对某个特定磁探针来说，其初始信号峰值与速度成正比的条件是速度大于某个阈值。
For a typical magnetic needle, the initial signal peak became proportional to the velocity step after a threshold value of velocity was over taken.
高转换效率的信号光输出取决于抽运光和初始信号光的强度及晶体长度的最佳优化值。
The signal power output of high conversion efficiency is depended on the optimum crystal lengths, pump intensity and signal power.
训练免疫系统识别肿瘤新发或复发初始信号后，它们便能在最早期开始攻击恶性肿瘤，这个时间远早于最好的扫描技术能侦测到这些肿瘤的时间点。
An immune system trained to recognize the first signs of new or recurrent growth can begin to attack malignancies far earlier than the best scans can detect them.
为了对信号量集数据结构进行初始化，可以使用IPC_SET命令来调用semctl系统调用。
In order to initialize the semaphore-set data structure, use the semctl system call with the IPC_SET command.
初始状态：在Win32中，信号可能会有初始值。
Initial state: in Win32, the semaphore might have an initial value.
value(信号量计数器)是这个信号量的初始值。
Value (semaphore count) is the initial value of the semaphore.
可以通过使用semctl将信号量计数器的初始值设置为0来获得信号量。
A semaphore can be owned by setting the initial count of the semaphore to 0 using semctl .
如果多个线程在完成上面的初始调用后尝试锁定信号量，则这些线程会被阻塞，它们的请求进入队列，直到执行pthread _ mutex_unlock调用。
If multiple threads attempt to lock a semaphore after the initial call above, they block and their requests are queued until the pthread_mutex_unlock call is performed.
视图中有为UI的初始位置、幻灯片出现、幻灯片消失定义的信号，还有2个分别为开始和结束卡片编辑而定义的信号。
Your view has signals defined for the initial positioning of the UI, the slide in, slide out sequence, and two for beginning and ending card editing.
它还会对信号量计数器进行初始化：intsem_init(sem_t *sem, intpshared,unsigned intvalue)。
This call also initializes the semaphore count: int sem_init(sem_t *sem, int pshared, unsigned int value). In this code
将数字管脚初始化为输出信号。
其他一些协议也正在开始使用SCTP，例如会话初始化协议(Session Initiation Protocol,SIP)和通用通道信号系统7 (SS7)。
Other protocols are using SCTP, such as the Session Initiation protocol (SIP) and the Common Channel Signaling System No. 7 (SS7).
最后，如果没有外部输入信号，系统的行为完全由自己的初始条件确定，该系统就称为齐次或非强迫系统。
Finally, if there are no external inputs and the system behavior is determined entirely by its initial conditions, the system is said to be homogeneous or unforced.
试验测定振动助流时散体颗粒在初始阶段和稳定流动阶段的振动加速度信号，并对流动场中波的传播规律进行分析。
The vibration acceleration signals at initial stage and steady stage in flowing granular media are tested, and the propagation of wave in the flowing field is analyzed.
基于中国余数定理解频率模糊和解线调方法，提出一种无模糊欠采样的宽带线性调频信号的调频斜率和初始频率的估计算法。
Based on the remainder theorem and direct dechirp operation, an algorithm for estimation of chirp rate and initial frequency of the subsampling wideband LFM signal unambiguously is presented.
根据小波分析理论，针对无源北斗导航定位系统初始校频问题，提出了一种基于小波分析的信号特征提取算法。
According to wavelet analysis theory, a signal picking up algorithm based on wavelet analysis is proposed to solve problem of passive CNS initial frequency calibration.
这种方法对高斯噪声和星座图由于信号初始相位而引入的旋转具有良好的稳健性，并避免了神经网络中的过学习和局部极小点等缺陷。
This method is robust to Gaussian noise and constellation rotation due to initial phase of signal and avoids overfitting and local minimum in neural networks.
在相位激光测距仪中，信号初始相位的相对稳定性对测距仪的测量精度非常重要。
The initial phase relative stability of signal is very important to digital phase range finder.
二相编码波形设计中初始移位寄存器的选择是个关键技术，它直接决定了信号波形在满足最小峰值功率下能否具有最大脉压比。
The selection of the initial shift register of M-sequence is a key technique in pulse compression waveform design whose pulse compression waveform must have low peak power and large compression ratio.
文中详细介绍了软件的初始化方法、模拟和数字rgb信号的处理流程、电源管理方法、红外遥控编码信号接收处理方法等。
In this article the initialization method of the software, the processing flow of analog and digitized RGB signal, the processing method of the encoded infra signal are all introduced, too.
通过检查初始相位特征信号，解决了由相位开关技术产生的初始相位不确定性问题。
The uncertainty problem of the initial phase due to the phase switching technology is solved by checking the characteristic signals of the initial phase.
其次，探讨了一种新的永磁同步电机转子初始位置估算方法——高频电压信号注入法。
Next, it puts forward a new permanent magnetism synchronous machine rotor initial point estimate method - High frequency signals injection method.
在旋转电弧信号的频域分析中，其特征谐波的相位反映了焊缝方向与焊接方向的初始夹角。
In frequency analysis of rotating arc signal, the phase of harmonic characteristic reflects the initial Angle between weld direction and seam's direction.
数控分频器设计：对于一个加法计数器，装载不同的计数初始值时，会有不同频率的溢出输出信号。
Nc divider design: an adder counter, loading the initial count value, have different frequency output signal of the overflow.
最后，利用DSP相关软件，对转子初始位置估算方法进行模拟仿真，验证了高频电压信号注入法理论的正确性。
Finally, the paper simulated to the rotor initial point estimate method using DSP related tool and confirmed the accuracy of high frequency voltage signal method.
模拟二次雷达信号功能、实现飞机的转弯、高度上升下降、速度调配，在授权范围内，初始化或动态调整飞机位置及状态。
Simulation of SSR blips, flight turns, flight level changes, speed adjustments, initialization or dynamic deployment of airplane position and status within authorization.
该方法利用Curvelet多尺度几何分析后信号的稀疏性特点，采用了C - means聚类方法寻求混合矩阵估计值，把该估计值作为算法初始值。
According to signals sparsity by Curvelet transform, the mixed matrix can be estimated with C-means cluster analysis, and the estimated value is looked as initial value of BSS algorithm.
合适的初始脉冲时延和初始脉冲啁啾有利于频域相位共轭技术对交叉相位调制所致信号失真的抑制。
Suitable initial time delay and pulse chirp of pulses can improve the suppression and compensation for the distortion.
首先，利用已知用户数据的初始估计，从接收信号中减去已知用户的影响。
Using interference cancellation of the known users' signal and subspace tracking for unknown users' signal subspace, the orthogonal projection matrix of the unknown users' signal subspace is obtained.
首先，利用已知用户数据的初始估计，从接收信号中减去已知用户的影响。
Using interference cancellation of the known users' signal and subspace tracking for unknown users' signal subspace, the orthogonal projection matrix of the unknown users' signal subspace is obtained.
应用推荐