在冷却段半焦经水冷排出。
砖渣经冷却段冷却后排除，可用于生产水泥。
Brick slag is removed after being cooled in the cooling section and is used for the cement production.
根据线径的不同，随便调节冷却段水位。达到冷却的目的。
According to the different wire diameter, literally adjust cooling section water level, to achieve the purpose of cooling.
将退火带钢在冷却段冷却到指定温度，经密封通道进入锌锅。
The annealed strip is cooled to the temperature required by galvanizing process in the cooling zone and then goes into zinc pot through sealed channel.
铜线退火后发红：连续退火分三个段：预热段，工作段、冷却段。
After annealing copper red: continuous annealing three sections: preheating section, the work piece, cooling section.
由普通薄板连铸装置的冷却段及结晶器两侧外加恒定磁场，磁场强度为0.3 ~1特斯拉。
In a common continuous sheet casting apparatus, constant magnetic field of 0.3-1 tesla strength is applied to the cooling section and the crystallizing section.
本文提出了热管换热器加热段和冷却段的三种长度比：流通长度比、经济长度比和许用安全长度比。
Three kinds of length ratio of evaporator to condenser of heat pipe heat exchangers are proposed: the flow length ratio, the saving length ratio, and the allowable safety length ratio.
对充气热管空气预热器的结构进行分析和应用介绍，采用平界面模型，确定充气热管冷却段的有效长度。
By using a flat interface model it is possible to determine the effective length of a gas-filled heat pipe cooling section.
铜线变色(暗红或发白)：连续退火在工作段把线烧软，还要经过冷却段冷却后才能达到引出线不烫、不带水。
Copper wire color (dark red or white) : continuous annealing in the work period of the line burn soft and pass cooling section after cooling can achieve lead not hot, without water.
冷却段将控制布置在精轧机与地下卷曲机之间输出辊道上下间的水阀，通过调整这些阀的水量来控制冷却温度和冷却速率。
The control valves arranged over and under the run out tables located between the finishing mill and the down coiler can be controlled through the cool...
如果新鲜面包在烘烤后迅速冷却，则可以保存一段时间后再食用。
Fresh bread can be kept for later use if it is cooled quickly after it is baked.
间隔锻炼，就是你拼命跑一段时间，然后冷却一段时间，这是一个好的推进速度方法，没有逼迫整个过程。
Interval training, where you run hard for a period of time and then cool down for another interval, is a good way to push the pace without pushing it for the entire run.
等蟹冷却一段时间后就可以吃了。
温度在很长一段时间内保持在零还要求业主必须检查冷却液液位是正常的，如果发现冷却液水平低于线下，应及时补充道。
Temperature in a very long period of time to maintain the owner must check the coolant level is normal, if you find that the level of the cooling fluid is below the line, should be added in time.
汽车经一段时间运行后，进行一次发动机冷却系统清洗是十分必要的。
The car after a period of time after the operation, the cleaning time of engine cooling system is very necessary.
退火工艺的组成为把钢加热到一定温度并保持一段时间，通常再缓慢冷却。
The process of annealing consists of heating the steel to an elevated temperature for a definite period of time and, usually, cooling it slowly.
每一段情感的冷却，等于百次的燃烧。
依据二冷均匀冷却的思想，重新设计并优化了二冷喷淋结构和喷嘴的布置，增加了一个二冷喷淋段。
According to the idea of uniform cooling in secondary cooling zone, the spraying cooling structure and the disposal of nozzles are redesigned and optimized, and one spraying cooling zone is increased.
从1号发电机淡水冷却出口到涡轮机进口这一段淡水冷却管损坏，需换新。
No. 1 main generator engine fresh water cooling outlet to turbine inlet damaged, to be renewed.
停堆初期（第一阶段）的冷却过程：通过蒸汽发生器将反应堆冷却剂系统的能量传输给二次侧的蒸汽。
The initial phase of reactor cooldown is accomplished by transferring heat from the reactor coolant system to the steam and power conversion system through the steam generator.
冷段再循环给堆芯提供长期的冷却，热段再循环用于交替地给堆芯提供反向流。
Cold leg recirculation mode will provide long term cooling for the core and hot leg recirculation mode will be used alternately provide reverse flow to the core.
并从试验中发现了液膜蒸干后气膜段冷却的一些特点。
With it, some characteristics of the gas film cooling after liquid film vaporized-out point have been revealed.
退火。退火工艺的组成为把钢加热到一定温度并保持一段时间，通常再缓慢冷却。退火是为了产生均匀化从而建立起有一致的特有性质的标准均匀化组织。
Tool steel is generally purchased in the annealed condition. Sometimes it is necessary to rework a tool that has been hardened, and the tool must then be annealed. For.
采用的固定床绝热反应器和多段反应、段间冷却的工艺是可行的。
It is also feasible to adopt the adiabatic fixed-bed reactor and the techniques of multistage reactions and interstage cooling.
在失水事故长期冷却过程中，必须确定安全注射系统从冷段注射切换到冷热段同时注射的切换时间。
It is necessary to determine switchover time to simultaneous cold and hot leg safety injection during LOCA long-term core cooling.
而分路冷却只会对加速段和同轴负载耦合处的腔体略有影响。
The two-way cooling structure only brings little effects to joint cavities of accelerating tube and collinear load.
主要通过非正线实体工程试验段块石护坡层内热量传递过程监测，对块石护坡结构冷却路基的作用机理进行研究。
The cooling mechanism of crushed rock revetment of embankment was studied by monitoring the heat transfer in crushed rock layers of revetment at the experimental sections.
连接完毕，必须双手紧握管材和管件，保持足够的冷却时间，冷却到一定程度后手方可松开，继续安装下一段管材。
Join, must both hands hold pipes and pipe fittings tight, keep enough cooling time, cool back hand can unclamp to certain extent, continue and install the next pipe.
冷却工位段采用强制风冷结构，确保玻璃达到二次印刷连线的工艺要求。
On the part of cooling, it adopts coerce wind cooling, makes sure the glass can arrive to the second time printing demand.
冷却工位段采用强制风冷结构，确保玻璃达到二次印刷连线的工艺要求。
On the part of cooling, it adopts coerce wind cooling, makes sure the glass can arrive to the second time printing demand.
应用推荐