把它放在窗边，如果你发现充电速度变慢，还可以通过旋转这些光电板来获得更大的能量输出。
Leave it by your window and you can rotate them to try and get more output if you find something charging slow.
光扭矩传感器的输出信号在进行光电转换过程中，由于温度影响，造成了直流电平漂移误差，影响系统的测量精度。
During the photoelectric conversion process of output signal from optical torque sensor, DC level drift error induced by temperature influence will affect the measuring accuracy of the system.
可以设计成各种形式，利用集成型结构，可获得更高的输出电压和光电转换效率。
Can be designed into various form, the use of an integrated structure, can obtain higher output voltage and photoelectric conversion efficiency.
并利用电逻辑处理技术和光的全反射原理研制了具有电逻辑处理输出的光电浓度仪。
Based on this technique and the principle of total reflection of light, a photoelectric instrument with electric process output is developed.
该系统采用光电编码器作为速度检测传感器，控制方式采用PID数字控制，控制输出采用PWM数字信号至驱动电路对电机调速。
This system USES photoelectric coder as speed detecting sensor, USES PID digital controller as control method, USES PWM signal as control output to regulate speed.
事件的响应输出取决于光电倍增管对于事件发生位置的光收集效率和事件的能量。
The response output depends on the light collecting efficiency in the position where the event happens and the energy of light quantum.
半导体激光器在受到如光反馈、光注入、光电反馈等扰动下，可得到混沌输出。
A semiconductor laser, when subjected to perturbation such as optical feedback, optical injection, optoelectronic feedback, can display chaotic output.
数字图像质量的评价涉及到图像的信息量问题，但在光电匹配滤波相关识别中，输入目标图像的信息量大小并不是相关输出优劣的决定因素。
The digital image quality evaluation involves the information capacity of image, but the magnitude of information capacity of input target image cant determine the quality in the correlation output.
双色(中短波)同步工作模式的红外探测器，其输出光电流信号为中波信号和中短波混合信号。
The output signals of two-color (MWIR and SWIR) infrared detectors with simultaneous mode are MW current signal and MW-SW current signal.
针对火灾探测过程中的光电探测器输出的微弱信号设计了一个微变信号提取放大电路。
A new circuit has been designed and developed for picking up and amplifying the weak signals of a photoelectric detector in fire detecting system.
只要控制接收器中超辐射的光电转换电平，就能控制打开Q开关时的反转粒子数，也就能稳定输出的巨脉冲激光。
So we can control the population which can trigger the Q-switch by controlling the superradiant convert electrical level in the superradiant detector and then the laser output can be stabilized.
它具有结构简单紧凑、输出功率高、稳定可靠、光电转换效率高、光束质量好等优点。
The double-clad fiber laser has the advantages of simple structure and high reliability, high output power, high conversion efficiency, high beam quality.
提出了装备用一次性化学电池动态输出特性的光电耦合测量法。
This paper advances an optoElectronic coupling measurement method of single - use chemical cells dynamic exportation features used by a type of equipment.
积分装置利用光电池的脉冲输出来确定旋转的总量。
Integrating devices use the photo cell pulse output to determine total amount of turning.
所述控制系统与所述至少一个光电传感器和所述光源两者都可操作地关联，以根据从所述至少一个光电传感器接收的测量值来调节所述光源的光输出。
The control system is operably associated with both the photosensor and the light source, to regulate the light source's light output in accordance with measurements received from the photosensor.
阐述了光电式速度传感器获取光电信号，跟踪滤波输出的随机窄带基波信号、波形预处理及应用。
To obtain photoelectric signal of the photoelectric speed sensor, tracking to filtering narrow band random base-wave which is output, voltage wave beforehand transaction and application are expounded.
光电流放大10倍后再去积分、输出，使器件灵敏度大大提高。
The amplified photocurrent (about 10 times) can increase the sensitivity of the image sensor very much.
指出基于最大相关原理（光电探测器输出信号极值判断法）的匹配解调只适用于两个光纤光栅具有相同的反射谱型。
The wavelength-matched demodulation based on maximum correlation, extremum judgment of photodetector output signal, are only available for alike reflective spectra.
指出基于最大相关原理（光电探测器输出信号极值判断法）的匹配解调只适用于两个光纤光栅具有相同的反射谱型。
The wavelength-matched demodulation based on maximum correlation extremum judgment of photodetector output signal are only available for alike reflective spectra.
设计了一种有效的浑浊度光电检测电路，实现了浑浊度的数字输出。
A practical photoelectric circuit for measuring turbidity is designed in the article, and the digital output of turbidity is realized.
在硬件抗干扰方面，本课题采用光电隔离的方法成功的对输入光电编码器的信号进行了整形，并隔离了输出负载对电路的影响。
In hardware aspect, this paper use optical-electric insulation method stronger the signal of optical-electric encoder and insulate the infection of out load for main circuit successfully.
通过对多路并行输出的高帧速自扫描光电二极管面阵(SSPA)的研究，分析了影响面阵帧速和响应度的主要因素。
By Studying the high frame rate self-scanning photodiode area array (SSPA) with parallel video output, the main factors which affect the frame rate and response of SSPA are analysed.
光电增量式轴角编码器的输出信号由于其编码原理而在慢速或停止时易受轴抖动影响。
Owing to the encoding principle, the outputs of the Photo incremental Rotary Encoder suffer from disorder when its shaft vibrates, especially when rotating slowly or halting.
本文介绍了锑化铟磁阻型光电传感器的结构及工作原理，并对锑化铟磁阻型光电传感器的输出特性进行了研究。
The paper introduce the configuration and theory of the InSb magnetoresistance IR-Photoelectrie sensor, and study the output characteristic of the sensor.
为了在变化的输入光电平上保持输出信号电平恒定，用于检测光接收机的输出功率电平的设备和方法。
An apparatus and method for detecting an output power level of an optical receiver, in order to hold output signal levels constant over changing input optical levels.
根据光电位置敏感器件的原理及特征方程，分析了存在背景光时它的输出信号是非线性的。
Based on the PSD analyses, it is found that the signal of PSD is nonlinear when there exist background light.
利用可变频脉冲发生器、光电耦合器和F/V转换器组成输出通道，设定阀值；
The threshold voltage is set by output channel comprised of pulse generator, photoelectric coupler and F/V converter, and the detection result is input through photoelectric coupler.
火灾探测系统常常因为光电探测器输出信号的微弱而不能工作。文中介绍了为此设计的一个微变信号检测电路。
A new circuit has been designed and developed for picking up and amplifying the weak signals from a photoelectric detector in fire detecting system.
火灾探测系统常常因为光电探测器输出信号的微弱而不能工作。文中介绍了为此设计的一个微变信号检测电路。
A new circuit has been designed and developed for picking up and amplifying the weak signals from a photoelectric detector in fire detecting system.
应用推荐