设计了一种用于测定低熔点二元合金步冷曲线的试样容器。
The sample cell used to measure the gradual cooling curve of two components alloy with low melting points was designed.
利用步冷曲线法测定了不同浓度的甲醇、乙二醇水溶液的冰点。
The curve law of step is used to determine the freezing points of methyl alcohol and glycol aqueous solution with different density.
可显示样品温度曲线、隔板温度曲线、冷阱温度曲线、真空度曲线。
Sample temperature curve can be displayed, a separator temperature curve, thetemperature curve of the cold trap, vacuum curve.
在DSC曲线中淬火样品有冷结晶峰,而其它样品没有。
There is a cold crystallization peak for the quenching sample in heating DSC curve, and there is not for the others.
该模型根据示范点各大楼的冷、电负荷预测延时变化曲线,按照经济最优原则制定微型燃气轮机的发电计划。
The results show that the generation curves of micro turbine made by this optimal model can satisfy the operation economy and primary energy ratio index requirements of this project.
提出采用多条柱子曲线以适应不同截面、不同壁厚、不同强度的高强度冷弯薄壁型钢柱。
It is suggested that several column curves should be adopted for the calculation of cold-formed steel columns of different sections, thicknesses and strengths.
同时给出准光学谐振腔高频系统的模拟计算和冷测实验的典型曲线。
The typical curve of quasi optical cavity simulation and cool testing experiment are also given.
测量断面的平均计数、噪声、冷区对比度及剖面曲线。
The mean counts, noise, contrast and profile curves of the slices were measured.
模拟钢轨焊接及焊后热处理工况,采用热膨胀方法分别测定uic 900a及u75 V钢轨钢的连续冷转变曲线(CCT曲线)。
By simulating welding and simulating heat treatment after welding, CCT Curves of UIC900A and U75V rail steels are determined by the expansion method.
油冷器各层芯片流量分配曲线大致呈S形分布,而换热量分配曲线呈浴盆状分布。
The oil flow rate distribution curve mainly has an "S" shape, and the heat transfer rate shows a "bathtub" distribution.
通过分析半钢冷锭加热裂纹产生原因,以及对半钢冷锭加热速度进行理论计算,制订了切实可行的加热工艺曲线。
Analyzing the reasons of semi-steel cold ingots crack occurred in heating and theoretically calculating heating speeds of semi-steel cold ingots, a practical curve of heating process is worked out.
说明:特性曲线是在冷态,三相负载下测得。
Note: The characteristic curves are obtained in the cold state and 3-pole loading.
其他较有影响力的方法有参比温度曲线法和蓄冷材料测试方法。
Other influential methods include T-history method and a self-designed method for cool storage.
简介了一种利用冷弯管组拼方法形成管道曲线段的技术。
This paper introduces a kind of technology using built up and connection method to make the pipeline bending curve of the cold bending tubes.
同时对步冷试验温度曲线进行修正,提出了修正步冷试验温度曲线。
In the mean time, temperature curve for step cooling was modified and a modified temperature curve for step cooling was first proposed in this paper.
特性曲线Characteristic curve特性曲线是在冷态,三相负载下测得。
The characteristic curves are obtained in the cold state and 3-pole loading.
变形使CCT曲线向左上方移动,提高了奥氏体冷却转变开始温度,随冷速加大提高得越多。
The deformation moves CCT curve to left and up direction. the cooling transformation initiating temperature of austenite increases more with the increase of cooling rate.
双冷结晶峰现象在一些非反应性溶剂处理过的PET试样的DSC曲线也观察到。
Duplex cold crystal peak was also observed in the DSC of PET by vapour of unactive…
最后,对传统的理想冷却曲线及低温区的冷速问题提出了一些新的看法。
Finally, some new viewpoints with respect to the conventional ideal cooling curve and cooling velocity below the martensitic transformatio…
最后,对传统的理想冷却曲线及低温区的冷速问题提出了一些新的看法。
Finally, some new viewpoints with respect to the conventional ideal cooling curve and cooling velocity below the martensitic t...
在简要分析原辊型配置应用情况的基础上,提出了对四机架冷连轧机支撑辊型配置(包括辊型曲线和辊型凸度)综合优化的方案。
This paper simply analyses the work of the exisiting backup rolls, and brings forward a project to optimize the backup rolls on 4 stand tandem cold strip mill.
在简要分析原辊型配置应用情况的基础上,提出了对四机架冷连轧机支撑辊型配置(包括辊型曲线和辊型凸度)综合优化的方案。
This paper simply analyses the work of the exisiting backup rolls, and brings forward a project to optimize the backup rolls on 4 stand tandem cold strip mill.
应用推荐