• CPU负荷增长尽管(写)事务没有日志个数没有变日志文件同步往返信号传输时间延长。

    When the CPU load goes up, the time taken for a log file sync round trip can increase even when the number of log file syncs and the volume of redo log generated doesn't change.

    youdao

  • AGC控制单元送出信号控制发电机组,按标准频率联络线负荷要求增大和减少负荷。 收藏。

    The AGC unit sends signals to the generating units under its control to raise or lower load as required to correct frequency and tie-line loadings.

    youdao

  • 结论心脏息时(尤其负荷时)出现钙是钙信号一种调节机制

    CONCLUSION: in the heart, waves of calcium release (especially in highly loaded with calcium) are a normal mechanism of cellular signaling.

    youdao

  • 自动闭塞电力贯通线路铁路沿线自动闭塞信号及车站负荷提供电源。

    Railway automatic blocking and continuous transmission lines (RABCL) supply power for the railway automatic blocking signal and the loads along the lines, etc.

    youdao

  • ECM接收到带有IVS的油门踏板传来的代表负载命令可变电压信号然后这个位置命令其转换成一个负荷百分比命令。

    The ECM receives its load command from a variable voltage signal through a foot pedal sensor with IVS. It then translates this position command into a load percentage command.

    youdao

  • 另外快速傅立叶变换适用分析平稳渐变信号,不能适应负荷动态变化的电力谐波检测

    In addition, FFT is applicable to analyze gradually-changed signals instead of detecting harmonics when the load breaks.

    youdao

  • 铁路信号自控系统一级供电负荷要求有两质量供电电源

    The railway signal auto-control system is a level of power supply load, which requires two lines of high quality power supply.

    youdao

  • 目前流行负荷调节系统中引入蒸汽流量信号弊病

    The author discusses incidentally the drawbacks of thermal load controls fed with steam flow rate signal that could cause trouble.

    youdao

  • 终结器就是置于电缆终端一个电阻负荷,用来防止数据信号反射回到线路中去。

    A resistive load placed at the end of a cable to prevent data signals from reflecting back into the data path.

    youdao

  • 而且,通过三维温度场所获得辐射能建立辐射能信号机组负荷之间能量平衡新的协调控制模型提高机组负荷控制水平。

    A new coordinated control model based on the energy balance between the value of radiative energy signal and the unit load is established, to improve the unit load control.

    youdao

  • 材料力学应变测量实验试件在负荷作用下所产生应变信号十分微弱

    In the strain-data measured experiments of material of mechanics, the bar generates weak strain signal by the less force functioning on the bar.

    youdao

  • 本文介绍了多个传感器共同实现对一个负荷进行测试信号采集方法数据处理方法。

    This paper introduces the methods of gathering the signal and data processing when a force is measured by multiple load cells.

    youdao

  • 研究前馈控制适用性选择不同信号模拟负荷变化,对比前馈控制不同干扰形式调节效果。

    For the study, the choice of applicability feed-forward control of different load simulation signal and contrast of different forms of feed-forward control regulation of interference.

    youdao

  • 方法以电网电压同步信号,在电网电压信号过零点采样直流侧电容电压,通过周期离散控制可以获得负荷电流有功分量

    The new control way can realize linear control for DC-bus voltage and get the fundamental component of the load current synchronously with a little of calculation.

    youdao

  • 结论压力负荷随着ROS升高激活ASK1可能心脏肥大信号传导途径发挥重要作用

    Conclusion Under chronic pressure overload, the activated ASK1 with the increasing ROS may play an important role in signal transduction pathway of myocardial hypertrophy.

    youdao

  • 方法14名受试者分别参加肱二头腰部脊竖肌等长运动负荷实验,取表面肌信号进行FF T功率及其功率谱地形图分析

    Methods Static isometric loading of the biceps and low back muscle was performed in 14 subjects, using FFT power spectrum and its two dimensional mapping to analyze SEMG signals from these muscles.

    youdao

  • 本文讨论柴油机转速信号反馈控制进油量,负荷信号控制进气量问题

    This article discusses the problem of regulating oil inflow by feeding back the revolutions of the diesel engine and of controlling air inflow with loading signals.

    youdao

  • 文章介绍基于机组负荷指令协调控制方法以及成功使用经验动态加速信号

    The paper briefs the unit's load command based coordinated control method as well as the dynamic acceleration signal with successful using experience;

    youdao

  • 首先信息函数最小选择优小基,然后其对燃气负荷进行二层分解得到负荷低频信号高频信号

    Firstly, the best wavelet basis selection was conducted via message entropy function; then the gas load was decomposed to low frequency signal and high frequency signal by two times through it.

    youdao

  • 检测机械工具工具磨损(负荷)破损(负荷)、停机信号维护增加安全性

    Detects tool wear (high load) or breakage (low load) in machine tools and shutdown or signals maintenance for added safety.

    youdao

  • 通过这些处理运动估计过程中复杂图像运算转化维投影信号进行处理,有效的降低计算负荷

    Those processing translate the 2D image calculation of motion estimation into 1D signal computation to reduce the computational complexity of motion estimation.

    youdao

  • 目的为进行飞船人工控制系统作业工作负荷工效研究研制一个肌电信号采集分析软件

    Objective a software used for acquiring and analyzing signals was developed for ergonomical research on Human Workload in space manual system.

    youdao

  • 采用近似理论分析得出随着运动负荷增加腓肠肌比目鱼的肌信号的近似熵值随负荷增加而增大。

    Compared with gastrocnemius and soleus muscle, gastrocnemius muscle acoustic signal 'approximate entropy increases faster, but soleus muscle acoustic signal' approximate entropy increase more gently.

    youdao

  • 采用近似理论分析得出随着运动负荷增加腓肠肌比目鱼的肌信号的近似熵值随负荷增加而增大。

    Compared with gastrocnemius and soleus muscle, gastrocnemius muscle acoustic signal 'approximate entropy increases faster, but soleus muscle acoustic signal' approximate entropy increase more gently.

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定