在计算中，还得到激励信号的电平。
In the calculation, a level of the excitation signal is also obtained.
涉及到大量的压缩直接关系到输入信号的电平是很重要的。
It is important to note that the amount of compression is directly related to the level of the input signal.
在一些实施例中，所述电平位移电路包括锁存经转换的输出信号的电平位移锁存器(208)。
In some embodiments, the level shifting circuit includes a level shifting latch (208) that latches a translated output signal.
无杂散动态范围被定义为用dB表示的，接收机噪声和两个相等杂散信号的电平的差，这两个杂散信号的互调产物与接收机噪声相等。
It is defined as the difference in dB between receiver noise and the level of two equal spurious signals whose intermodulation products are equal to the receiver noise.
现在的信号电平增加了三到五倍，病人也说，光纤化学传感刷比传统的纤维终端要舒服得多。
Signal levels increase three - to five-fold, and patients report that the brush optrode is considerably more comfortable than the conventional fiber ends.
与信号电平表联合使用，任何系统部件的收益或损失都可以进行快速测量。
Used in conjunction with a Signal Level Meter, the gain or loss of any system component can be quickly measured.
信号电平也全部依赖与其所在的芯片。
“满刻度”是指转换器可能达到“数字过载”之前的最大可编码模拟信号电平。
"Full scale" refers to the converter could reach the "digital overload" maximum before the encoding analog signal levels.
本文阐述光纤数字通信中部分响应信号的特点，和适当地设置信号电平使平均误码率达到最小的方法。
This paper describes the signal characteristic in optical fiber communication systems, and the way to set the signal levels appropriately for the minimum average error rate.
“最大信号电平”是指能够切换但又不会损坏开关卡的电压、电流和功率的最大值。
"Maximum signal levels" refers to the highest levels of voltage, current, and power that can be switched without damaging the switch card.
对于特定的信号类型，例如低电平或高频率，则不宜使用模拟背板，以避免造成信号劣化。
For certain signal types, such as low level or high frequency, the analog backplane should not be used to avoid possible signal degradation.
另一方面，为了兼容其他那些工作输入信号电压不为0的器件，如模数-数模转换器，信号电平也许要做平移。
On the other hand, the signal may require level shifting in order to be compatible with the input of other devices (such as ADCs) that are not designed to operate at 0v input.
若切换小于最大信号电平的信号，触点寿命将介于105到108之间。
Switching at less than the maximum signal levels yields a contact life between 105 and 108 closures.
分配有必要安装在120型的大方线盒内(TV盒)减少电平信号的丢掉，一同又便于维修。
Distribution is necessary to install in the 120 type of the easy line box (TV box) to reduce the level of signal loss, together and easy to repair.
就电缆电视系统信号电平变化的几种情形作系统的理论分析，并指出解决办法，供广大有线电视系统工作人员参。
Mainly analyses several cases of signal level variation in CATV system, and also points out practical methods to be consulted by workers in CATV system.
第二部分介绍了当存在相对高的测量系统噪声（示波器噪声）电平时，如何进行更精确低电平信号噪声和干扰测量的有用提示。
The second part is to introduce the useful prompt to measure the low level signal noise and its disturbance even more accurately when there is rather high noise level in measure system.
当信号从原中心频率偏移，信号越来越从设定的发射通道偏移，功率分析仪的功率电平会越来越低。
As the signal is shifted from the original center frequency, the RF power analyzer reads lower and lower power levels as more and more of the signal shifts out of the intended transmission channel.
在恶劣电力线通信环境下，只有努力提高自动增益控制(agc)水平，才能实现信号电平的稳定。
In poor PLC communication environment, the stability of the signal can only be realized by improving the level of Automatic Gain Control (AGC).
并同时以“时序法”及电平记录仪所测得的信号分析相比较，结果基本相符。
Comparing this result with other one which was obtained from"time serial analysis"and signals detected by electrical record metre we found that both results are very consistent.
如果输出电压小于预定的电压电平，则开关电路部分将增强的控制信号传输到调节电路。
If the output voltage is less than the predetermined voltage level, the switching circuit portion transmits an enhanced control signal to the regulation circuit.
光扭矩传感器的输出信号在进行光电转换过程中，由于温度影响，造成了直流电平漂移误差，影响系统的测量精度。
During the photoelectric conversion process of output signal from optical torque sensor, DC level drift error induced by temperature influence will affect the measuring accuracy of the system.
最后，讨论了频谱仪本地噪声对低电平信号测量影响的修正方法。
At last, correction method of low level signal measurement is discussed duo to effect of spectrum analyzer floor noise.
由偏差和测量时间有限而引起的总误差与量化输入信号限幅电平有关。
The total error due to finite observation and bias is dependent on the limited level of the quantized input signal.
有效地校正由上述因素产生的误差以获得良好的天线副瓣电平和信号处理能力，一直是人们着重研究的课题。
It is always an important problem to effectively correct the errors due to the above mentioned reasons to achieve excellent antenna sidelobe level and signal processing capability.
让你的信号接近这个电平，你的机架设备，调音台会工作的更好。
So by putting the incoming signal at around this reference, your rack equipment will work better as well.
门限电平的定量分析对卫星电视系统提高接收微弱信号的能力具有重要的指导作用。
A quantitative analysis of the threshold level is important to improve the abilities of receiving weak signals for satellite television system.
模拟时域，或波形。模拟时域信号不同于其他信号，它通过信号电平传输有用的信息，而这些电平时随时间变化的。
Analog time domain, or shape, signals differ from other signals in that they convey useful information not only in the signal level, but also in how this level varies with time.
由于模拟直流信号是静态或缓慢变化的，因此测量时更注重于测量电平的精确度而不是测量的时间或速率。
Because the analog DC signal varies slowly, the accuracy of the measured level is of more concern than the time or rate at which you take the measurement.
多功能芯片ADT14既是一种输出逻辑电平控制信号的多点温度监控器，又是一种输出模拟电压信号的温度传感器，可广泛应用于各种嵌入控制系统中。
The multi-functional chip ADT14 is a kind of multi-point temperature monitor of outputting logic level control signal, It is also a kind of temperature sensor of outputting simulated voltage signal .
多功能芯片ADT14既是一种输出逻辑电平控制信号的多点温度监控器，又是一种输出模拟电压信号的温度传感器，可广泛应用于各种嵌入控制系统中。
The multi-functional chip ADT14 is a kind of multi-point temperature monitor of outputting logic level control signal, It is also a kind of temperature sensor of outputting simulated voltage signal .
应用推荐