其输出信号可用数字电压表，信号调节器，或动态应变仪接示波器记录。
Its output signal can be displayed by digital voltmeter, signal conditioner or dynamic strain amplifier with recorder.
这些信号调节器为需要单个点，孤立的热电偶信号调节的应用，提供了理想的低成本解决方案。
These signal conditioners provide a low cost solution ideal for applications where single point, isolated thermocouple signal conditioning is required.
接着，还重点介绍了信号调理单元、位置调节器的功能和硬件电路实现。
Meanwhile, the paper focuses on the function and the hardware implement of the signal modulation unit and the position regulator.
调节器必须在没有输入信号的空闲条件下进行。
Adjustments have to be done at an idling condition with no signal input.
为了能更好地满足要求，本文设计的电压调节器可以根据控制信号的不同产生不同的输出电压。
To meet the requirements best, the regulator designed can output different voltages according to the different control signals.
使用1位内部ADC，图1中内部转换调节器采集输入信号，产生粗量化的输出作为输入信号。
Using a 1-bit internal ADC, the internal converter modulator in Figure 1 samples the input signal, producing a coarse, quantized output.
在配置闭环极点的同时，对调节器的高频增益加以限制，以减弱控制信号的高频振荡。
The high frequency gain of the regulator is limited to suppress the high frequency oscillation of the control signal while assigning the closed-loop poles.
然后根据交流侧和直流侧的功率平衡方程，推导了电压环的小信号模型。最后基于该模型设计了一种高动态性能的直流电压调节器。
Subsequently, a novel controller for DC bus voltage regulation is put forward according to the small signal model based on the instantaneous power balance in AC and DC sides of three-phase SAPF.
针对串联型交流电压调节器，提出了一种新的基波正序计算方法以获取补偿电压的参考信号。
A series ac voltage regulator based on a new fundamental positive sequence calculation method, which is utilized to generate the compensation voltage reference, is introduced in this paper.
三台航空静止变流器模块均为电压、电流双环控制，通过公用电压调节器稳定并联系统的输出电压及频率，同时产生统一的模块电流给定信号。
Each module is controlled by voltage current two closed loops. The common voltage loop controls system output voltage & frequency, and generates a common reference current signal.
每台航空静止变流器模块均为电压、电流双环控制，通过公用电压调节器稳定并联系统的输出电压及频率，同时产生统一的模块电流给定信号。
Each module is controlled by voltage-current two closed-loops. The common voltage loop controls system output voltage & frequency, and generates a common reference current signal.
文中讨论了采用数字信号处理器(dsp)作为控制核心时PF C主电路参数的选择，并详细讨论了两种数字PID调节器参数的确定方法。
How to choice parameters of PFC main circuit using DSP as control center is described, what is more, two methods to select parameters of PID adjuster are also discussed.
工程师们需要创造理想的和最差的信号，以得到精确且具有深度洞察力的设备和设计，如：半导体电路、传感器和调节器。
Engineers need to create ideal and worst-case signals to get accurate and accelerated insight into devices and designs such as semiconductor circuits, sensors or modulators.
一种电热调节器能把温度转化为连续的电信号。
由氧化锆探头测出烟道气中的氧含量，经氧量变送器输出电信号，用调节器进行PI运算，再转换成压力信号。
The values, of oxygen content in the flue gas measured by a ZrO2 sensor are sent out as electric signals by a transmitter, They are converted into pressure signals via PI regulator.
以给定转速和实际转速作为输入信号，给定电磁转矩作为输出信号，设计了ADRC速度调节器，提高系统的抗干扰能力。
The ADRC speed regulator is designed with the given speed and real speed as inputs and the given electromagnetic torque as output to improve the anti-interference ability of system.
以给定转速和实际转速作为输入信号，给定电磁转矩作为输出信号，设计了ADRC速度调节器，提高系统的抗干扰能力。
The ADRC speed regulator is designed with the given speed and real speed as inputs and the given electromagnetic torque as output to improve the anti-interference ability of system.
应用推荐