下面是系统中运行时参数的典型值。
Here are some typical values of the runtime parameters on a system.
这是金属的典型值。
这些技术指标是典型值,不作保证。
上述数据为实验典型值,真实可靠。
注:以上数据为实验典型值,真实可靠。
Note: The data above are all experiment typical values, true and reliable.
因此,action属性的典型值是OBSERVE。
Therefore, the typical value for the action attribute is OBSERVE.
这些性质是典型值,但不构成技术指标。;
These properties are typical values but do not constitute specifications.
以上产品特性数据为测试典型值,仅供参考。
All the data listed are typical values for your reference only.
我们取发射极基极电阻的典型值为250欧姆左右。
We shall take the typical emitter-to-base resistance as about 250 ohms.
典型值是指实验室平均数据,仅用于使用时的参考,不作为产品的标准。
The typical values are average data of laboratory and only for reference. The data can not be used for standard of production.
请仅在属于存储过程的查询子集中使用非典型值或临时值时使用此选项。
Use this option when atypical or temporary values are used in only a subset of queries belonging to the stored procedure.
典型值是指实验室平均数据,仅用于使用时的参考,不作为产品的标准。
Typical values are the averaged data from laboratory. They are for reference only and not the standards for products.
典型值是指实验室平均数据,仅用于使用时的参考,不作为产品的标准。
Typical values are the averaged data from laboratory, it is for reference only and it is not the standards for products.
注:以上数据为实验典型值,真实可靠。本数据仅供参考,不作为正式质保承诺。
Note: the data above are all experiment typical values, true and reliable. But they serve only for reference not for quality guarantee.
由于我们不能用所有可能的输入值运行用例,所以我们必须只局限于系统用户所建议的典型值。
Since we cannot run the use cases with all possible input values, we must restrict ourselves to the typical values as advised by the users of the system.
有多少次是根据典型值设计好电路后却发现只是因为使用的器件不典型而不能工作呢?
How many times has a circuit been designed using typical values, only to find that the circuit does not work because the device used is not typical?
如果非典型值或临时值仅用于属于存储过程的查询子集,则使用RECOMPILE查询提示。
Use the RECOMPILE query hint when atypical or temporary values are used in only a subset of queries that belong to the stored procedure.
图中所示的电流源典型值为50paDC,其幅值会发生几个数量级的变化,其极性亦可正可负。
While the typical value of the current source is shown as 50pa DC, this can vary by several orders of magnitude. Its polarity can also be positive or negative.
其他功能还包括28纳秒(典型值),快速的上升和下降时间很短的传播延迟,以及电源轨欠压锁定。
Other features include a short propagation delay of 28 ns (typical), fast rise and fall times, and supply rail under-voltage lockout.
在50伏特直流电供电情况下,其最小增益为9.0dB,而最低集电极效率为40%(>45%的典型值)。
It is designed to have a minimum gain of 9.0 dB with 40 percent minimum collector efficiency (>45 percent typical) on a 50VDC supply.
文中在校准应用研究中采用田口方法,根据数字信号源的频率、调幅及调频试验典型值推导出全量程校准公式。
The Taguchi method is studied to derive calibration formulae of frequency and amplitude modulation of digital signal generator in whole range in this paper.
如图2 - 9所示,由于保护缓冲放大器具有典型值为104到106的开环增益,所以能够大大减少CSHUNT的充电时间。
As shown in Figure 2-9, the guard buffer significantly reduces the charging time of CSHUNT because of the open-loop gain (AGUARD), which is typically 104 to 106.
二极管1n3595是完成此功能的很好的选择对象,因为其漏电流很低,即使在正向偏置电压为1mV时,漏电流典型值也小于1pa。
The 1n3595 diode is a good choice for this function because it has low leakage current, typically less than 1pa, even with a forward bias of 1mv.
该属性的一个典型值是com . sun . jndi . cosnaming .CNCtxFactory,这也是我们在这里的几个例子中所使用的值。
A typical value for this property, which we'll be using for these examples, would be com.sun.jndi.cosnaming.
该属性的一个典型值是com . sun . jndi . cosnaming .CNCtxFactory,这也是我们在这里的几个例子中所使用的值。
A typical value for this property, which we'll be using for these examples, would be com.sun.jndi.cosnaming.
应用推荐