典型的低温液体钢瓶如图2所示。
典型的低温液体钢瓶如图3所示。
只使用设计用于低温液体的转移管。
Only transfer lines designed for use with cryogenic liquids should be used.
随后，氧作为低温液体搬运和储存。
The oxygen is then removed and stored as a cryogenic liquid.
随后，氩作为低温液体运输。
研究了低温液体的水下直接排放问题。
The cryogenic liquid drained directly into water was studied.
所有低温液体的温度都极低。
总是小心地操作低温液体。
所有低温液体在蒸发时都会产生大量的气体。
All cryogenic liquids produce large volumes of gas when they vaporize.
分析了低温液体与水之间的传热过程及其特性。
The process and characteristics of heat transfer between cryogenic liquid and water were analyzed.
可装低温液体进行低于环境温度的线膨胀系数测试试验。
Can be installed in cryogenic liquid is lower than the environment temperature linear expansion coefficient test test.
必须认识到，在操作惰性低温液体时存在窒息的可能性。
The potential for asphyxiation must be recognized when handling inert cryogenic liquids.
目的探讨静脉滴注低温液体对烧伤高热患者的降温效果。
Objective To explore the cooling effects of intravenous drip of hypothermal liquid on the patients with burn and high fever.
对于低温液体钢瓶，转移管连接到钢瓶的液体提取阀门上。
For cryogenic liquid cylinders, the transfer line is connected to the cylinder liquid withdrawal valve.
对于低温液体钢瓶，转移管连接到钢瓶的液体提取阀门上。
For cryogenic liquid cylinders, the transfer line is connected to the cylinder's liquid withdrawal valve.
当蒸发到气态时，大多数低温液体是无嗅、无色和无味的。
MOST cryogenic liquids are odorless, colorless, and tasteless when vaporized into the gaseous state.
眼睛是对低温液体的液体和蒸气的超低温最敏感的人体部分。
The eyes are the most sensitive body part to the extreme cold of the liquid and vapors of cryogenic liquids.
液体转移管用于从杜瓦瓶或低温液体钢瓶中安全地提取液体产品。
A liquid transfer line is used to safely remove liquid product from dewars or cryogenic liquid cylinders.
熄灭狭窄空间内的易燃低温液体一般是不可取的，这取决于环境。
Depending upon the circumstances, it is generally not advisable to extinguish a flammable cryogenic liquid in a confined area.
在低温液体火箭发动机的试验中，对液体密度的测量是很重要的。
It is very important to measure liquid density in cryogenic liquid rocket engine test.
介绍了卧式低温容器的传热特点，以及低温液体无损贮存的传热模型。
The heat transfer characteristic of horizontal cryogenic vessel and the heat transfer model of non-loss storage for cryogenic liquid were introduced.
低温液体钢瓶配备有可以复位的减压装置，另外还用破裂盘来保护钢瓶。
Cryogenic liquid cylinders are equipped with reseat able relief devices and are additionally protected with burst discs.
然后，用以对此规格的钢丝制造的气阀弹簧进行了低温液体软氮化处理。
Then, pneumatic valve spring made from this spring steel wire have been treated by this investigation of liquid tufftriding process.
不同的排放环境压力下，低温液体与水之间的传热过程及特性会有所不同。
The process and characteristics of heat transfer between cryogenic liquid and water are different under different environment pressure.
在空气分离工厂，通过空气液化和蒸馏分离出氮。接着氮作为低温液体回收。
Nitrogen is produced at air separation plants by liquefaction of atmospheric air and separation of the nitrogen by distillation. The nitrogen is then recovered as a cryogenic liquid.
当与惰性低温液体或液氧一起工作时，应备有监测器来检查空气中氧的浓度。
Monitors should be available to check for oxygen concentrations in the atmosphere when working with inert cryogens or with liquid oxygen.
该种计算方法在预测低温液体无损贮存压力升高时有较高的准确性与可靠性。
This calculation method possesses better accuracy and reliability to predict the pressure change in the process of cryogenic liquid non-loss storage.
结论静脉滴注低温液体是一项有效、安全的降温方法，适合烧伤高热病人应用。
Conclusion the intravenous drip hypothermia liquid is an effective and safe cooling method. It ADAPTS to the patients of burn and hi-heat.
当低温液体没有泄漏或已经产生了水蒸汽时，这种雾也会在低温设备附近生成。
This fog can also be formed around cold equipment when no release of the cold liquid or vapors has occurred.
为了防止低温液体或低温气体积聚在阀门之间的管道内，要给管道配备减压装置。
To prevent cryogenic liquids or cold gas from being trapped in piping between valves, equip the piping with pressure-relief devices.
应用推荐