在介绍漏磁检测原理的基础上，详细论述了利用有限元法分析缺陷信号的方法以及利用ANSYS对漏磁信号的仿真过程和仿真结果，并对结果进行分析。
On the base of introducing the principle of the magnetic flux leakage (MFL) detection, the finite element method based on ANSYS used to simulate and analyze the MFL signal is presented.
针对WITNESS仿真环境下，复杂离散事件仿真建模过程中出现的大量顺序、并行、同步、冲突及因果依赖等关系，提出采用改进型idef 3方法进行仿真建模。
An improved IDEF3 method was presented to describe a great lot sequence, paralleling, synchronization, conflict and consequence relation during discrete event simulation using WITNESS software.
采用蒙特卡罗法设计车辆转弯行为仿真模型，并提出了局域路网交通量与OD矩阵估计的集成仿真方法。
Monte Carlo Stochastic Modeling Method is adopted to design vehicle turning behavior module, and a simulation model integrating link traffic flow and od matrix estimation is established.
以单根箔条rcs的计算方法为基础，使用矢量输运理论对箔条云团rcs的计算进行了计算机仿真，并基于半解析法开发了箔条云团rcs模拟仿真软件包。
Based on the RCS calculation method of a single chaff, using vector transport theory, a computer simulation on the RCS calculation of chaff cloud is conducted.
仿真实验结果表明：新的仿真方法改善了仿真数学模型的形式，并且利用经验值估计区间的参数优化法大大地提高了运算效率。
The simulation results express that the new simulation method improves simulation mathematical model, and the estimate zone method enhances the operation efficiency.
其次，结合MATLAB编程仿真和HFSS建模仿真，对微带天线的三种典型分析方法进行了深入研究，即传输线法、腔模理论和有限元法，为下面宽频带微带天线的设计奠定了理论依据。
Secondly, Using MATLAB and HFSS to deeply research three types of analytical method for microstrip antenna which are transmission line method, cavity mode theory and finite-element method.
其次，结合MATLAB编程仿真和HFSS建模仿真，对微带天线的三种典型分析方法进行了深入研究，即传输线法、腔模理论和有限元法，为下面宽频带微带天线的设计奠定了理论依据。
Secondly, Using MATLAB and HFSS to deeply research three types of analytical method for microstrip antenna which are transmission line method, cavity mode theory and finite-element method.
应用推荐