并详细介绍了功率驱动电路及逻辑控制电路。
Then discuss the power drive circuit and the logic control circuit in detail.
具有信号调理和功率驱动电路设计与调试经验；
With signal conditioning and power-driven circuit design and debugging experience;
解决了CCD的时序电路及功率驱动电路设计问题。
The paper designs the circuits of working clock and power driver for CCD.
重点介绍了功率驱动电路和驱动信号分配电路的设计。
The design of the power driver module and distributive circuit of driver signals were discussed in detail.
不要连续使用超过系统的最大输入功率驱动扬声器系统。
Do not drive the speaker system with a continuous wattage exceeding the maximum input power of the system.
介绍了电磁浮轴承的控制原理及对功率驱动电路的要求。
Presents the control principle of electromagnetic bearing and the requirements of the power drive circuit.
介绍了ECU输出接口功率驱动电路的特点和工作原理。
Features and the working principle of the power circuit of ECU output interface are introduced.
采用功率分配器保证两声光q开关的同步和有效功率驱动。
The power divider for ensuring two AO Q-switch synchronization and effective power driving is designed.
由PW M脉宽调制器驱动功率驱动电路，输出电流信号驱动比例电磁铁。
This output transferred thorough PWM driver circuit and changed into current signal to the proportional magnetic valve.
功率器件采用智能功率驱动模块，其内置的保护电路大大提高了系统的可靠性。
The Intelligent Power Module is been used for power instrument, its inner protect circuit raise reliability of the system.
在原来在线检测的硬件系统中加入功率驱动板，就构成了闭环模糊在线控制系统。
The fuzzy on-line control system of close-loop is made up when the power driver board is added in primary on-line checking system.
垃圾转运站和直流电动机驱动器组合系统既经济又非常具有竞争性的低功率驱动器。
The RTS drive and DC motor combination is economical and extremely competitive for low-power drive systems.
应用结果表明，采用该方法设计的功率驱动单元性能优良，已成功应用于电动汽车驱动系统中。
The application result shows that the performance of the power driver unit is well and has been used in the driving system of the electric vehicles successfully.
提出了将传统单个储能电感利用传输线分隔成两部分的新型电感储能脉冲功率驱动源技术方案。
A novel inductive energy storage pulsed power source design has been presented, with two energy storage coils separated by a water transmission line.
该系统以PWM方式工作，应用IGBT功率模块构成功率驱动单元，采用8098单片机作为中央控制器。
The system operates in PWM mode using IGBT modules as power drive unit and 8098 sc computer as central controller.
采用高频脉宽调制功率驱动电路进行电磁阀的高速强力驱动，并利用电流微分信号有效反馈了控制阀关闭始点。
The ECU accomplishes the fast energizing of the solenoid valve by driving circuit with high frequency PWM, and detects the start of injection by the differential signal of driving current.
所设计的无刷直流电机稳速控制系统用电机控制专用芯片ML4428实现了反电势的检测、换相和功率驱动；
Using the motor control special chip ML4428, the counter electromotive force detection and back-EMF commutation were realized.
因为激烈的价格竞争以及对较低额定功率驱动的偏好，中国的中压驱动平均销售价格比全球平均销售价格低很多。
The average selling prices of medium voltage drives in China are much lower than the global average because of intense price competition and the prevalence of drives with lower power ratings.
L 297芯片产生脉宽可调的脉冲相序信号，该信号作为双极性桥式功率驱动电路的输入信号，放大后驱动步进电机。
L297 chip generates pulse phase sequence signals of which the pulse width is adjustable. The signals are the input ones of dual bridge driving circuit and drive the stepper motor after amplification.
建立了包括电流控制电路、功率驱动电路以及五相混合式步进电动机在内的恒频斩波恒总流驱动系统的完整的数学模型；
Mathematical model of the system, included the current control circuit, power driving circuit and five-phase hybrid stepping motor is established.
设计了一款基于DDX功率驱动技术、既具有USB数字音频接口又具有模拟音频接口的数字音频功率放大器upa001。
In this paper, a new kind of digital audio power amplifier on DDX is proposed and tested, which is UPA001 not only with a USB digital audio interface and but an analog audio interface.
作者介绍了PMM 8713与SI- 7300的功能，给出了由它们组成的功率驱动电路及其在步进电机上的应用方法。
The functions of PMM8713 and SI-7300 are introduced, providing a power driving the circuit and an application method to step motors.
双回转机构的步进电机控制电路由TDA1521音频集成功率放大器组成平衡桥式功率驱动电路，由计算机并行口经过锁存器构成脉冲分配器。
To control stepping motors, the balance bridge power drive circuit is made up by TDA1521 integrated audio power amplifier, the pulse allotter is made up by the parallel ports of computer and latches.
在无刷直流电动机驱动的雷达伺服系统中，采用了智能功率驱动模块(IPM)来实现功率驱动，它能够满足苛刻的环境要求，并能获得比较满意的系统性能。
Intelligent Power IC (IPM) is applied to a radar servo system, which is drived by brushless DC motor. The system can be used in harsh circumstances and get some satisfactory performance.
此外还研究了高宽长比功率驱动MOS晶体管的版图优化设计，通过采用高密度的版图结构使有效宽长比密度提高了一倍，从而使其占用的版图面积为缩小为原来的一半。
Besides, in order to minimize the area of output driving MOSFET, high W/L density structure is adopted with effective W/L density being doubled compared with normal MOS structure.
本文采用UC 3846作为PWM发生器，桥式驱动的脉冲变压器既保证信号的传输，又保证足够功率驱动全桥逆变主电路。对于经常发生短路刷镀刷镀工艺，快速过电流保护非常必要。
UC3846 is used for PWM, pulse transformer driven by bridge can transfer signal and power for IGBT in main circuit, quick protection is necessary for short circuit often happen during brush plate.
混合电力驱动是集成功率管理系统技术的基础，后者设计用于满足未来地面战斗车辆在网络环境下的需要。
The hybrid electric drive is the cornerstone of integrated power management designed to meet the demands of future ground combat vehicles in a networked environment.
这些精度放大器可以用于驱动电机、压电设备、可编程电源以及其他需要高功率和精确控制的设备。
These precision amplifiers are used for driving motors, piezo electrics, programmable power supplies, and other devices requiring high power and precision control.
这些精度放大器可以用于驱动电机、压电设备、可编程电源以及其他需要高功率和精确控制的设备。
These precision amplifiers are used for driving motors, piezo electrics, programmable power supplies, and other devices requiring high power and precision control.
应用推荐