其加热介质是导热油。
加热介质流过加热器管，而燃气则注入加热器壳程。
The heating medium will flow through the heater tubing while the fuel gas will fill the shell side of the heater.
用途：用于烘箱、烘道加热，一般加热介质为空气。
Applications: Used in oven, bake, heating, heating medium for the general air.
由于商业灭菌所要求的热处理需要高温，因而典型的加热介质是高压蒸汽。
Since the thermal processes required for commercial sterilization require high temperatures, the typical medium for heating is high pressure steam.
由于商业灭菌所要求的热处理需要高温，因而典型的加热介质是高压蒸汽。
Other factors influencing the process are the size of the container and the types of heating and cooling media utilized.
本发明的技术方案，采用熔融焊料作为加热介质，对电路板焊接面上的焊点进 行加热；
The technic proposal of the invention adopts the melting welding material as the heating medium and heats the welding pots on the welding surface of the circuit board;
然后，将在回收步骤中加热后的加热介质作为用于干燥的加热介质气体引入到干燥工序中。
Then, the heating medium heated in the recovery process is introduced into the drying process as a heating medium gas for drying.
采用油作为加热介质对焊锡进行加热，再通过超声波振动去除电路板上的焊锡，从而把电路板上的元器件拆卸下来。
Using oil as heating medium to heat soldering tin, then disassemble it by ultrasonic vibration and consequently disassemble the PCB's components.
中空的干燥盘内通入加热介质，加热介质形式有饱和蒸汽、热水和导热油，加热介质由干燥盘的一端进入，从另一端导出。
The heating media, which could be in forms of saturated steam, hot water or heat conducting oil will be led into hollow drying plates from one end to the other end of the dryer.
利用溶剂溶解回收的聚苯乙烯塑料，将其涂布于不锈钢传送带上，以水蒸气为加热介质，经薄膜干燥法获得再生聚苯乙烯树脂。
The recycled polystyrene was dissolved in organic solvents and coated on stainless steel deliver. The polystyrene resin can be regenerated by heating the thin films on water vapor.
本文对比分析了氮基保护气氛和真空两种热处理加热介质对300M钢疲劳性能的影响，并研究了热处理后表面喷丸强化对300 M钢疲劳性能的改善情况。
In this paper, the effect of heat treatment by the nitrogen atmosphere and vacuum furnace and shot peening thereafter on fatigue properties of 300m steel were studied.
整个系统都要有介质加热和注入防冻液的途径，以避免形成类似冰的甲烷水合物（译者注，即可燃冰）。
Throughout the system there would be ways of warming things up and injecting antifreeze to stave off the formation of icelike methane hydrates.
罐体上设有米洛板或迷宫式夹套，可通过加热或冷却介质来进行循环加热和冷却。
On the tank tody install Milo board or labyrinth type clamp cover, which can contain heating or cooling medium to heat or cool cyclically.
为了生产出炸薯条，必须把它们加热到很高的温度，这会放出一些化学物质如acrylimide. Acrylimide是一种致癌介质，它同样会引起神经损伤。
In order to make French fries, they must be cooked at high temperatures which cause the chemical, acrylimide to be released. Acrylimides are a known cancer causing agent that also causes nerve damage.
微波技术作为一种传播介质和加热能源已被广泛应用于各个科学领域。
Microwave irradiation as a spread medium and calefaction energy sources is widely applied in all fields of science.
采用复合传压介质和动态补压、非恒功率加热等工艺进行了合成试验。
The experiment was carried on by using the compound pressure transmission medium, dynamic compensating pressure and non-permanent power heating.
分别采用超声波震荡、加热下介质处理、稀碱处理等方法研究亚微米超细TATB夹杂酸的脱除。
Methods of eliminating acidity in submicron TATB have been studied applying consecutively the ultrasonic shaking, medium treatment upon heating, dilute alkali treatment etc.
本文研究了沸腾传热过程中不同加热方式，不同几何结构表面和工作介质对沸腾滞后的影响，并提出了减少滞后对沸腾传热影响的措施。
The effects of heating ways, geometric surfaces and working media on hysteresis are studied in boiling heat transfer, and the ways of lessening hysteresis are proposed.
酮与稳定膦叶立德在家用微波炉中加热，在无任何溶剂或固体介质条件下，4。
Ketones and stabilized phosphorus ylides were heated together in commercial microwave oven, under solvent and medium free conditions, the Wittig reaction finished within 4.
以水和正己烷作为介质，考察了通入空气对内管加热的竖直圆柱形环隙内的沸腾传热性能的影响。
Heat transfer of nucleate boiling of water and n-hexane in a vertical cylindrical annulus with inner side heated has been experimentally investigated.
目前，在锻造等热塑性成形生成过程中常采用快速加热和介质保护加热等方式来减少和防止坯料在加热过程中的氧化。
At present, quick heating or medium protected heating to reduce or prevent oxidation during heating are often used in the process of thermo-plastic forming such as forging.
恒温型热式流量计加热探头与被测介质之间交换的热量不仅与质量流量有关还与被测介质的温度有关。
The heat exchanged between the probe of constant temperature thermal flowmeter and the flow correlates not only with the mass flux but also with the flow temperature.
根据所输送介质需要还可提供加热或冷却结构。
According to the need to still can provide heating or cooling medium structure.
提出了采用加热空气介质的高温空气槽测定材料热变形温度(HDT)的方法，通过几种高分子材料在油浴中及高温空气槽中测定HD T值的比较。
The way of heating air by using high temperature-air container was designed for the measurement of the heat deflection temperature (HDT) of polymer materials.
热敏介质的印刷起始位置位于感热式印刷头的加热元件下面。
The thermal medium print starting position is located under a heating element of the thermal printhead.
对炼油装置中两相流介质进加热炉如何均匀分配的问题进行了分析和探讨。
Analysis and study for how to uniformly distribute the two - phase flow to the heater inlet in hydrocracking unit is done in the article.
本文就含水的倾斜多孔介质层在侧向加热条件下流体热对流稳定性问题进行试验研究。
A experimental investigation on the stability of thermal convection in a sloping porous Medium under lateral heating is reported.
输送流动性差，粘度较高的介质或需要所输送介质进行加热或保温时选择双层加热泵体结构的泵；
The transport mobility is poor, medium or high viscosity media transport needs of the selection of heating or insulation layer structure of heat pump pumps;
输送流动性差，粘度较高的介质或需要所输送介质进行加热或保温时选择双层加热泵体结构的泵；
The transport mobility is poor, medium or high viscosity media transport needs of the selection of heating or insulation layer structure of heat pump pumps;
应用推荐