研究了一种应用于工程车司机驾驶室的新型制冷管的制冷性能。
The refrigerating identity of an adsorption cooling tube applied in mobile machinery shop air conditioning is researched in this paper.
制冷管排列形成列组18。
提出了一种新型的余热固体吸附式制冷管。
A novel solid adsorption cooling tube driven by waste heat is proposed in the paper.
倒棱增加物的塑造在自动制冷管的范围内、头螺栓的座套表面。
Disc– machined seating surface is mated to seat ring for positive shutoff.
棱 增加物的塑造在自动制冷管的范围内、接头螺栓的座套表面。
Addition of chamfering shape on seating surface of joint bolt at atf cooler pipe area.
试验表明 ，制冷管内制冷剂水的充灌量对制冷管的性能影响很大。
The experiment shows that the affect of water-charge on the pump's refrigerating identity is very obvious.
研究了在吸附剂量不变的情况下，制冷剂(吸附质)充注量对制冷管性能的影响。
The effect of recharge quantity of refrigerant (adsorbate) under the condition of keeping the adsorbent quantity constant on performance of the cooling tube is studied in the paper.
它的发明者们管这种双层降温过程叫“光子辐射制冷”。
The Stanford team have called this two-layer process "photonic radiative cooling".
制冷时细铜管为压缩机的输出管，粗的时回流管。
Fine copper tube for the output of the compressor pipe cooling, thick return line.
针对渔船出海捕鱼冷藏问题，利用渔船的柴油发动机的余热，采用余热冷管进行制冷来提供冷冻保鲜需要的冷量。
Aiming at the refrigeration of the fisher, we use exhausted heat of the fisher's diesel engine as the power to drive the cooling tube.
该系统完成了对典型制冷装置的换热器部件，如板管式蒸发器、单脊翅片管式蒸发器、箱壁式冷凝器的参数化设计和绘图；
The system implements the parametric design and drawings of many typical kinds of refrigerating parts, e. x. the plate-tube evaporator, the single back-fin evaporator and the box condenser.
线性压缩机、回热器、脉冲管以及惯性管的耦合特性对高频脉冲管制冷机的整机性能有很大的影响。
Matching characteristics among linear compressor, regenerator, pulse tube and inertance tube have large impact on the performance of high frequency pulse tube cryocooler.
随着土壤源热泵在制冷工况下连续运行，埋管出口介质温度和管井壁面温度逐渐升高。
Along with GSHP running at refrigerate condition the temperatures of the out medium and the wall gradually rise.
针对渔船出海捕鱼冷藏问题，利用渔船的柴油发动机的余热，采用余热冷管进行制冷来提供冷冻保鲜需要的冷量。
Aiming at the refrigeration of the fisher we use exhausted heat of the fisher's diesel engine as the power to drive the cooling tube.
研究结果表明：涡流板同单管涡流管相比具有相同的制冷性能，为涡流板进一步研究奠定了基础。
The results show that the vortex board has the same cooling performances as vortex tube, which will lay a foundation for further study on the turbulent flow board.
由于冷管结构上的特点，其循环特性跟一般的基本型吸附式制冷循环有所不同。
The air-conditioning system with a larger refrigerating power can be constituted based on a number of simple tubular adsorption modules to meet the need.
温度的测量用DS18B20温度传感器测量，并用数码管显示测量值，用PWM控制冷却风扇控制温度到恒定值。
The measurement of temperature adopts DS18B20 temperature sensor and the measurement value is displayed by LEDs. The Fuel Cell temperature is controlled by cooling fan which adopts PWM control.
本文介绍了利用数字式温度传感器ds18 B 20构造大功率激光二极管恒温制冷系统的方法。
A precise temperature control system using DS18B20 for high power laser diode is introduced in this paper.
它由制冷器具、蓄冷盘管、冷放盘管、水泵及驱冷风扇构成。具有耗电少、噪音小、价格低廉的特点，是家庭及办公室理想制冷装置。
The said machine has advantages of less power consumption, low noise, low price and so on, and is a ideal refrigerating device for family and office.
本文通过实验，研究了塑料管溴化锂吸收式制冷机中聚四氟乙烯换热器的传热性能及制冷机组性能。
Study on the coefficient of PTFE heat exchangers and refrigerator, using the theory calculation and experimental methods.
介绍了表面增强型蒸发强化管，并对氟利昂制冷工质R22在该管外的沸腾换热进行了实验研究。
The experimental study on the performance of nucleate boiling of R22 outside the surface enhanced evaporation tubes was conducted by use of four two-sides enhanced tubes with different geometries.
首先介绍了我实验室自主开发的实用型产品：空调压缩机驱动的同轴脉冲管制冷机，然后针对实用化过程中要求脉冲管的热端长度增加的问题进行了分析，得到一些分析结果。
The problem of hot end length in actual use is proposed and a simple analysis is given, which shows the evident effect of length on pressure ration and hot end temperature.
在我院多年开发胀管机的基础上，首次研制成功空调制冷换热器超大型胀管机，解决了大片距换热器由手工胀管转变为机械胀管的难题。
The huge Tube Expander for Heat Exchanger of Air Conditioner and Refrigeration System are developed first by our institute after studying for a long time.
全新知名品牌压缩机和搞笑壳管式冷凝器、蒸发器组合、超强制冷、宁静省点。
Famous brand new compressors, high efficient shell condensers and evaporators — excellent cooling, quiet with low electric consumption.
鑫雷产品涵盖高效盘管壳式换热器、钛管换热器、镍铜管换热器、套管换热器、膨胀水箱等，广泛应用于商用空调、制冷设备、热泵热水机、泳池调温设备、海鲜池恒温机。
The products range covers high efficiency shell heat exchanger, titanium tube heat exchanger, nickel copper heat exchanger, tube in shell heat exchangers , expansion tanks and so on.
数值研究了制冷剂充灌量以及蒸发器盘管布置形式对柜内稳态温度分布的影响。
The effects of refrigerant charge and configuration of the evaporator coil on the temperature distribution have been investigated numerically.
同时，对振荡管长度、气体分配器的转速等影响脉管式气波制冷机性能的因素进行了试验。
The factors, the length of shock tube, the distributor rotor speed and the ratio of gas expanding, which affect the…
冷凝器应用—用于制冷高压侧的冷凝盘管，高温高压蒸汽在冷凝器中冷却为饱和过冷状态的液体。
Air condenser - For the condensing coil in the high side of Refrigeration System. high temperature and high pressure steam is cooled into saturated super cooled liquid in the condenser.
使用了一种新型材料制成的感温管，代替了微型节流制冷器原来自调机构的不锈钢感温管。
A temperature induced tube made from new material is used on self regulating cooler, instead of the former stainless steel temperature induced tube.
本文研究制冷剂r 113和废塑料制汽油过程中产生的裂解气在水平光滑管、螺纹管与“犁刺”管上的冷凝强化传热。发现“犁刺”管的制冷传热效果约为光滑管的14倍，为螺纹管的10倍。
This paper researches into enhanced heat transfer of condensation of splitting gas of waste plastics and R113 on the general smooth tubes, the screw tubes and the aculei finned tubes.
应用推荐