检查冷却效率。
噪音水平的因素是电源也将大大减少由于更好的冷却效率。
The noise level of the power supply will also significantly decrease due to better cooling efficiency.
冷冻水冷器各传热管冷却水量分布不均匀使其冷却效率普遍很低。
Cooling water is not distributed well in each heat transfer tubes which makes the operation efficiency of vertical water coolers low.
利用数值计算的方法研究了非定常尾迹对动叶气膜冷却效率的影响。
Numerical calculations were performed to investigate the effects of unsteady wakes on film cooling.
通过分析多孔材料骨架温度的变化趋势，研究了影响发汗冷却效率的因素。
The factors that influence the effectiveness of transpiration cooling were also discussed.
冷却效率随吹风比的增加而增大，且沿气流方向冷却效率存在一极大值；
The efficiency of film cooling will be increased with the increase in blow ratio, and it has a highest value in the direction of flow.
因此，能够改善冷却效率、使用稳定性、清洁便利性、美感和产品可靠性。
Therefore, cooling efficiency, stability in using, convenience in cleaning, esthetic feeling, and reliability of a product can be improved.
微星提供了9厘米超大风扇自己设计的R5850气旋达到更高的冷却效率。
MSI provides own design R5850 Cyclone with 9cm extra large fan to reach higher cooling efficiency.
现场调试运行结果表明，该套装置具有体积小、安全可靠、冷却效率高等特点。
Debugging and running on spot show that this set has the properties of small volume, safety and reliability, powerful cooling efficiency.
对比再生冷却分析了不同注入率对壁面温度、冷却效率以及边界层厚度的影响；
The influences of porosity on the local blowing ratio, wall temperature and boundary layer thickness were compared with the effects with regenerative cooling.
大容量水泵，水冷机油冷却器和双圆环型散热器风扇确保最佳发动机的冷却效率。
Large-capacity water pump, liquid-cooled oil cooler and twin ring-type radiator fans ensure optimal engine cooling efficiency.
MDI的高功率衰减器结合最大的冷却效率，同时拥有优良的频率和准确的特点。
MDI's high power attenuators combine maximum cooling efficiency, along with excellent frequency and accuracy characteristics.
计算得到了冷却效率云图、冷却效率径向平均值以及近壁面处流场和温度场分布。
The film cooling effectiveness contour, laterally averaged film cooling effectiveness, and the flow and temperature distributions near the surface have been obtained.
主流雷诺数对冷却效率的影响不大，但总体上仍表现出雷诺数越大，冷却效率越高。
The Reynolds number of the main flow has a relatively small effect on cooling effectiveness, but the cooling effectiveness still increases with increasing Reynolds number as a whole.
在内燃机的生产过程中，气缸盖铸造水芯的冷却效率对于发动机的热应力分析至关重要。
In the process of diesel engine manufacturing, the cooling efficiency of the casting core of cylinder head is critical to the thermal stress analysis.
与圆形孔相比，位于喉部上游位置收敛缝形孔既具有好的冷却效率又具有低的损失系数。
Compared with cylindrical holes, the converging slot holes at the upstream of the throat exhibit both higher cooling effectiveness and lower aerodynamic loss coefficient.
本实用新型通过塔状溅水盘的多次溅水，避免了中空现象，喷洒均匀，提高了冷却塔的冷却效率。
The utility model avoids a hollow phenomenon, uniformly sprays and enhances the cooling efficiency of a cooling tower through the multiple water spray of the tower-shaped water spraying disc.
冷却水的流动与传热直接影响柴油机的冷却效率、高温零件的热负荷、整机的热量分配和能量利用。
Cooling-water flow and heat transfer directly influences the cooling efficiency of diesel engine, thermal load of high temperature components, heat distribution of engine and energy utilization.
采用放大的半圆柱状表面模拟涡轮叶片前缘的形状，对叶片前缘单排及两排圆柱形孔的气膜冷却效率进行了测量。
Film cooling effectiveness of hole rows on leading edge of turbine blade has been studied experimentally. The model is a blunt body with a half cylinder leading edge with two flat side walls.
该工艺具有提高冷却塔的抽风能力，提高冷却塔冷却效率，降低污染物排放浓度，降低工程造价和运行费用等优点。
It has the advantages of improving both the draft inducing capacity and cooling efficiency of the cooling tower and reducing the emission concentration and manufacturing and operation cost.
使用 90% ，或比较高的氧集中而不是空气将会产生达到重量仰赖瓦斯流程和冷却效率的 13%新鲜的空气。
Using 90% or higher oxygen concentrations instead of air will generate up to 13% ozone by weight depending on gas flows and cooling efficiency.
与机械通风式凉水塔的冷却效果比较表明，该凉水塔具有冷却效率高、运行成本低、操作简单等优点，值得推广应用。
The results show that this kind of hydraulic spray type is worthy to be spread, with advantages of high efficiency, low cost, easy operation, and so on.
研究结果表明，在本文研究的参数范围内，离散孔切向进气气膜冷却的冷却效率随吹风比和气膜孔直径的增大而上升；
The results show that, for the present investigation conditions, the film cooling effectiveness will be increased with the increase of blowing ratios and the diameter of film hole;
燃烧室迷宫复合冷却结构是一种集冲击、对流换热和近似发散冷却于一身，结构合理，冷却效率高，具有创新性的新型冷却结构。
A combustors maze composite cooling structure is an innovative and highly efficient cooling structure that integrates impingement, convection heat exchange and approximate perspection cooling.
为了探讨在不同径向角下动量比和湍流度对圆柱形气膜孔流动和换热的影响规律，采用数值模拟方法，研究了涡轮叶片的冷却效率。
The cooling effectiveness of cylindrical gas-film cooling holes was numerically investigated, which was determined at different radial angles, momentum ratio and turbulent intensity.
研究了基于叶片弦长的主流雷诺数和二次流-主流流量比对冷却效率的影响，并与叶片上圆柱形孔排的气膜冷却效率分布进行了对比。
The influences of re based on the blade chord length and coolant-gas flux ratio are tested, and comparison is made between the effect of the converging-expanding hole rows and cylindrical hole rows.
近些年来，市场上的数据中心公共设施管理(DCIM)，冷却，电力和其他承诺增加效率的产品增加了。
Offers for data center infrastructure management (DCIM), cooling, power and other products promising efficiency gains have been increasing in the market in recent years.
氮化镓技术提供更高的可靠性和效率，从而降低功耗总量，放宽冷却要求。
GaN technology provides increased reliability and efficiency, resulting in lower prime power consumption and relaxed cooling requirements.
人脑其实与电脑一样，处于低温冷却状态时工作效率最佳，工作负担过重就会导致过热，出现过热就会降低其信息处理能力。
Like a computer the brain works best when it is cool, but putting too great a strain on it can lead to overheating which reduces its ability to process information.
IBM发现使用水来冷却处理器的效率是使用空气冷却的4000倍。
IBM found that using water to cool off a computer's processors is 4,000 times more efficient than using air.
应用推荐