且静偏应力的影响随着静偏应力的增大而显著。
And its effect increased with the increasing of static deviator stress.
由此对通常认为比较抽象的偏应力张量不变量的意义与作用有更深层次的理解。
So, a deeper understanding of the significance and the role of the invariants of the stress deviator which are considered more abstractly has been given.
以往的研究大多忽略初始偏应力对软黏土循环软化及动应力-应变关系的影响。
Unfortunately, previous work rarely incorporated the effect of initial deviator stress on cyclic degradation behavior and dynamic stress-strain relationship of soft clay.
纵向偏应力总是削弱反常内耗效应,而切向偏应力因施加方向的不同引起不同的内耗效应。
The longitudinal bias stress may always weaken the anomalous amplitude-dependent effect, while the torsional one may induce different effects from different directions applied.
当破坏标准选定时,界限累积耗损能量与平均应力、偏应力比及动应力间较好的回归关系。
When the failure criterion is decided, the limit accumulate energy dissipation can be fitted by a formula which includes the average stress, deviator stress ratio and cyclic axial stress.
在相同偏应力条件下,不排水常规三轴压缩蠕变的应变值要小于减压三轴压缩蠕变的应变值;
The value of strain of undrained conventional triaxial compression creep is less than that of reduced triaxial compression creep under the same deviator stress;
研究结果显示重复荷载下之偏应力愈大则回弹模量愈小,且回弹模量随基质吸力的增加而增加。
Experimental results showed that the resilient modulus of unsaturated cohesive subgrade soils reduced with the increase of deviator stress and the decrease of matric suction.
应变路径理论与传统的增量理论不同之处在于其偏应力增量和偏应变增量之间为一非线性关系。
The strain path theory is different from the plastic flow theory since it gives a nonlinear relation between stress deviation increment and strain deviation increment.
利用自行改装后的三轴蠕变仪对海相沉积的营口软土进行蠕变试验,获得了在不同围压、不同偏应力条件下的剪切应变与时间关系数据。
The relationship between shear strain and time of Yingkou soft soil is obtained under a series of different cell pressures and different deviator stresses.
在上海地区典型饱和软粘土不排水循环三轴试验的基础上,分析了影响软粘土塑性累积变形的主要因素:循环荷载的作用次数,初始静偏应力和循环加载动偏应力。
It was shown that the cumulative plastic strain depended not only on the applied cyclic stress and number of cycles, but also on the initial static deviatoric stress level.
稳定蠕变应变率本构方程是作用在盐岩上的应力偏量的幂次函数和能量与温度的指数函数。
The steady-state creep strain rate is a power function of deviatoric stress and exponential function of temperature and energy.
稳定蠕变应变率本构方程是作用在盐岩上的应力偏量的幂次函数和能量与温度的指数函数。
The steady state creep strain rate is a power function of deviatoric stress and exponential function of temperature and energy.
实现了不同尺寸规格缓冲底垫的胶带自动粘贴功能,并很好地解决了胶带跑偏、胶带应力大、粘贴不牢等问题。
This design can solve the problems happened during pasting, such as tape deviation, too high stress of tape, poor pasting and so on.
结果表明:夹杂物局部偏聚是铜管断裂的内在原因。焊接时产生的热应力及弯曲变形是铜管断裂的外部诱发因素。
The results show that the aggregation of contaminant is the inner cause of Copper pipe crack, while the thermal stress formed during welding and winding deformation is another two important factors.
通过对某小学活动馆的预应力管桩基础在施工过程中出现的桩头偏位的情况进行分析与处理,取得了较好的实用效果并得到了一些有益的经验。
Pre-stressed pipe pile foundation is used in the gymnasium of certain primary school, in which some pile-heads of them are deviated during the course of constructing.
与此同时,存在由于热应力产生的微裂纹和稀土元素偏聚烧损后产生的孔洞。
The thermal stress and the burning loss of rare earth elements segregate at grain boundaries resulting in the presence of micro-cracks and micro-holes.
在应力偏张量主值三角函数解的基础上,推导了应力空间内主应力和主方向的通用解析解公式。
Based on the stress partial tensor's trigonometric function answer, the main stress and main direction are established in parsed currency formula, and some special answers and examples are discussed.
采用能量差率方法,首次导出含偏轴裂纹三维有限大体应力强度因子封闭解。
An energy difference rate method (EDRM) is applied to establish a closed form solution (CFS) about stress intensity factor (SIF) of three dimensional finite bodies containing inclined embedded cracks.
电光系数随温度变化及应力双折射引入的最大退偏损耗分别为2.38%和4.04%。
The largest depolarized loss induced by variation of electro-optic coefficient and stress birefringence is correspondingly 2.38%, 4.04%.
数值模拟显示:电光系数随温度变化和应力双折射是引起开关退偏损耗的主要因素。
The simulated results indicate: variation of electro-optic coefficient as well as stress birefringence is the main factor, which induces depolarized loss of the switch.
结合工程实例分析了预应力管桩产生偏位的原因,介绍了预应力管桩偏位的处理方法。
Based on an engineering example, the reason of sloping prestressed pipe piles (PPPs) and the treatment method for the sloping PPPs are given.
通过实验可以发现板条中部均匀的热应力分布能够有效抑制退偏效应,而板条边缘部分存在一定的退偏现象;
The stress introduced by the mechanical operation must be paid attention to. (4) LD edge-pumped slab module is developed, with the test experiments on the thermal effects and the depolarization.
通过实验可以发现板条中部均匀的热应力分布能够有效抑制退偏效应,而板条边缘部分存在一定的退偏现象;
The stress introduced by the mechanical operation must be paid attention to. (4) LD edge-pumped slab module is developed, with the test experiments on the thermal effects and the depolarization.
应用推荐