峰值间的距离随厚度的减薄而增大。
The distance between peaks increases as the thickness is reduced.
局部减薄弯头与直管的极限载荷不同。
The limit load of local thinning elbow is different from the straight pipe.
在该断裂带存在着轴部重力高与地壳减薄。
Higher gravity values and thinner crust can be found at the axial localities of the fault zone.
同时，表面氧化层减薄，脱落情况明显减少。
At the same time, the oxide scale thins out and flaking condition reduces evidently.
多金属成矿作用与岩石圈伸展减薄及地壳拉张的关系。
The relationship between polymetallic mineralization and lithospheric thinning and crustal extension.
同向切应力具有减薄液膜厚度和增大传热系数的作用；
The cocurrent shear plays the roles on thinning film thickness and enhancing heat transfer, and the countercurrent shear has inverse effect.
本发明可为单个工件的减薄而提供或用于减薄成批的工件。
The present invention provides for single workpiece thinning or thinning a batch of workpieces.
减薄硅膜厚度和增加铝膜的厚度也能增大泵腔体积变化量。
The stroke volume of the chamber is enlarged when the thickness of aluminum membrane is increased or that of silicon membrane is decreased.
在综合分析基础上建立了胶东地区岩石圈减薄的动力学模式。
The dynamic model of lithosphere thinning in Jiaodong area is set up on the base of comprehensive analysis.
提出了考虑裂解管蠕变损伤和减薄损伤的剩余寿命预测方法。
A residual life predication method of cracking tube is proposed taking account of the creep damage and the thinning damage of the tube.
文中研究了油管局部缺陷和壁厚减薄缺陷的漏磁场检测原理。
Based on the magnetic leakage flux technique, the principle of localized defect inspection and wall thickness measurement in oil well tubing has been researched.
高压锅炉过热器在运行中受到飞灰、吹灰磨损，导致管壁减薄。
Abraded by flying ash and blowing ash, the tube wall of low temperature superheater of HP boiler was thinned during operation.
所述较厚边沿或箍向否则会脆弱的减薄半导体工件给予了强度。
The thick rim or hoop imparts strength to the otherwise fragile, thinned semiconductor workpiece.
伸展条件下的地壳拆离作用是岩石圈减薄的重要浅部构造响应。
Extensional crustal detachment is the most important tectonic response of lithosphere thinning.
在离子减薄制备的电镜样品中，孔的边缘往往有一些无颗粒区。
Some small grain free regions (GFR) near the hole in the transmission electron microscopic specimen of this material prepared by ion milling was observed.
板料厚度大，不易起皱，但壁厚减薄率大，因而成形精度不高。
The thick blank is difficulty wrinkled, but the blank thinning is larger and result in a low forming precision.
通过对芯片进行背面减薄和倒装连接，可以实现有源芯片的埋嵌。
The embedded active chip also can be realized by backside thinning and flip chip bonding.
采用减薄硅片衬底厚度和光陷阱技术可望使转换效率达到29%。
It is possible to get 29% efficiency by reducing wafer thickness and employing light trapping technology.
减薄镀锡板的镀锡层和合金层的厚度成为目前镀锡板生产的趋势。
It is an inevitable tendency to reduce the thickness of tin coating and alloy layer of tinplate.
发现表面高密度缺陷减薄了势垒层厚度，显著增强了热电子隧穿过程。
It is found that the barrier width is thinned by the surface defects with high density to enhance the hot electron tunneling.
现今盆地的演化可能处于第二次伸展减薄—热事件的同裂谷相的晚期。
Currently the evolvement of the basin is probably in late syn-rift phase of the second event.
钎焊过渡层和减薄陶瓷块厚度可降低钎焊复合挺柱中陶瓷块的残余应力。
Residue stress in the ceramic chip of the composite tappet rod may be reduced by intermediate layer of soldered connection and by decreasing thickness of ceramic chip.
介绍了近年来不同学者从各个方面研究中国东部岩石圈减薄所取得的进展。
Some advances of many scholars studying on lithosphere thinning in eastern China in recent years are reported.
理论计算结果与实验结果对比表明，所得减薄率选取范围具有较强的实用性。
The experiment results, show that the range of reduction ratio is very practicable.
热轧是控制无取向硅钢成品横截面厚差偏大、尤其是边部减薄显著的关键工序。
Hot rolling is the key factor for controlling transverse thickness difference, especially edge drop, of non - oriented silicon steel.
计算结果表明：在转臂上施加一定的反向弯矩，能有效减小弯管的壁厚减薄率。
It shows that pipe bending by using induction heating applied a counter torque can efficiently reduce the thinning ratio of pipe wall thickness.
实验结果表明，随着小粒径锌粉的增多，涂层减薄，铬含量提高，耐蚀性增强。
The experimental results showed that the smaller the powder size and higher the chromium content were, the higher corrosion resistance the coating could be.
为克服现有的透射电镜试样双喷电解减薄仪的缺点，自制了双喷电解减薄装置。
A home-made twin-jet electropolishing device for preparing transmission electron microscope(TEM)samples is reported.
对焦炭塔上部壳体和球形封头的减薄原因进行了简要分析，提出了临时修复措施。
The reason of thinning out of the upper shell and spherical head for coke tower was analyzed briefly. The temporary repair measure was proposed.
对焦炭塔上部壳体和球形封头的减薄原因进行了简要分析，提出了临时修复措施。
The reason of thinning out of the upper shell and spherical head for coke tower was analyzed briefly. The temporary repair measure was proposed.
应用推荐