本系统可以实现多路温度信号采集与显示，可以使用按键来设置温度限定值，通过进行温度数据的运算处理，发出控制信号达到控制蜂鸣器和继电器的目的。
The system achieves multi-channel temperature signal acquisition and control. Temperature limit is set by keyboard. The buzzer and relay are controlled by MCU.
在检测到待机信号时，单片机控制继电器开关，将电流切断，家电完全断电，消除了待机功耗，达到节能的目的。
When detecting standby signal, microcomputer gives structure to relay switch to cut off the current, then standby power is eliminated so as to realize energy saving.
由单片计算机控制的计数器自动产生通1秒停4秒的信号，使5路继电器输出带动电喇叭轮流通电。
By single chip computer control of counter automatically generate tong 1 second stop 4 seconds of signal, make no. 5 relay output drive electric horn turns electrify.
电子模块取代原有的继电器，直接实现对道岔、信号机、减速器的控制和对轨道电路的状态识别。
Electronic modules, instead of traditional relays, perform directly the control of switches, signals and retarders and identification of the status of the track circuits.
控制电路通过水位检测信号，利用继电器和接触器控制排水机构。
The control circuit controls the water drainage mechanism using a relay and a contactor by the water level detection signal.
复合式闪光继电器是一种用来控制转向信号灯和危险报警灯的电子产品。
The composite flash relay is a kind of electronic product to control steering signal lights and danger alarm lights.
如果实际温度超出了控制范围，则系统会有自动的提示信号，并且相应的继电器会动作。
If the actual temperature exceeds the setting range, the system will automatically give signal, and the corresponding Relay will take related actions.
系统控制核心采用AT 89 C 2051单片机，信号输出为音响和多组继电器开、闭触点。
The system takes the monolithic computer AT89C2051 as the control kernel, and the tone and contacts of relay as the signal output.
介绍多功能组合继电器的优点，提出一种包含转向信号、间歇刮水、后雾灯控制功能的组合继电器设计。
The author introduces the merits of multifunctional combination relay, advances the design of a kind of combination relay that can control the steering signal, intermittent wiping and rear foglight.
示范90低压91高压模型选择继电器的设计选择较低或两个信号的压力较高，以提供持续的输出压力的控制装置。
The Model 90 low pressure and Model 91 high pressure Selector Relays are designed to select the lower or higher of two signal pressures to provide a continuous output pressure to a control device.
在铁路车站信号控制领域，目前应用最广的是6502电气集中和以继电器为执行机构的计算机联锁系统。
Nowadays the 6502 electric centralization and the computer interlocking system with actuator of relays are widely applied in the railway signal control system.
在典型的R LC振荡放电电路中，引入5 5 5时基电路和水银继电器作为控制电路，设计了阻尼正弦瞬变信号发生器。
In typical R-L-C resonance circuit, the 555-time-circuit and mercury relay are used as control unit. A damped sinusoid source is designed. It has been proved that the source satisfies our request.
在典型的R LC振荡放电电路中，引入5 5 5时基电路和水银继电器作为控制电路，设计了阻尼正弦瞬变信号发生器。
In typical R-L-C resonance circuit, the 555-time-circuit and mercury relay are used as control unit. A damped sinusoid source is designed. It has been proved that the source satisfies our request.
应用推荐