现金有一个阀门低温阀门和控制广泛的一致。
Cash valve has an extensive line of cryogenic valves and controls.
低压密封试验4.4.1进行低压密封试验时，低温阀门密封面应保持干净，无油、无油脂和密封脂，如需防止擦伤。
Low pressure seal test 4.4.1 for low pressure seal test, the sealing surface should be kept clean, no oil, no grease and seal fat, for to prevent scratches.
结合工程实际，提出了一种较完整的低温阀门深冷试验装置设计方案，并就装置结构、参数检测、深冷处理机理和低温试验方法等方面的内容进行了探讨。
This thesis gives a brief introduction of the steps how to estimate the uncertainty in electric sector, and for low-temperature test proficiency testing prog - ram program No.
对于低温液体钢瓶，转移管连接到钢瓶的液体提取阀门上。
For cryogenic liquid cylinders, the transfer line is connected to the cylinder liquid withdrawal valve.
结构紧凑、重量轻，可以认为它时用于低温介质系统的最合理的阀门结构。
The structure of compact, light weight, it could be that the media system for low-temperature valve structure of the most reasonable.
对于低温液体钢瓶，转移管连接到钢瓶的液体提取阀门上。
For cryogenic liquid cylinders, the transfer line is connected to the cylinder's liquid withdrawal valve.
为了防止低温液体或低温气体积聚在阀门之间的管道内，要给管道配备减压装置。
To prevent cryogenic liquids or cold gas from being trapped in piping between valves, equip the piping with pressure-relief devices.
为了防止低温液体或低温气体积聚在阀门之间的管道内，要给管道配备减压装置。
To prevent cryogenic liquids or cold gas from being trapped in piping between valves, the piping should be equipped with pressure relief devices.
在低温应用环境下，配置硬面的阀门也适用于严酷的应用环境。
Valves with hard facings are also suitable for severe services at low temperatures.
我们在法国里昂的工厂工程师正在开始开发适用于低温应用的TORQSEAL阀门。
The engineers in our Lyon operations are starting work on developing the TORQSEAL valve for cryogenic applications.
焊接端口阀门适用于不需要拆卸的软焊接管线，采用低温焊料(204oc)。
Solder end valves are designed to be soft soldered into lines without disassembly, using a low temperature solder (400of) (204oc).
低温设备仪表在线阀门的阀帽和填料箱应为加长阀帽型或伴热型(必要时)，从而避免阀杆结冰。
The bonnet and packing box of low temperature service instrument in-line valves shall be extended bonnet type or heat traced, if necessary, to avoid freezing of valve stems.
在此种极低的温度下，管道、阀门和管接头等的材质必须采用特殊的耐低温材料。
In such low temperatures, pipes, valves and fittings and other material must be of special low-temperature-resistant materials.
低温热水地面辐射供暖系统由热源，分、集水器，绝热层，加热管，填充层以及管路、阀门、过滤器等组成。
Low temperature hot water floor radiant heating system consists of heat source, and the collector, the heat insulation layer, heating pipe, pipeline, valve, filling layer and filter etc...
装置刚启动时，管道出现低温冷凝水，膜盒内的液体处于冷凝状态，阀门处于开启位置。
When the device just starts, there appears condensate with low temperature in conduits and the liquid in the bellows is in the condensed state. The trap is turned on.
装置刚启动时，管道出现低温冷凝水，膜盒内的液体处于冷凝状态，阀门处于开启位置。
When the device just starts, there appears condensate with low temperature in conduits and the liquid in the bellows is in the condensed state. The trap is turned on.
应用推荐