反应共混物熔体呈假塑性流体特征。
The melt of blends exhibits the characteristics of pseudoplastic fluid.
该涂料为带有屈服值的假塑性流体。
结果表明，共混物熔体为假塑性流体。
The results showed the blend melts were pseudoplastic fluids.
提出了一个新的假塑性流体的本构方程。
A new constitutive equation of pseudoplastic fluids are presented.
木钠涂料的流体类型为屈服假塑性流体。
The fluid type of sodium lignosulphonate coating is yielding pseudoplastic fluid.
泡沫凝胶体系属于假塑性流体且粘弹性好。
Foam gel system is a pseudoplastic fluid and its viscoelasticity is good.
流变性能研究表明，两种熔体均为假塑性流体。
The two compatibilized systems are pseudo-plastic fluids through rheological character study.
并且接枝产物的流变性能与PP一样为假塑性流体。
The rheological property of grafted products and PP was still a kind of non-Newtonian pseudoplastic fluid.
结果表明，该体系的流动符合假塑性流体的流动规律。
The results proved that the flowability of the system obeyed the law of pseudoplastic fluid.
实验结果表明，复合胶原溶胀液具有假塑性流体的特性。
The experimental results show that the composite collagen dispersion behaves pseudo-plastic fluid.
结果表明：料浆均表现出剪切变稀行为，且为假塑性流体。
Results show that shear thinning behaviour and pseudoplasticity of aqueous slurries can be found.
辽河油田含水超稠油的流变指数均小于1，它属于假塑性流体。
Flow behavior index of watery super-heavy oil of Liaohe oilfield is all less than 1, so it is quasi-plastic fluid.
流变学研究表明，两种类型冰淇淋混料均属于屈服—假塑性流体。
The theological studies indicated that the mixes of the two types ice cream both belonged to yield pseudoplastic fluid.
本文研究假塑性流体在搅拌槽内的给热系数与搅拌功率之间的关系。
This paper studies the relation between heat transfer coefficients and power consumption, of pseudoplastic fluids in agitated vessels.
结果表明，该区含气原油为假塑性流体，地层条件下非线性渗流显著；
The result shows that live crude in this area is pseudoplastic fluid, nonlinear seepage flow is remarkable at the formation conditions;
豆渣水溶性膳食纤维溶液粘度随剪切速率的增加而降低，呈现假塑性流体。
The solution of SDF from soybean dregs were pseudoplastic fluid which viscosity decreased with the increasing of shear rate.
文中用带屈服应力的假塑性流体描述驱替液性质，用宾汉流体描述原油性质。
The displacing fluid of power law fluid with yield stress and displaced fluid of Bingham are used to illustrate these effects.
研究结果表明：蜡质玉米淀粉糊具有假塑性流体的特征，属“剪切变稀”体系。
The experimental results obtained revealed that waxy maize starch paste with pseudoplastic characteristics could be considered as a shear-thinning system.
当物系为中等粘度假塑性流体时，混合速率由桨叶泵送流动的流量和形态所决定；
Change in viscosity of test fluids alters principally pumping flow of impeller and therefore influences bulk mixing.
浆材胶凝体系流变性能的研究显示，此体系属于假塑性流体，具有剪切稀化的性质。
Rheology study reveals that the cementitious system of the grout is pseudoplastic fluid with shear-thinning property.
结果表明，凉粉草胶溶液在不同的条件下呈牛顿流体或假塑性流体行为，在剪切速率52。
It was suggested that MBG looked like a Newtonian fluid or a pseudo-plastic fluid under different conditions, and under the shear rate of 52.
在所研究的剪切应力、剪切速率及温度范围内，两者均属于假塑性流体，呈现剪切变稀行为。
The results show that HDPE/MMT nano-composite and HDPE belong to pseudoplastic fluid and present, shear thinning behaviors within the range of shear stress, shear rate and temperature.
结果表明：涂料中加入0.2%黄原胶后，可使涂料流型变为具有一定屈服值的假塑性流体。
With addition of 0. 2 % xanthan gum into the EPC coating, the rheological behavior of the coating is similar to pseudoplastic fluid with certain yield value.
假单胞菌多糖溶液流变学性质研究发现，该多糖溶液具有自身增粘性和触变性，属于假塑性流体。
Rheology research found that the exopolysaccharide had self-viscosity-improvement and thixotropy, so the exopolysaccharide solution was a pseudoplastic liquid.
结果表明，浆体为屈服假塑性流体并具有触变性，屈服应力值和粘度随着温度升高、浓度的降低而减小。
The ZGG solution behaved as pseudoplastic fluids-the decrease in reduced viscosity with increasing shearing-velocity, and had considerably thixotropic response.
表观粘度测定显示辛烯基琥珀酸淀粉酯具有剪切变稀现象，属于假塑性流体，表观黏度随着温度升高而下降。
The phenomenon of increasing shear force, and decreasing apparent viscosity, showed that it was a kind of Pseudo plastic Fluid. As the temperature increased, the apparent viscosity decreased.
介绍了幂律方程、埃利斯方程和米特方程，分析了这些方程的基本特点。提出了一个新的假塑性流体的本构方程。
The Power law equation, the Bills equation and Meter equation are introduced, and basic features are discussed. A new constitutive equation of pseudoplastic fluids are presented.
文中采用S IMPL ER方法，以苯乙烯-聚苯乙烯物系为例，对高粘假塑性流体管内传热进行了仿真计算。
In this article, we adopt SIMPLER method, take styrene-polystyrene as an example and make a simulating calculation of heat transfer of a high viscosity pseudo - plastic fluid in the tube.
文中采用S IMPL ER方法，以苯乙烯-聚苯乙烯物系为例，对高粘假塑性流体管内传热进行了仿真计算。
In this article, we adopt SIMPLER method, take styrene-polystyrene as an example and make a simulating calculation of heat transfer of a high viscosity pseudo - plastic fluid in the tube.
应用推荐