通过模拟仿真验证了双基斜视CS算法的保相性和基线不稳定补偿方法的有效性。
The simulation results validate the property of phase preserving of bistatic and squinted CS algorithm and the effectiveness of compensated method of baseline instability.
数学仿真验证了改进方法比传统方法更能够及时准确地识别双余度传感器缓变故障。
Mathematical simulation results show that the improved method can identify and orientate dual sensor soft fault more exactly and quickly than the traditional method.
介绍了多目标攻击的目标分配和攻击排序的过程与算法，并用仿真验证了该算法的有效性。
The process and algorithm of target distribution and attack sequence in multi target attacking are introduced, and the validity of the algorithm is proved by simulation.
本课题结合项目的要求，对分组传送芯片组中一款千万门级的流量管理芯片进行了仿真验证。
Complying with the requirement of the project, the simulation of traffic managing chip with ten million gates in chips of packet transport networks is executed in this subject.
理论分析与仿真验证都证明新原理不受长线路分布电容电流的影响，具有很高的灵敏性和可靠性。
Theoretical analysis and simulation prove that the proposed protection principle will not be affected by distributed capacity current of transmission line and has higher sensitivity and reliability.
通过对机织布、针织布、斜纹布和网眼布等不同种类织物的仿真验证了该算法的有效性和适应性。
Computer simulation demonstrate that the proposed algorithm can adapt to the identification of several different kinds of fabric as woven, stockinet, damask and mesh fabric.
所述方法在某型双转子涡喷发动机气动热力学非线性模型上对抗干扰性和目标跟踪进行了仿真验证。
Simulations on the nonlinear model of the twin spool turbojet engine aerothermodynamics are conducted to verify the disturbance rejection and tracking performance.
指出在角加速度存在的情况下，光功率的波动产生IFOG输出误差，通过仿真验证了所提出的观点。
We verifies the opinion through our simulating that the fluctuation of optical power make output errors of the IFOG on the condition that the angular acceleration is being.
LOP电路设计采用VHDL语言门级描述，已通过逻辑仿真验证，并在浮点加法器的设计中得到应用。
The LOP circuit module is described in gate level with VHDL, which has passed the logic simulation and verification. It is applied to the design of floating-point adder.
最后以某型歼击机结构故障为例进行了仿真验证，结果表明该方法确能有效的检测出歼击机的各种故障。
Finally, the proposed scheme is demonstrated using the model of a fighter and the results show that the method is an effective tool for structural fault detection of the fighter.
最后本文采用定子磁场定向的矢量控制策略，结合转速扰动功率观测的控制算法对转子侧进行了仿真验证。
Finally, simulating experiment for the whole system is carried through with the stator flux-oriented vector strategy and control arithmetic of rotor speed perturb and power observation.
建立其数学模型，并进行计算机仿真验证，其结果显示出该方法可以有效地提高目标的位置精度与可靠性。
A mathematical model is established and validated with computer imitation. The results show that the method can effectively improve accuracy of object position and reliability.
建立其数学模型，并进行计算机仿真验证，其结果显示出该方法可以有效地提高目标的位置精度与可靠性。
Mathematics model is established, and verified by the imitation of computer. The results show that the method can effectively improve the accuracy and reliability of the position.
通过仿真验证并与常规串级PID控制系统进行比较，表明自适应PS D控制系统具有更好的控制效果。
Through simulation verification and comparison with conventional cascade PID control system, the results show the self-adaptive PSD control system has better control effectiveness.
在此基础上建立系统的运动学模型，利用捕获环伸出过程和缓冲阻尼过程系统运动学仿真验证了系统模型。
Based on the analysis the kinematics model is established and it is checked by the kinematicss simulation of protrusion capture ring and cushion damping procedures.
研究了在数字最优预见控制中，输入权重对评价函数的影响，给出了两者的函数关系，最后进行了仿真验证。
The influence of input weighting on evaluation function in digital optimal predictive control is investigated. Its function relation derived has been proven by simulation.
在从参考模型取状态MRAC方案的基础上，提出了混合自适应设计方法。文中给出详细的理论推导和仿真验证。
This paper presents a mixed self adaptive design method by taking the state MRAC scheme from a reference model. It gives a detailed theoretical derivation and simulation proof.
主要通过机理分析建立了氧量软测量模型，仿真验证表明建立的氧量软测量模型能够较好的反映实际氧量的变化。
Setting up the soft-sensing models of oxygen content through mechanism analysis, and this soft-sensing model fit well with the practical oxygen content, which is illustrated by the simulations.
对所提出的触发rsd方式的脉冲电源设计方法进行了试验验证分析和仿真验证分析，证明了设计方法的正确性。
Design methods that the pulsed supply with means triggering RSD is mentioned are verified and analyzed by experiment and simulation. The correctness of design methods are proved.
结合视频压缩的理论以及IP核设计中对于仿真验证的要求，本文设计了视频压缩IP核FPGA仿真验证平台。
According to the theory in video compression as well as the simulation and verification requirement in IP core designing, the FPGA based IP core simulation platform is developed.
采用机理分析和统计分析的方法，建立了二次风系统非线性动态模型，并通过仿真验证了模型的有效性和准确性。
Utilizing mechanism analyzing and statistical analyzing methods, a dynamic model of secondary air systems has been constructed and its effectiveness and accuracy validated by simulation.
通过仿真验证了在电网电压存在畸变时，有源电力滤波器的补偿效果良好，且可以根据对谐波和无功电流灵活补偿。
The results of simulation verify this scheme is effective, and in this scheme APF can compensate harmonic and reactive currents with the distorted source voltages flexibly.
对单机无穷大母线系统进行了公式推导和仿真验证，从理论上探讨了多机系统的三相短路故障临界切除时间求解方法。
The formulae for SMIS are derived and verified by case simulation, the solution of critical clearing time (CCT) of three-phase short fault in MMS is theoretically discussed.
另外，根据本文提出的视频流量模型实现了一个内嵌于ns - 2的视频流量产生器，并用它进行了网络仿真验证。
Moreover, this paper implemented a video traffic generator embedded in NS-2 according to the model proposed in this paper. And it is applied to network simulation.
在此基础上，建立了该空间站的一种极点配置混合自适应控制算法，通过计算机仿真验证了该算法的有效性和鲁棒性。
Based on this model, a pole assignment hybrid adaptive control scheme for the station has been proposed and illustrated to be effective and robust through computer simulation results.
介绍了数模混合信号仿真的设计流程，说明了一种在混合设计的各个层次上对系统进行仿真验证的自上而下的设计方法。
A design flow based on mixed-signal simulation is proposed. The top-down design method indicates simulation and verification at each level of the mixed signal system design.
针对球体固定单目视觉测距问题，推导了椭圆中心偏移量的解析公式，研究了基于该公式的校正方法，并进行了仿真验证。
To solve the sphere ranging problem of fixed monocular vision, the analytical formulation of ellipse center offset is deduced, and the calibration method using this formulation is proposed.
针对球体固定单目视觉测距问题，推导了椭圆中心偏移量的解析公式，研究了基于该公式的校正方法，并进行了仿真验证。
To solve the sphere ranging problem of fixed monocular vision, the analytical formulation of ellipse center offset is deduced, and the calibration method using this formulation is proposed.
应用推荐