介绍了以激光输出功率为对象的激光谐振腔的自适应过程，从而使激光器输出功率一直处于良好状态。
This article describes adaptive process of laser resonator for laser outpower, so that laser outpower is with better status.
因此，生态学目标函数不仅反映了输出功率和熵产率之间的最佳折衷，而且反映了输出功率和热效率之间的最佳折衷。
So it represents not only a compromise between the power output and the entropy generation rate but also one between the power output and the thermal efficiency.
从理论和实验上分析了剩余反射率与SLA的输出光功率关系及温度对其输出功率的影响。
The relations among the residual reflectivity, temperature and the output power of SLA are analyzed theoretically and experimentally.
它提供了一个输出功率最大的输出功率为160千瓦(218马力)与增加了33马力相比，生产的发动机，装备了207钢筋。
It delivers a power output of a maximum power of 160 kW (218 BHP), with an increase of 33 HP compared to the production engine that equips the 207 RC.
获得了在最大生态学函数条件下的最佳效率、输出功率和熵产生，并与在最大输出功率条件下的结果进行比较。
The optimal efficiency, output power and entropy production at the maximum of an ecological function are obtained, and are compared with those results at the condition of maximum output power.
着重研究了抽运功率、腔长、输出镜透过率以及初始透过率等因素对激光输出脉冲序列的重复率、脉冲宽度以及输出功率的影响。
The focus is given to the influence of pumping power, cavity length, the output coupler transmission and initial transmission on the repetition rate, pulse width and output power of laser output.
由于光泵浦热效应，高功率固体激光器的输出参数如光束远场发散角、输出功率等会发生变化。
The output parameters such as beam divergence angle in far-field output power of high power solid state lasers are variable due to thermal effect of optical pumping.
分析结果表明：在多信号输入时，输出功率中确实有输入信号的互调制分量产生，同时可以发现，对于宽频带的行波管，互调制分量对主工作频率输出功率有比较大的影响。
The results show that: when two signals are inputted into TWT, the output power includes the intermodulation components, and the intermodulation components have important effect on broadband TWT.
在无催化剂的情况下，获得U型腔激光器输出功率3.5W和相同条件下的直线型激光器输出功率4.5W，证实了该U型腔设计的可行性。
The power output of U-folded laser without catalyzer, 3.5W has been gotten, while the corresponding unfolded laser, 4.5 W. This result indicates the availability of the forementioned design.
在单个器件输出功率有限的情况下，往往需要采用功率合成技术来实现更大功率输出。
As a single solid-state device's output power is low, power combining technology is usually used to achieve higher power output.
通过功率合成器将E类放大器的输出功率叠加起来，作为高效的大功率RF发射机的功率输出源；
The merge of the output power of class E amplifiers with the power synthesizer was used as the source of power of the RF emission machine with high efficiency and power.
据粗略估计，nu ？ez - Ameni说道，该风电场的输出功率等同于覆盖同区域的一座传统风电场的输出功率。
Based on rough estimates, said nu? Ez-Ameni the output would be comparable to that of a conventional wind farm covering the same area.
目前激光器输出功率受限于泵浦功率，增加泵浦源的数目有望进一步提高输出功率。
The experimental results have demonstrated the potential for higher output power with more powerful pump source.
而这时往往需要输出较大功率，电压下降导致电机输出功率大大减少，严重影响了电动汽车的动力性能。
Meanwhile the electric vehicle need a large power output from the power system. Therefore the power system control and dynamic performance of electric vehicles will become worse.
宝钢现有两种配置形式的TRT装置，其工艺设计参数相同，但设计输出功率不同，实际输出功率也不同。
Now there are two forms of disposal for TRT device at Baosteel. They are same in parameter for technical design, but different in design output power and actual output power.
输出功率可以手动调整，以提供在任何条件下的最准确的数量和循环时间很短，即使在使用的最大功率输出情况下也能确保快速反应，。
The power output can be manually adjusted to provide the most accurate amount of light in all conditions and a short recycle time ensures quick responsiveness even when using the maximum power output.
最后分析了全光译码器的输出功率和输出消光比与输入泵浦光功率、探测光功率之间的关系。
Finally, it also analyzed the relationship between the input pump power and the probe optical power and its output power and output extinction ratio.
讨论了纯电阻电路、非纯电阻电路电源输出功率和损耗功率，分析了输出功率最大值出现的条件及相应的公式。
This paper has discussed the power delivered by the power source lossed in the pure resistor element circuit. Condition of the maximum delivering power has been analysed and equation has been written.
同时从理论上分析了增益光纤长度、泵浦功率、输出镜透射率等因素对激光器输出脉冲波形和输出功率的影响。
The parameters, such as the fiber length, pump power and the transmissivity of the output mirror, which affect the output power and pulse linewidth, were analyzed.
将光纤缠绕至两种不同半径，实验测量了相应条件下激光器的输出功率和光束质量因子M2。缠绕半径为165mm时，输出功率为217W，M2为2.96；缠绕半径为52mm时，输出功率为160W，M2为1.38。
Output powers and beam quality factors M2 are measured under two different coiling radii. 217 W with M2 of 2.96 can be obtained for coiling radius of 165 mm and 160 W with M2 of 1.38 for 52 mm.
将光纤缠绕至两种不同半径，实验测量了相应条件下激光器的输出功率和光束质量因子M2。缠绕半径为165mm时，输出功率为217W，M2为2.96；缠绕半径为52mm时，输出功率为160W，M2为1.38。
Output powers and beam quality factors M2 are measured under two different coiling radii. 217 W with M2 of 2.96 can be obtained for coiling radius of 165 mm and 160 W with M2 of 1.38 for 52 mm.
应用推荐