可吸收骨折内固定材料要求具有较高的初始强度及良好的生物相容性。
Higher incipient intensity and favorable biocompatibility were imperative to the bone internal fixation material.
结论：固态压缩法可获得高初始强度和维持强度的PLLA，满足一般的骨内固定要求。
Conclusion Solid-compression process could obtain high initial and retention strength PLLA which could fit for the general bone internal fixation.
分析得到疲劳寿命概率分析方法和初始强度概率分析方法计算疲劳强度标准值具有一致性；
At the same time the conclusion that the method of calculating the characteristic value of concrete fatigue strength using fatigue life agrees to that using initial strength is presented.
目的探讨有效提高假体-骨结合面的匹配度，加强假体初始固定强度，并使假体外形更为优化的方法。
Objective to improve the fitness and initial fixation strength between the hip and bone and to optimize the shape of the prosthetic implants.
试验研究表明，水泥掺入比、初始含水量和夯实功对夯实水泥黄土的抗剪强度、压缩性和微观结构有着重要的影响。
The results indicate that cement mixing ratio, water content and comparative effort have important influence on shear strength, compressibility and microstructure of the compacted cement -loess.
研究一种具有较高的初始力学强度和早期降解速度缓慢，并能用于承重骨内固定的器材是临床所需要的。
A new kind of biodegradable internal fixation device with high initial strength and slow early degradation, which can be used for weight-bearing bones, is required.
随着初始静态荷载的增加，混凝土的动态强度趋于减小。
With the increase of initial static load, the dynamic strength of concrete tends to reduce.
具有初始缺陷板元的极限强度可靠性分析。
Reliability analysis of ultimate strength of plates with initial impact.
根据某算例，采用极限平衡分析方法，讨论了土体的初始体积含水率、降雨的强度、降雨时间对边坡稳定性的影响程度。
The paper according to a calculating example to use limiting equilibrium analysis discussed soil mass original bulk water content rainfall intensity rainfall time impact extent to slope stability.
对玉米纤维进行不同方式的热处理实验，得出了热处理温度和热处理时间对断裂强度、断裂伸长、初始模量、断裂功的影响规律。
The impact of temperature and duration of heat treatment on the breaking strength, elongation at break, initial modulus and work to break of the fibers was investigated.
铁素体迅速应变硬化和铁素体到马氏体的载荷传递使双相钢具有较高的初始应变硬化速率和较高的强度。
The higher initial strain hardening rate and higher strength of dual phase are attributed to rapid strain hardening in ferrite and the load transfer from the ferrite to martensite.
而粒径缩尺后的接触面强度会降低，同时初始剪切模量则有所增长，其影响不能忽略。
However, the interface strength decreases after size scaling while the initial shear modulus increases, which cannot be ignored.
激光诱导荧光强度是光碎片分子初始态多极矩、线强度因子和解离—激发几何因子的函数。
The LIF intensity is a function of the initial molecular state multipoles, the line strength factor and the dissociation excitation geometrical factor.
详细地讨论了克尔非线性作用的强度以及初始压缩真空场的压缩度对原子反转和原子量子态演化的影响。
The influences of nonlinear interaction intensity of kerr medium and the squeezing degree of initial squeezing vacuum state field on the quantum properties of the atom are discussed.
结果表明，经过BDA方案优化的台风初始场更加接近实际台风的结构，有效地提高了台风路径和强度预报的准确率。
The results show that the optimal initial field produced by BDA scheme is closer to the observations and the forecast accuracy for both track and intensity is improved effectively.
随着初始磁场强度和磁化率的增大，磁场力逐渐增大。
When the initial magnetic field intensity and the magnetic susceptibility increase, the magnetic force increases gradually.
降雨强度和初始含水量是影响入渗量的主要因素。
Rainfall intensity and initial water content are important infiltration factor which influence rainfall infiltration content.
从混凝土磨蚀和力学性能试验得知，水工混凝土的磨蚀程度依赖于混凝土的初始磨损率，抗拉强度和极限拉伸变形值。
Abrasion and mechanical properties test of concrete have shown that the degree of abrasion dependent on initial abrasion ratio, flexural strength and limit strain.
初始含水量、降雨量和降雨强度是影响地被物层水分传输的主导因子。
Initial water content, precipitation quantity and precipitation intensity are the major factors influencing water transport in litters and moss layer.
讨论了初始压缩真空场的压缩度以及克尔非线性作用的强度对该量子体系纠缠特性的影响。
The influences of nonlinear interaction intensity of Kerr medium and the squeezing degree of initial squeezing vacuum state field on the entanglement of the quantum system are discussed.
采用轻质高强铝合金材料设计舟桥的甲板时，其强度计算是初始设计者最为关心的问题之一。
In designing a pontoon deck system which is made of light-weight and high rigidity material, strength calculation is one of the most concerned problems for designers at the beginning stage.
结果显示，当最大接触应力大于橡胶材料压缩强度时，极易产生初始裂纹。
The FEA results show that initial crack comes into being as the maximal Von-Mise stress exceeds the compressive strength limit of rubber.
高转换效率的信号光输出取决于抽运光和初始信号光的强度及晶体长度的最佳优化值。
The signal power output of high conversion efficiency is depended on the optimum crystal lengths, pump intensity and signal power.
试验采用的混凝土强度等级为C25，主要变化参数为初始荷载及加载历史、CFRP加固量、纵筋配筋率、锚固措施等。
Concrete intensive grade is C25, the main variable parameters such as initial load and load history, CFRP amount, reinforcement ratio, anchor measure was adopted.
在相同初始车速下平路减速制动，制动强度越小，再生制动能量回收越多。
With the same initial speeds of deceleration, the smaller the braking strength, the more regenerative braking energy recovery.
初始缺陷和强度参数为设计变量，采用一阶矩法计算单元层的失效概率。
The initial imperfection and the strength parameters are considered as random variables. Ply-level failure probability is evaluated by the first order reliability method.
根据系统的初始呼叫强度和离散接入帧长推导出系统主控信道总的业务量、接入时延及每时隙的平均接入个数，并分析了离散接入帧长对上述参数的影响。
The total call strength, access delay and average access calls for the main control channel are derived according to the initial call strength and discrete access frame length.
采用在原料土中掺入微量普通硅酸盐水泥的方法制备具有不同胶结强度和初始孔隙比的结构性土样，模拟天然结构性原状土的受力变形性质。
Applying the method of mixing some ordinary portland cement into soil sample, structrued soil with different cemented strength and initial void ratio is.
应用可靠性设计方法，对压力试验时扁平绕带式容器初始静强度的可靠度进行定量分析。
By using reliability design methods, minimal reliability of virgin static strength of flat ribbon-wound pressure vessels at pressure test is quantitative analyzed.
研究结果表明，双原子纠缠度影响场熵的平均值，而初始光场的强度则影响场熵演化的振荡特性。
The results show that the entanglement of atoms affects the mean-value of field entropy and the intensity of field affects the oscillation properties of field entropy evolution.
应用推荐