaters in a grid pattern to create heated plots, then unheated plots, back and forth, so he can judge the effects side by side.
针对一种蓄热推钢式加热炉三个加热区的炉温稳态优化问题，本文提出了一种混合粒子群优化(HPSO)方法。
A hybrid particle swarm optimization (HPSO) approach is presented to solve the problem of optimizing the steady-state temperatures of the three zones of a billet reheating furnace.
在对流加热区，大量的潜热释放形成深厚的热源和水汽汇，热源峰值出现在上部对流层，水汽汇峰值出现在下部对流层；
In the convectively heating region latent heat release causes a heating peak in the upper troposphere and a moisture sink in the lower troposphere.
在这之外是厚度为几百到几千公里的过渡区，它由在其上的日冕加热，并发射大部分光和紫外线。
After that is the transition region a few hundred to a few thousand miles or kilometers thick, which is heated by the corona above it and sheds most of its light as ultraviolet rays.
美国、欧元区还有英国，则更像平稳加热的水里的青蛙。
The U.S., the eurozone and the U.K.might more closely resemble the frog in a pot of ever-so-gradually hotter water.
从外部看，同一的持续空间在不透明的建筑间创造了二元性，建筑内有客厅、卧室和服务区，以及加热游泳池和桑拿房的通透延展空间。
Externally, the same continuous volume creates a duality between an opaque block - where the living room, bedrooms and service areas are - and the transparent stretch of the heated pool and sauna.
通过对基片加热材料的微波设计，在MPCVD装置中获得大于基片台直径的均匀温度分布区。
By microwave designing for substrate heating materials, the larger uniform temperature field areas than the diameter of substrate holder in MPCVD device is obtained.
通过对铸焊齿轮的材料和结构的分析，利用“加热减应区”法及适当的装配焊接顺序，成功地焊接了异种金属的合金钢齿轮。
Through the analysis of material and construction, the dissimilar steel gear is successfully welded using stress reduction zone by heating and proper assemble and welding sequence.
本文用晶体区熔生长理论对激光加热基座法生长的单晶光纤形状稳定问题作了研究。
In the paper, the shape stability of single crystal fibers grown by laser heating float zone growth method is studied with zone melt growth theory.
论述了端出料轧钢加热炉“传统”炉头、“少闲区”炉头、“短滑坡”炉头的构造及其在热工方面的特性。
The structures and thermotechnical characteristics of reheating furnace heads of the traditional, useless-space reduced and short-landslide types are discussed.
力学性能测试结果表明，除在临界二相区加热外，二次热循环均使粗晶区得到初化。
The results show that toughness of the coarse grained HAZ is improved after second welding heat cycle except intercritical two-phase heating.
研制成功加热炉用冶金熔接钴合金复合垫块，并对新型垫块的熔接区的显微组织和性能进行了评估。
The compound pad used in heating furnace is developed and evaluation is performed on micro organization and performance.
当我让少量水运行到一个池塘，当有许多单位区用石块和根源，水加热。
And when I let only a little water run into a pond, and when there are many flat zones with stones and roots, the water heats up.
该台车炉配套自动控温柜，分别对多区加热进行自动控温和对炉门炉体运行控制。
The car furnace supporting automatic temperature control cabinet, respectively, multi -zone automatic temperature control and heating furnace operation control on the door.
讨论了在相变区的加热速度、奥氏体化温度及保温时间对奥氏体晶粒的影响。
The influence of the rate of heating at phase transformation region, temperature of austenitizing and holding time on the austenite grains are studied.
其原因包括在喂料区加热时间太短和在过渡区熔融太慢、混合不良、在机筒和口模中存在过多的热量损失。
Causes include heating too quickly in the feed zone, melting too slowly in the transition zone, insufficient mixing, and excessive heat loss in the adapters or die.
探讨了焊接加热对热影响区组织的影响。
The influence of weld heating on microstructure of heat affected zone was investigated in this paper.
利用1982 ~ 1996年每天两次的NCEP再分析资料，研究青藏高原地面加热场的日变化对亚洲季风区环流的影响。
The impact of the diurnal variation of the surface heating in the Tibetan Plateau on the circulation over the Asian monsoon region is analyzed using the twice daily NCEP data from 1982 to 1996.
本文针对多区两级时滞加热炉对象，提出一种双闭环自适应控制算法。
In this paper, a double closed-loops adapting control algorithm for the cascade time-delay plants has been proposed.
预热区使用加热器加热，温度可控，可满足各种绝缘需求。
Preheating zone with taper design, use heaters heating, temperature can control, can meet all kinds of insulation varnish requirements.
在工业生产条件下测量了铸坯加热温度分布，工业试验确定了加热炉经济负荷运行区。
By the industrial experiment, the distribution of continuous casting billet preheating temperature is measured, and the economic load range of reheating furnace is established.
本文运用差分法求解了聚焦超声加热的二维稳态温度场，比较了声场与温度场的特征，分析了耦合层厚度与治疗区大小、位置的关系。
Characteristics of sound field and temperature field, and the relation between the width of coupling layer, the size and the position of treated area are presented.
发现，HQ70钢过热区粗大非平衡组织，经第二次快速加热到正火区，并没有出现通常所认为的“细化品粒”现象，而是出现了“组织遗传”。
It was discovered that structural heredity phenomenon took place in the non-equilibrium structure of overheated zone of HQ70 steel after another quick heating.
通过误差分析及湿度探针的校验表明双区加热法测量蒸汽湿度能够满足测量的要求。
The double region heating method is suitable for monitoring wetness fraction of steam turbine exhaust on line, which is proved by the error analysis and the calibration of wetness probe.
应用推荐