切割电流可调，能适应各种厚度板材的加工。
Cutting current is adjustable to adapt to the various thickness of sheet metal processing.
所以气体流量一定要与切割电流和速度很好的配合。
So the gas flow must with cutting current and speed very good cooperation.
所以在切割前要根据材料的厚度正确选用切割电流和相应的喷嘴。
So in before cutting the thickness of the material according to the correct choice of cutting current and the corresponding nozzle.
当电流一定时，电压的提高意味着电弧焓值的提高和切割能力的提高。
When the current, voltage must be improved means that the improvement of arc enthalpy and cutting capability is improved.
本课题首次从理论与实践上探讨了线切割加工中，电流上升沿斜率对加工能量分配的机理，发现了电流波形影响线切割加工性能的规律。
In this paper the effect of current slop on the distribution of discharge energy in the gap of WEDM is researched for the first time in theory, and some rules are found.
研究了在大气和乳化液两种介质中，峰值电流对高速走丝电火花线切割加工的影响。
The influence of peak current on finishing high-speed wire electrical discharge machining (WEDM) in gas and emulsion dielectric is studied.
本文就小电流空气等离子弧切割工艺的特性、切割质量、切割设备、存在问题和应用情况作了综合介绍。
The article introduces synthetically technological properties, cutting quality and equipment, the present problems and the applied condition for low-current air plasma cutting.
指出了在磁场中做变速切割磁力线（线）运动的导体（不闭合）中有电流存在，讨论了其运动加速度。
The existence of electric current in the conductor(not closed)which is cut-ting the magnetic lines of force(B-lines) variably in the magnetic field is pointed out, and the acceleration is discussed.
通过建立空间电动绳系系统动力学模型，研究了通有电流的导电系绳高速运动切割地球磁力线时系绳的振荡和变形特性。
With its mass and flexibility of an electrodynamic tether system considered, the propulsive motion of the electrodynamic tether system is modeled.
在作大厚度切割时，变频跟踪应适当调慢，最好从零位起调至切割稳定，电流表指针不再激烈晃动。
When advancing large thickness cutting, frequency tracking shall be properly adjusted slow, you'd better adjust it to stable cutting from zero position and ammeter pointer no longer shakes sharply.
通过在快走丝线切割加工机床上进行多次加工实验，本文研究分析了放电电流对线切割加工表面粗糙度的影响规律。
Through the experiments with quickly wire cut of electric discharge machines, this paper analyzes and studied the influence regulation of the discharging current to the surf...
通过在快走丝线切割加工机床上进行多次加工实验，本文研究分析了放电电流对线切割加工表面粗糙度的影响规律。
Through the experiments with quickly wire cut of electric discharge machines, this paper analyzes and studied the influence regulation of the discharging current to the surf...
应用推荐