• 过的蒸气然后进入汽轮机低压

    The dry, reheated steam then enters the low pressure turbine.

    youdao

  • 托电3机组低压叶片运行3个月就发生了断裂

    The LP casing blade of unit 3 in Tuoketuo Power Plant is broken after only three months operation.

    youdao

  • 介绍汽轮机高、中和低压缸流道的流量分布计算方法

    The paper presents a method for calculating mass flow distribution and pressure losses in HP, IP and LP steam turbine extractions.

    youdao

  • 冷凝式汽轮机系统低压缸末级出口余速动加以利用关键部件。

    Exhaust system is of great importance to the overall performance of the steam turbine.

    youdao

  • 本文的主要目的讨论叶片大功率汽轮机低压缸次东级工程应用问题。

    The primary goal of this paper is to discuss the engineering application of the bowed and twisted blade on sub-last and last stages of steam turbines.

    youdao

  • 本文叙述辽河化肥厂合成气压缩机低压入口处振值居高不下分析过程处理手段

    This paper explains the analysis course and the treatment measure for high vibration at the entry of low pressure cylinder of synthetic ammonia compressor in Liaohe Chemical Fertilizer Factory.

    youdao

  • 1993年开始实施低压密封改造密封改造蒸汽阻塞密封,使用效果良好

    From 1993, the reconstruction of low pressure cylinder sealing began to conduct. The floating ring seal are changed into steam jamming seal. The applied effect is good.

    youdao

  • 通过对低压低压及其对应捕集器采取相应措施保证冰机稳定运行

    Relative measures were taken to the floating ring on the low pressure side of LP cylinder and corresponding sludge oil collector, to ensure stable operation of the freezing machine.

    youdao

  • 汽轮机组和凝汽器热平衡入手,对汽轮机性能老化低压缸变动方向进行研究

    Starting with the heat balance of steam turbine unit and condenser, the study is carried out on changed direction of exhaust steam point after turbine performance aging.

    youdao

  • 本文研究工作一定程度上汽轮机低压低压进汽系统结构设计提供了建设性意见

    The study work of this paper provide some constructive advice in a way to the structure designed of inlet system of the low-pressure cylinder.

    youdao

  • 针对二氧化碳压缩机低压振动现象进行分析提出相应检修处理方案具体防范措施

    This paper analyses the phenomena of vibration in LP drum of CO2 compressor, puts forward corresponding repairing scheme and specific countermeasures.

    youdao

  • 系统建模主要围绕其四个子系统展开,器、冷却塔、汽轮机低压末端以及循环水泵

    The modeling of cold end system was carried out surrounded by its four subsystems, which are condenser, cooling tower, the end of lower pressure cylinder, and circulating water pump.

    youdao

  • 针对现有汽轮机低压缸在线计算模型存在一定的局限性提出了种排汽焓在线计算模型。

    A new online model for calculating the exhaust enthalpy was proposed aiming at the limitation of existing online calculation model for calculating the enthalpy of steam turbine lp exhaust hood.

    youdao

  • 在此主要针对低压效率偏低原因着重低压以及气流组织好坏方面进行了分析。

    We will target the reasons for the low efficiency of low-pressure cylinder, Focus on the inlet air flow field and their organization's performance in this regard were analyzed.

    youdao

  • 通过分析研究低压工况三维,可深入了解透平内部流动机理有助于进一步优化机组设计

    Through the study for the full 3-d flow field of LP casing under all conditions, the internal flowing mechanism of the turbine shall be known clearly to optimize the design of air cooling units.

    youdao

  • 通过2号汽轮机低压缸通道进行优化改造试验,发挥了凝汽器铜管热交换潜力,提高器真空度

    The purpose is to increase the hot exchange potentiality of the steam condenser and improve the vacuum of the steam condenser.

    youdao

  • 详细介绍华能玉环电厂1 000MW机组采用碰撞试验方法进行汽轮机高、中、低压缸轴向径向定位。

    This paper introduces collision tests used in Huaneng Yuhuan Power Plant 1 000 MW unit axial and radial alignments of turbine HP, IP and LP casings.

    youdao

  • 针对汽轮机低压末端本文基于汽轮机功率特性建立了循环水变速调节系统的多目标节能优化体系结构。

    To the end of lower pressure cylinder, the thesis set up architecture of multi-objective energy saving for thermal power units on the basis of power characteristic to back pressure of steam turbine.

    youdao

  • 对东方汽轮机厂生产的D29机组低压转子振动特性进行了分析指出低压工作转速附近存在结构共振,并针对这个问题提出了现场的处理措施

    The LP rotor vibration of the D29 turbine unit was analyzed in this article, and point out LP cylinder was in structure resonance region around working speed, for this fault the measure was given.

    youdao

  • 介绍了350MW汽轮机低压制造过程各个制造难点解决了详细的说明

    The article introduces the fabrication process of 350mw steam turbine outer cylinder, and describes the solution to every difficulty in detail.

    youdao

  • 介绍了350MW汽轮机低压制造过程各个制造难点解决了详细的说明

    The article introduces the fabrication process of 350mw steam turbine outer cylinder, and describes the solution to every difficulty in detail.

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定