详细介绍了光发送、光接收电路和单片机与微机的串行通信控制接口。
Transmitting and receiving circuits and serial communication and control interface between PC and microcontroller are described in detail.
宽带光接收组件中前端电路的低噪声设计在整个光通信系统的研制中具有重要地位。
The minimum noise design of the wideband optical receiving module plays an important role in the full optical communication system.
本论文给出了时钟恢复电路的基本原理以及采用PLL型时钟恢复电路的完整的电路设计、模拟结果和版图设计，以及将时钟恢复电路集成到光接收机后的测试结果。
The thesis presents basic principle of CRC and rounded circuit design, simulation results, layout design and testing results of a PLL type CRC, which is incorporated in a optic-fiber receiver chip.
给出了在小色散和大色散光纤通信系统中近似实现光接收机最佳传递函数的电路型式；
The circuit types approaching the realization of the optimal transfer function of the receiver in low- and high-dispersion digital fiber-optic communication systems are given.
根据光接收机前端等效电路模型，建立了噪声系数与等效输入噪声电流谱密度的关系。
Based on the equivalent circuit model of a two-port optical receiver front-end, the relationship between the equivalent input noise current spectral density and the noise figure is analyzed.
光接收机前端放大电路主要由两个关键电路构成：前置放大器和主放大器。
The front-end amplifier for optical receiver is made up of two important circuits: preamplifier and main amplifier.
一控制电路，它根据光发射接收器的信号控制水泵。
The control circuit controls the pump according to the signal of the light emission receiver.
论文设计了光源发射驱动、光信号接收、信号调理及数据采集等硬件电路，以获得计算血氧饱和度所需的信号。
Light sources launch driven, light signal reception, signal conditioning, and data acquisition system were designed, and signals for calculating oxygen saturation were acquired by these circuits.
在用于光纤传输系统的几个功能电路中，构成光接收机前端放大电路的前置放大器和主放大器是两个关键电路。
In the building blocks of an optical transmission system, the pre-amplifier and the main amplifier are the critical parts.
在用于光纤传输系统的几个功能电路中，构成光接收机前端放大电路的前置放大器和主放大器是两个关键电路。
In the building blocks of an optical transmission system, the pre-amplifier and the main amplifier are the critical parts.
应用推荐