设计出传感器输入输出信号调理电路和试验台架液压激振系统、磁流变阻尼器控制器的功率放大电路。
Design the signal adjust circuit for sensor, and the power amplification circuit for the hydraulic pressure system of test platform and the controller of magnetorheological dampers.
理论分析结果表明，单周控制开关功率放大器的输出信号与输入信号成线性变化关系，其控制性能由输出滤波器决定。
The theory research results of one cycle controlled switching power amplifier show that the output signal follow the input signal linearly, and the control performance is decided by output filter.
介绍了一种新型的压力先导控制伺服阀，该阀的功率放大级采用双阀芯结构代替传统单阀芯结构。
A new servovalve using a pressure control pilot state was introduced, which USES two spools instead of single spool in power magnifying stage.
内置功率放大电路，可以单独成为一个小系统，并受主信号强切优先控制。
Built-in power amplifier circuits that can be a small system, and strong signal by cutting the main priority control.
为了实现垂直位移方向上的稳定，给主动控制线圈供电的功率放大器的响应速度必须具有快速性。
In order to realize a stabilization system, the response rate of the power amplifier feeding the stabilization coils must be fast enough.
提出了一种为电流型功率放大器所用的新的滑模控制方法。
A kind of new sliding mode control method for current type power amplifier is put forward.
针对径向力的控制要求研制了双向电流型线性功率放大器和PID控制器。
The linear power amplifier of current-type and the PIDcontroller is designed for the control of radial force.
本文介绍了单片机控制的PW M直流功率放大器的结构形式、硬件电路以及软件设计。
This paper introduces the structure, hardware circuit and software design of PWM DC power amplifier controlled by microcomputer.
功率放大器是控制器控制命令的执行者，它的性能对整个系统有着重要影响。
The power amplifier is executor of the controller's control command, its performance has important influence on the overall system.
为了实现垂直位移方向上的稳定，给主动控制线圈供电的功率放大器，其响应速度必须具有快速性。
For realizing the stability in vertical displacement, the power amplifier must be fast in response for feeding active control coils.
介绍了用工业控制计算机控制卫星地面站功率放大器的一种方法，阐述了控制系统的硬件和软件基本组成。
This paper introduce a method that industry control computer controls power amplifier in the satellite earth station, and expound the structure of the hardware and software of the control system.
双回转机构的步进电机控制电路由TDA1521音频集成功率放大器组成平衡桥式功率驱动电路，由计算机并行口经过锁存器构成脉冲分配器。
To control stepping motors, the balance bridge power drive circuit is made up by TDA1521 integrated audio power amplifier, the pulse allotter is made up by the parallel ports of computer and latches.
文中着重介绍了系统架构、DS P控制板、波形产生算法和功率放大器的设计。
The design of the system fabric the DSP control board the algorithm of waveform generating and the power amplifier are introduced.
研制一套以单片机PIC16C54为核心的专业音频功率放大器控制系统。
The control system of professional audio power amplifier is developed , centered around MCU controller PIC16C54.
本系统主要由数字频率合成电路、调制电路、宽带功率放大、单片机控制系统等模块构成。
The system is mainly composed of Digital Synthesis circuit, modulation circuit, broadband power amplifier, the MCU control system, and a module.
智能天线子系统中，射频前端模块包括线性功率放大器，低噪放大器，检测控制电路。
In intelligent peripheral subsystem, Radio Frequency Front Modules include linear power amplifier, low noise amplifier and detection control circuit.
在需要回放时，再由单片机控制提取RAM中的数据，通过D/A转换器将数字信号转换为模拟信号，通过功率放大器将语音信号还原后回放出来。
When this system needs to playback, data is gotten from RAM, and it transforms into the analog signal through the D/A switch. Moreover through the power amplifier, the voice signal can be recovered.
该功率放大器同时包括动态控制偏置电路和完全集成的功率检测器。
The power amplifier contains dynamic control bias circuits and a fully integrated power detector.
基于H型双极模式P WM控制原理，设计了一种直流微电机正反转调速功率放大电路。
A power amplification of H-bridge bipolar PWM control is designed for controlling DC micro-motor of positive rotation, reverse rotation and speed regulation.
在D类音频功率放大器中，驱动死区时间控制是一个很流行的术语。
Driver deadtime control is a popular scheme used to prevent the occurrence of the shoot-through issue in a Class-D APA (audio power amplifier).
控制技术是影响开关功率放大器保真度的关键因素之一。
One of the key factors of affecting fidelity of switching power amplifier is control technique.
经脉冲分配器和功率放大后控制步进电机，使步进电机的转速符合所要求的正弦曲线。
Through cyclic pulse distributor and power amplifier, the pulses drive step-motor and let the speed of step-motor in agreement with a required sine function.
节点设计方案中，网络控制器采用智能网络接口控制器OS81050，解码器采用可控音量芯片CS4341，功率放大器采用NE5532。
In the design of this node, the network controller used the intelligent network interface controller OS81050, the encoder used CS4341, the amplifier used NE5532.
为了改善电气控制系统性能，设计了适用于片状无轴承永磁电机的双向三电平PWM功率放大器和控制箱转接板。
To improve the capability of the electric system, a three-level PWM power amplifier and Backboard of the control-box is designed, which are applicable to the bearing-less slice PM motor.
AT 89s52作为显示模块的控制核心，实现功率放大器输出功率、直流电源的供给功率和整机效率功能的显示。
AT89S52 as a display module to control the core of achieving power amplifier output power, DC power supply of power and machine efficiency, for display.
本文着重介绍了磁悬浮球控制系统实验平台的硬件设计，介绍了包括位移传感器、控制器、功率放大器的设计过程。
This thesis narrates the hardware design of Magnetic Suspension ball Control System testing platform, including the design of displacement senor, controller and power amplifier.
提供控制机构，以当不需要时切断功率放大器或整个发射信号通路。
Control mechanisms are provided to power down the power amplifier, or the entire transmit signal path, when not needed.
本厂的声频功率放大器、播音控制桌椅、调音台、大型音响扩声工程等相关产品在国内久负盛名。
The main products are audio power amplifiers, broadcasting controlled tables, large sound amplifying engineering, which is well know for a long time.
收发信机可接收基带数据和控制信息，以及向功率放大器提供射频信号。
The transceiver may receive baseband data and control information and provide RF data to the power amplifier.
收发信机可接收基带数据和控制信息，以及向功率放大器提供射频信号。
The transceiver may receive baseband data and control information and provide RF data to the power amplifier.
应用推荐