图2示出传统的12位转换器的最后四个位试验的示例。
FIG. 2 shows an example of the last four bit trials of a traditional 12-bit converter.
这些记录包括内置的16位转换器和较低成本(低性能)为多轨道模拟录像机的替代。
These recorders included built-in 16-bit converters and were low-cost (and low performance) replacements for multi-track analog recorders.
注意用具有3个校正位的12位转换器的特定情况描述了引入偏移以提高转换的分辨率。
Introducing an offset to increase the resolution of the conversion has been described with the specific case of a 12 bit converter with 3 correction bits in mind.
本设计为兼顾模数转换器的速度和精度，采用数字校正技术，以每级1.5 位的9 级流水线结构实现。
The converter has a good tradeoff between conversion speed and conversion precision. It is a 1.5-bit per stage with 9 stage and digital correction technique.
大厦内的自动增益控制的阈值可数码网，以合片上4位D /A转换器控制的。
The thresholds inside the AGC blocks can be digitally controlled by means of on-chip 4-bit D/A converters.
模数转换采用了14位，四通道A／D转换器MAX1325，实现了自整角机四路模拟数据的同时、快速采样。
The 14-bit, four-channel A/D converter MAX1325 is employed to sample the analog input and output voltage of the synchro and then converted them into digital.
音圈电机的驱动采用16位D/A 转换器，使音圈电机的控制精度提高。
The VCM is driven by a 16 bits D/A converter to improve the control precision.
本文介绍了一种自动测试系统，可对12位及12位以下的A/D转换器的转换特性进行测试。
This paper introduces a type of automatic test system that can test the transfer function characteristic of 12-bit or less than 12-bit A/D converters.
图1所示为理想和带增益误差的3位ADC转换器的传递方程。
Figure 1 shows the transfer function of an ideal 3-bit ADC and the same converter with gain error.
在VITA25K型传感器还具有一个10的数字输出，易于应用开发的片上时序控制位片上模拟到数字转换器（ADC）。
The VITA 25K sensor also features a 10-bit on-chip analog-to-digital converter (ADC) for digital output and on-chip timing control for easy application development.
仅使用两个转换器形成胶连逻辑，一个8位微处理器和两个12位DAC实现256级QAM。
Using just two inverters for glue logic , an 8-bit microcontroller and two 12-bit DACs enable 256-level QAM.
AD9218 功能框图AD9218是一款双核10位单芯片采样模数转换器（ADC），内置片内采样保持电路，具有低成本、低功耗、小尺寸和易于使用等特性。
The AD9218 is a dual 10-bit monolithic sampling analog-to-digital converter with on-chip track-and-hold circuits. The product is low cost, low power, and is small and easy to use.
AD 9446是一款16位单芯片采样模数转换器(adc)，内置一个片内采样保持电路，专门针对高性能、小尺寸和易用性进行了优化。
The AD9446 is a 16-bit, monolithic, sampling analog-to-digital converter (ADC) with an on-chip track-and-hold circuit. It is optimized for performance, small size, and ease of use.
简要介绍了16位模数转换器MAX195的结构和性能，详细讨论了MAX195在单片机系统中的两种应用，并分别给出了硬件电路和软件程序设计。
The structure and performance of 16 bits analog-to-digital converter MAX195 is briefly described, and based onwhichtwo applications inMCUsystem includinghardware and software designs is discussed .
甚至更复杂的问题，转换器输出12位或是14位数据，还有16位输出。
To even further complicate matters, some converters produce 12 - or 14-bit output words, and others produce 16-bit output words.
AD7693是一款16位、逐次逼近型模数转换器（ADC），采用单电源（VDD）供电。
The AD7693 is a 16-bit, successive approximation analog-to-digital converter (ADC) that operates from a single power supply, VDD.
系统由8051单片机、16位模数转换器MAX1177、存储器、信号调理电路和串口电路等构成。
The system is composed of 8051MCU, 16bits A/D MAX1177, memory, signal condition circuit and serial interface.
本文提出了基于沃尔什函数的模数转换器（ADC）位检定方法。
Methods based on Walsh Function for calibrating analog-to-digital convert-ers(ADCs) at the bit level are presented in this paper.
一般来说，光盘质量可能下降1991至2002年间，由于16位多轨机和使用其内置的转换器。
In general, the quality of CDs probably declined between 1991 and 2002 due to the use of 16-bit multi-track machines and their built-in converters.
处理器不能从转换器识别出负数，所有来自12位的双极性adc数据都是正的。
The processor does not recognize a negative number from the converter and assumes that all codes from the 12-bit, bipolar-in ADC are positive.
此转换器只能将16 位有符号整数对象与字符串相互转换。
This converter can only convert a 16-bit signed integer object to and from a string.
本论文着重阐述一种基于数据权重平均算法（DWA）的12位分段式电流舵型数模转换器的设计。
The dissertation introduces the design of a 12-bit segmented current steering DAC based on data weighed average algorithm (DWA).
输出的时钟信号普适于多通道多相 位时钟应用，尤其适用于并行交替型模数转换器。
An output clock signal is universally suitable for the application of the multi-channel multi-phase clock, and is particularly suitable for a parallel alternate type analog-to-digital converter.
本文设计的数模转换器是一个“4-4-4”分段的12位电流舵型DAC。
The dissertation designs a 12-bit "4-4-4" segmented current steering DAC.
本文设计的数模转换器是一个“4-4-4”分段的12位电流舵型DAC。
The dissertation designs a 12-bit "4-4-4" segmented current steering DAC.
应用推荐