它由软件工程研究所(SEI)开发，CMM是为软件过程改进开发的初始模型。
Developed by the software Engineering Institute (SEI), CMM was the initial model for software process improvement.
研究了线性光纤中色散导致初始频率啁啾的高斯光脉冲展宽的详细物理过程。
The physical process of frequency chirped Gaussian pulses broading induced by the group- velocity dispersion has been studied.
综述了关于高聚物在熔融混合过程中能量消耗及初始阶段形态演化的研究现状。
Recent research on energy consumption and morphology evolution during the initial stage of polymer melt compounding is reviewed.
研究发现，在进气过程的初始阶段，缸内始终存在一对旋涡，并且沿气缸轴线向下缸内流体出现逐步融合的趋势；
The results show that there are a couple of vortexes trending blend along the axes in the cylinder at the initial phase of intake process.
通过仿真研究，确定了遗忘因子和初始条件的最佳值，实现了对过程故障诊断和预报。
The optimum values of oblivious genes and initial conditions can be confirmed, and also the process fault diagnosis can be realized through the simulation experiments.
由于本篇论文是关于空闲状态下手机脱网现象的研究，所以，本文详细介绍了手机的初始化状态和空闲状态的处理过程。
Because this is the study on the mobile in out-of-service in the idle mode, there are the detailed introductions about the operation process of initialization mode and idle mode.
试验研究结果表明：采用的一整套滑坡监测仪器，能监测滑坡从初始蠕变到破坏的全过程；
The research results indicate that the whole set of landslide monitoring instrumentation is capable of monitoring a landslide process, from initial creep to failure.
以常规光纤中的皮秒脉冲孤子效应压缩过程为基础，研究了在有无损耗的光纤中初始啁啾对脉冲压缩的影响。
The effect of initial chirp on the quality of the soliton-effect picosecond pulse compression in loss and no-loss fibers is studied by simulating the process of compression in conventional fibers.
以最新的激光动光弹为实验手段，对初始应力条件下的爆破应力波的传播过程进行了实验研究。
A new dynamic holophotoelasticity method is used in laboratory test to study propagation of dynamic stress by blasting subjected to initiative stress.
通过内配碳球团的热风穿流干燥实验，研究了不同热风温度、流速、球团初始湿含量以及生球尺寸对干燥过程的影响规律，并对球团的爆裂温度进行测定。
The influence of different parameters on drying process is studied in hot air cross-flow experiment, which includes air temperature, air speed, initial moisture content and size of raw pellets.
在一维炉上对煤粉再燃过程中烟气内主要气体体积分数随再燃区初始氧体积分数的变化规律进行了研究。
The variations of main gas volume fractions with initial oxygen volume fraction during pulverized coal reburning were investigated using a one-dimensional flame furnace.
接着本文对不同初始半径的单个空化泡在刚性壁面附近的溃灭过程进行了研究。
Then the collapse process of different initial radius single bubble near rigid wall is studied.
通过对该问题的研究，认为无论采用何种方式关井，其求解过程相似，只是初始条件有变化。
According to this problem, the solutions for different shut-in procedures are similar except for the initial conditions.
把这些缺陷简化为冻土中的初始裂纹，应用断裂力学理论和试验方法，研究冻土的非线性断裂过程和特征。
Supposing the defects as the initial crack, using the theory and testing method of fracture mechanics, the nonlinear fracture process and character of frozen soil are investigated.
建立三维有限元模型模拟轮胎硫化过程，研究初始硫化温度对轮胎硫化温度场及程度场的影响。
The influence of the initial curing temperature on the curing temperature field and curing state field of tire was investigated by simulating the curing process of tire with a 3D FE model.
研究了不同的加料方式、反应物初始浓度配比以及干燥方式对合成过程和粒子性能的影响规律。
The effects of the feeding ways, the initial concentration of the reactants and the drying methods on the particle morphology were studied.
通过对不同初始条件下界面失稳过程的模拟和分析，研究了混合气体的组元、温度，来流的压力、温度、速度对过驱动爆轰波形成的影响。
With simulation of unstable interfaces with different gas species, temperatures, inflow pressures and velocities, overdriven detonation initiation process is analyzed and illustrated.
在马赫8炮风洞中开展了不同初始真空压力条件下风洞喷管启动过程对侧压进气道启动的影响研究。
Effect on inlet starting of nozzle starting process was studied in a 500 mm Mach 8 gun tunnel.
研究结果表明，以线性表格为基础的修正方式不能完全控制瞬态过程空燃比的偏移，初始阶段的空燃比偏移脉冲难以避免。
The study shows that the modification manner based on linear table can't eliminate the AFR excursion in transient and the AFR pulse at the beginning of transient is inevitable.
研究者用探测、说明、解释的过程将39个初始变量简化成四个主要因素，并将这个四个因素看成是数据库辞典质量因素。
Using processes of exploration, explanation, and interpretation, researchers reduced the initial 39 variables to 4 main components, regarded as the main DB thesaurus quality factors.
在一维炉上对煤粉再燃过程中烟气内主要气体体积分数随再燃区初始氧体积分数的变化规律进行了研究。
The numerical simulation and experimental study on the rule of the NOx reduction in the micronized coal reburning has been done.
采用SBR法研究了不同曝气量、初始污泥浓度和进水COD质量浓度等条件下，有机物在降解过程中温度对DO变化的影响。
DO variation with temperature under the conditions of changing aeration rate, MLSS density and influent COD in the process of the organism degraded.
用俄歇电子能谱 （AES）研究高真空室中纯铁和多能量叠加注碳纯铁表面与氧气吸附及初始氧化过程。
The initial oxidation of pure iron and implanted samples which were overlapped energy ion–implanted with C ions was studied by auger electron spectroscopy (AES).
论述了基于数控立式车床的初始总体方案设计，研究了模块选择与组合的设计次序和推理过程。
The selection and integration on the modules of the NC vertical lathe are researched, based on its primary scheme design. The order and the reasoning of the modules design are discussed.
应用动力显式数值模拟软件，研究了线性渐增和渐减变压边力下拼焊板盒形件的成形过程。建立了线性变压边力终止值随初始值变化的关系曲线，该曲线被拟合为二阶多项式曲线。
The forming of box with TWBs based on a series of linearly increasing and decreasing variable blank holding forces(VBHF)over the stroke were studied by means of dynamic explicit finite element method.
应用动力显式数值模拟软件，研究了线性渐增和渐减变压边力下拼焊板盒形件的成形过程。建立了线性变压边力终止值随初始值变化的关系曲线，该曲线被拟合为二阶多项式曲线。
The forming of box with TWBs based on a series of linearly increasing and decreasing variable blank holding forces(VBHF)over the stroke were studied by means of dynamic explicit finite element method.
应用推荐