创建一个混合曲线之间的预测曲线。
创建窗户上曲线与曲线2的看法命令，利用它作为一个参考曲线曲面创建窗口。
Create the Windows upper curve with the curve from 2 views command to use it as a reference curve for Windows surface creation.
创建罩采用曲线曲线2意见和改装，以减少他们的控制点。
Create the hood curves using curve from 2 views and refit them to reduce the control points.
首先，在芯模外侧创建与铺丝路径相对应的特定曲线，然后将曲线按特定方向投影在指定的偏置曲面上，形成初始路径。
First, a specific curve is created around the core module, and then it is projected on to specified surfaces in a particular direction and the projections are taken as initial paths.
为第一条曲线创建起始点、结束点和两个控制点；为第二条曲线创建结束点和两个控制点。
Creates the start, end, and two control points for a first curve and endpoint and two control points for a second curve.
我已经做了数学如何计算控制点的三坐标曲线的定义必须通过，但现在我需要创建该曲线。
I've already done the math to figure out how to calculate the control point as defined by the three coordinates the curve must go through, but now I need to create this curve.
我已经做了数学如何计算控制点的三坐标曲线的定义必须通过，但现在我需要创建该曲线。
I've already done the math to figure out how to calculate the control point as defined by the three coordinates the curve must go through, but now I need to create this curve.
应用推荐