介绍了一种适宜水声接收用的高性能通用信号调理器的设计思路。
This paper introduces a design of high-performance general signal conditioner suitable for acoustic signal receiving.
系统的硬件平台主要由数据采集卡和霍尔电压电流传感器构成的信号调理器组成。
The hardware is made up of Data Acquisition card (DAQ) and signal conditioning extension for instrumentation (SCXI) which is composed of Hall voltage current sensor.
随后，本文还简要介绍了信号调理器、保护屏蔽接地与电源、计算机接口、信号处理等。
Then it came the signal debug device, protecting shield and power source, computer connection, signal process.
同时我们还可以为客户提供全面可靠的信号隔离器、信号调理器、信号变送器等整体解决方案。
Simultaneously we may also provide comprehensive reliable whole solution archives and so on signal disconnector, signal recuperation, signal transmitting instrument for the customer.
这些设计方案分别基于运算放大器、仪表放大器以及集成一体化的传感器信号调理器等集成电路，分别满足不同档次的产品要求。
These solutions respectively base on ICs of Op Amp, instrumental Amp and full-integrated sensor signal conditioner, meet different-level products requirements.
设计出传感器输入输出信号调理电路和试验台架液压激振系统、磁流变阻尼器控制器的功率放大电路。
Design the signal adjust circuit for sensor, and the power amplification circuit for the hydraulic pressure system of test platform and the controller of magnetorheological dampers.
接着，还重点介绍了信号调理单元、位置调节器的功能和硬件电路实现。
Meanwhile, the paper focuses on the function and the hardware implement of the signal modulation unit and the position regulator.
这种将传感器输出转换成电压信号，并与系统的其它电路相连接的过程，称为信号调理。
This process of converting the transducer output into a voltage signal which can be connected to the rest of the system is called signal conditioning.
所设计的电路简单、新颖、实用。可广泛用于模拟电子电路，特别是传感器的信号调理电路中。
The designed circuit is simple and novel and practical, and it can be used (extensively) in (analogue) circuits, special in signal condition circuits of sensor.
其硬件部分主要由六个模块组成：信号调理模块、时间校对模块、存储器模块、网络控制模块、WDT模块和电源管理模块。
The hardware mainly comprises six modules: signal procession module, time adjusting module, memorizer module, network control module, WDT module and power management module.
系统由8051单片机、16位模数转换器MAX1177、存储器、信号调理电路和串口电路等构成。
The system is composed of 8051MCU, 16bits A/D MAX1177, memory, signal condition circuit and serial interface.
硬件部分包括各传感器信号调理电路模块以及由AD 574a, 89c 52,8255 A等构成的主板模块。
Its hardware interface includes sensor signal condition circuits and the motherboard constructed by AD574A, 89c52, 8255a, etc.
调理电路将磁电式传感器产生的齿轮旋转逐齿信号调为矩形脉冲。
Pulse signal of gear wheel rotating generated by magnetoelectricity sensor was adjusted into rectangular pulse by adjusting circuit.
基于力矩电机的姿态传感器由倾角测量装置、信号调理板及封装外壳组成。
The gesture sensor based on moment motor consists of inclination measure equipment, signal regulation board and encapsulation shell.
介绍了小电容量的电容传感器信号调理的一种新方法。
A new method of sensing signal conditioning for small capacitance transducer is introduced.
重量传感器输出的信号经信号调理电路输入6024E的模拟通道，经计算机分析处理；
The signal output from the weight sensor is transmitted to one of the analog channels of PCI-6024E board by conditioning circuit.
该传感器将集成大量霍尔元件技术和进行信号调理的仪表电路整合在一起，从而使与硅霍尔元件特性相关的温度漂移降到最小。
The sensor combines integrated bulk hall cell technology and instrumentation circuitry to minimize temperature related drifts associated with silicon hall cell characteristics.
本文针对该传感器进行了特性测试，并通过实验研究确定了喷油泵内齿条与传感器位置的物理零点，最后对传感器的信号调理电路进行了设计。
So it is the key to choice the sensor. The characteristics of sensor is tested. This paper adjusts the physical zero point between rack and sensor. The circuit of signal adjusting is design.
该数据采集系统采用TI公司的TMS320 LF 2407 A芯片为主控制器，另外设计了相应的外围信号调理电路、存储模块、通信模块等。
The data acquisition system adopted TMS320LF2407A chip of ti as main controller, in addition, designed peripheral signal processing circuit, memory module, communication module and so on.
采样端固定在旋转构件上，将传感器输出信号进行信号调理和模数转换，并利用无线数字传输技术将数据发送到接收端；
The sampling part, which is fixed in a revolving component, processes and digitalizes signals from sensors and sends out the data by wireless transmission technology.
系统硬件包括压力传感器平板阵、信号调理电路、信号采集板以及计算机系统。
The hardware of this system includes pressure transducer board array, signal modulation circuit, signal capture board and PC.
根据霍尔传感器的特性和MAX14 5 7的工作原理，提出将MAX14 5 7应用于霍尔传感器信号调理的方案。
Base on characteristic of Hall sensor and work principle of MAX1457, the plan of appalling MAX1457 to signal condition circuit of Hall sensor is given.
PGA309作为数字化可编程信号调理芯片，主要用于电阻桥式压力传感器，将微弱的传感器桥路信号进行放大输出。
As a digital programmable chip of signal conditioning chip, PGA309 is mainly used in resistance bridge pressure sensors, it amplifies and outputs the weak signal from the sensor.
该系统由水泵试验台、传感器、信号调理电路、数据采集卡、计算机处理几个部分组成。
This system consists of: pump test bed, sensors, signal processing circuit, data-collecting card, computer processing.
传感器信号调理是对传感器直接输出的信号进行调节，信号调理的原理以及硬件实现电路在文中都做了说明。
Sensor signal adjustment is used to adjust the direct output signal of sensors. The principle of signal adjustment and the hardware circuit implementation are both discussed in this paper.
介绍了本课题中采用的电子鼻硬件系统的三个组成部分――传感器阵列、信号调理电路和数据采集卡。
Then the three key parts of electronic nose: sensors array, signal amplification circuit and AD board are also introduced.
介绍ad698型线性位移差分变压器(LVDT)专用信号调理电路，应用ad698可简化电路的设计。
Signal conditioning circuit AD698 for Linear Variable Differential Transformer (LVDT) is introduced, and the application of this circuit can greatly simplify the circuit design.
DAQ式虚拟仪器自动测试系统是由传感器、信号调理、数据采集硬件、通用计算机、软件等基本要素构成。
And this system is composed of some essential elements such as sensor, signal-modulating circuit, hardware of DAQ, general computer, relative software and so on.
为将接收二极管上的微弱信号送到A／D转换器处理，采用锁定放大原理设计接收信号的调理电路。
We use the principle of lock - in amplifier to amplify the weak singal and send it to A/ D conversion properly.
本设计完成的网络测试系统主要由传感器、信号调理、数据采集、网络接口、显示以及通用计算机硬件和软件等基本要素组成。
This network testing system is mainly made up of basic elements such as sensors, data acquisitions, network interface, display, universal computer software and hardware, etc.
应用推荐