该方法无毒,凝胶速度快,凝胶温度低,保持被包埋微生物的活性,同时提高了凝胶的稳定性和降低了使用成本。
The method has such advantages as no toxicity, rapid gelation and low gelation temperature. The gel has such advantages as retained bioactivity of embedded microorganisms, and improved stability.
当外部温度提高时,凝胶成分开始分解而且变得不那么粘性,创造了一个溶胶可以流动并且加快细胞移动速度的新途径。
When the external temperature rises, the gel component starts to break down and become less viscous, creating new pathways through which the sol can flow and speeding up the cell's movement.
研究了单体浓度、引发剂浓度、反应时间和反应温度对接枝聚合物接枝率、凝胶率等的影响。
The influences of concentration of BPO, concentration of monomer, reaction time, reaction temperature were investigated in terms of grafting degree and gel content.
目的探讨各因素对他克莫司温度敏感眼用凝胶体外释放的影响。
Objective to study the factors that influence the release of tacrolimus from the thermosensitive ophthalmic gel.
随着单体溶液浓度、固化反应温度、引发剂和催化剂加入量的提高,凝胶固化反应速率快速增长。
The rate of solidification process increases with the concentration of the monomer solution, gelation temperature and the amount of the initiator and catalyst.
不熔凝胶与周围树脂有同样的熔点,但是受热温度比平均温度低。
Unmelted gels have the same melting point as the surrounding resin, but remained colder than the average melt temperature.
在固化工艺方面,研究了固化剂含量和固化温度对于凝胶时间的影响。
As for curing process, the influence of dosage of curing agent and curing temperature on gel time was investigated.
提高凝固温度,可以缩短凝固时间,并可显著增加豆腐凝胶的强度。
Coagulation time could be decreased by increasing coagulation temperature and tofu gel strength increased remarkably.
用水基凝胶注法制备出ysz固体电解质薄膜,研究了温度、湿度和坯体厚度对干燥过程的影响规律。
YSZ solid electrolyte film was prepared by aqueous gel casting. The influences of temperature, relative humidity and sample thickness on drying process were studied.
结果表明:采用凝胶注入法可有效降低煤矿温度,减缓煤氧反应,降低爆炸危险。
It shows that infuse gel can reduce coal well temperature, coal and oxygen reaction and explosive fatalness greatly.
研究了3233环氧树脂体系的粘度-温度关系、凝胶时间-温度关系、热力学性能、垂直燃烧性能和力学性能。
The relations of viscosity vs. temperature and gel time vs. temperature of 3233 epoxy resin system are studied.
结果表明:随保温温度的升高,交联体系凝胶含量、陶瓷产率逐渐增大。
Experimental results show that the increase of preservation temperature could elevate the gel content and ceramic yield.
方法:采用梯度PCR对醛固酮合酶基因(CYP11B2)进行扩增,通过凝胶呈像技术判断CYP11 B2基因最佳退火温度。
Methods: Gradient PCR was employed in analysis of aldosterone synthase (CYP11B2) gene polymorphisms, and gel Imaging Technology was used to determine the optimal annealing temperature.
试验结果表明:制备炭质凝胶的转化率与反应物配比、反应温度、反应时间及沥青原料性质有关。
The experiment results indicated that the carbon conversion from asphalt to gel was directly related to the reactant ratio, reaction temperature and time, and asphalt properties.
温度梯度凝胶电泳(TGGE)是一种用于检测核酸序列变异和点突变的电泳方法。
Temperature gradient gel electrophoresis (TGGE) is a new and powerful electrophoresis method for separation of nucleic acids (DNA and RNA) and analysis of sequence variations.
分别研究了有机粘土对树脂体系粘度、凝胶特性、力学性能和热变形温度、耐湿热性能等的影响。
The effect of organic rectorite on the viscosity, gel-time, heat deformation temperature, mechanical properties and wet-heat resistant property were researched.
研究了PVB本体浓度、制膜间隙、凝胶浴温度以及乙酸添加剂等因素对PVB不对称超滤膜性能的影响;
Effects of concentration of PVB, clearance of scraper, temperature of gelling bath and concentration of acetic acid additive on membrane performance were investigated.
凝胶化剂量随辐照温度的升高而降低。
The dose of gelation is decreased with the increasing of temperature.
环氧树脂与改性液体酸酐体系的凝胶时间与环氧树脂的结构与组成、固化温度及促进剂等因素有关;
The gelation time of this epoxy resin with modified liquid anhydride was related to the chemical structure and the composition of epoxy resin, curing temperature and accelerator.
本品是高韧性的延长凝胶,环境温度或手部温度的变化而使光疗甲上的颜色随着变化。
It is a high toughness gel, the color will change as the temperature changing in environmental.
文章研究了影响抗起毛起球效果的因素,同时还对降低凝胶焙烘温度的方法进行了筛选和研究。
In this paper, it researched the influential factors about pilling-resistance and methods for decreasing the gelling temperature.
用氨基酸分析、热分析以及溶解法分析了丝素蛋白与环氧化合物(PGDE)在不同反应温度下形成的凝胶的微观结构。
The microstructures of gels prepared by reaction between silk fibroin and epoxide (PGDE) at different reaction temperature were studied by amino acid analysis, DSC analysis and dissolution methods.
采用共聚合的方法,确可提高凝胶的相变温度。
RESULTS LCSTs of gels were increased by the method of copolymerization.
提高凝固温度,可以缩短凝固时间,并可显著增加豆腐凝胶的强度。
With increasing coagulation temperature, coagulation time could be decreased and tofu-gel strength increased remarkably.
研究发现,溶剂体系、反应温度、凝胶清洗用剂及洗滤次数等对所得的粉体粒度有较大的影响。
The results show that solvent system, reacting temperature, washing agent and washing-leaching times can influence the perticle size of HAP powder.
升高温度凝胶的脱水速率明显加快。
The dehydration rate increases obviously with increasing of the temperature.
经不同工艺和过程制备二氧化硅气凝胶,初步摸索出制备温度、溶剂、催化剂、反应时间最佳参数。
The factors that influence silica aerogel preparations were investigated, and the optimum values were obtained for preparing temperature, solvent, catalyst and process duration.
溶胶-凝胶过程是是一种用金属烷氧化物或金属无机盐在较低温度的条件下制备金属氧化物的方法。
The sol-gel process is a method to prepare metal oxide by using alkoxy metal salt or metal inorganic salt.
溶胶-凝胶过程是是一种用金属烷氧化物或金属无机盐在较低温度的条件下制备金属氧化物的方法。
The sol-gel process is a method to prepare metal oxide by using alkoxy metal salt or metal inorganic salt.
应用推荐