这样充、放电很快但却存不了多少电。
It is quick to charge and discharge, but cannot hold much energy.
正是锂离子进入和脱离电极的速度决定了电池充、放电的速度。
It is the speed with which the ions can enter and leave the electrodes that governs how fast a battery can be charged and discharged.
另外，还有一种方法可以使流体电池重新充电：将释放电量的电解质溶液抽空，然后重新充入溶液。
There is, though, another way to recharge a flow battery: pump out the discharged electrolyte and replace it with a solution that has been recharged elsewhere.
德国阳光蓄电池应避免长期搁置不用，也不能长期浮充而不放电。
German battery should avoid sun lay up for a long time, can't long-term floating without discharge.
具有过充及过放电自我保护性能。
电池不可与其他类型的一次或二次电池混用，否则会因为不正常充、放电造成电池发热、冒烟、变形或燃烧。
This battery cannot be used in combination with other types of primary or secondary batteries, or the abnormal charge or discharge will make batteries overheat, smoke, deform or burn.
本文提出中性锌—锰电池可充性电解液的配方特点，并阐述了将其用于湿电池和干电池的充放电情况。
In this paper the authors described the characteristics of the rechargeable electrolyte of neutral Mn-Zn battery and its application in dry and wet battery charge and discharge.
在使用BREAK - IN模式前先给电池放电是可以的。在BREAK - IN模式下对电池过充不会对电池造成伤害，因为充电电流非常小。
Discharging prior to BREAK-IN mode is optional. Overcharging during the BREAK-IN mode does not harm battery as the charging current is very slow.
在这类放电中，等离子体的密度由限制器和壁的出气量决定，而和初始充的氢气压强完全无关。
In such discharges, the plasma density was determined entirely by the outgassing of the limiter and-wall, and independent of the initial hydrogen pressure pA totally.
设计出用于阵列MPPT的DC／DC电路和具有蓄电池分组充、放电电路。
A charging (discharging) circuit for storage battery and a DC/DC circuit for MPPT of array are designed.
循环伏安曲线出现明显的氧化还原峰，并分别与充、放电电位平台相对应。
Cyclic voltammetry curve showed obvious oxidation and deoxidization peaks, corresponding to the flats of charge and discharge.
应用双极性脉冲传输信号。避免了因远距离电缆充、放电带来的波形畸变。
Application of bipolar pulse in transmitting signal can avoid distorted wave caused by charge or discharge in a long cable.
给出了对阵列MPPT控制、蓄电池容量预测及充、放电控制等功能及控制策略的实现程序设计。
A program is designed, which can accomplish the strategy for array's MPPT control, the storage batteries' capacity prediction, the storage batteries' charging and discharging control.
阐述了镍-氢电池的工作原理，充、放电特性和性能指标；以及镍-氢电池的特点及应用现状。
The operational principle of the nickel-hydrogen battery and its charging and discharging characteristics and performance index is described here as well as its application status.
具备完善的过充、过放电保护功能。
运用恒电流充、放电实验和粉末微电极循环伏安实验来检测上述试样的充、放电性能。
The charging-discharging performances of these samples were examined with galvanostatic charging-discharging experiments and powder microelectrode cyclic voltammetry experiments.
在这类放电中，等离子体的密度由限制器和壁的出气量决定，而和初始充的氢气压强完全无关。
In such discharges, the plasma density was determined entirely by the outgassing of the limiter and wall, and independent of the initial hydrogen pressure p0 totally.
实验结果表明，掺杂不同离子的炭电极具有充、放电的不可逆性，其充、放电容量也有明显的差别。
The result of investigation shows that the electrode derived from different ion doped into polystyrene resin has a visible difference in the reversibility and capacity of the charge and discharge.
针对锂离子蓄电池在充放电过程中容易出现的过充、过放、过流、过温问题，设计了基于软硬件保护的锂离子蓄电池保护电路。
According to the problems in charging and discharging process of lithium-ion battery, a kind of protection circuit based on software and hardware was designed.
电池剩余电量估计系统不仅能够防止电池过放电或过充，而且对于电动汽车行使过程中起到了汽车汽油表的重要作用。
SOC system can not only avoid the overcharge or overdischarge of battery, but also play as a important role as auto gas instrument.
提出了料仓刚刚灌充时或者接近灌满时，电场的起伏变化，可能是诱发危害性静电放电的原因之一。
It is raised that, at the beginning of the filling operation or when it is nearly fully filled, the undulating change of the field should be one of the reasons which may cause incentive ESD.
磁体电压、磁体电流及直流母线电流仿真与实验波形吻合较好，所应用的斩波器数学模型及其控制方法能实现对超导磁体快速稳定地充、放电和续流。
The experimental and simulative waveforms of magnet current and DC bus current inosculate well, which indicates the validity of the proposed mathematical model of chopper and its control method.
磁体电压、磁体电流及直流母线电流仿真与实验波形吻合较好，所应用的斩波器数学模型及其控制方法能实现对超导磁体快速稳定地充、放电和续流。
The experimental and simulative waveforms of magnet current and DC bus current inosculate well, which indicates the validity of the proposed mathematical model of chopper and its control method.
应用推荐