同时，LG变频器的自动节能模式，可使电机在满足负载转矩要求下以最小电流运行，达到更好的节电效果。
At the same time, the automatic energy-saving mode frequency converter LG, can make the motor in the meet load torque requirements to minimum current operation, to reach better energy saving effect.
本文提出了电流型逆变器-感应电动机变频调速系统中电机驱动恒功率负载时，系统以最大效率运行的节能控制方式。
This paper proposes an energy saving control mode for current source inverter(CSI) induction motor drive system with the motor driving a constant power load.
为了提高电能质量，通常采用有源电力滤波器来补偿非线性负载的谐波电流，以减小谐波对电网的污染。
In order to improve the power quality, Active power filter is used to compensate harmonic current of nonlinear load to decrease harmonic pollution of the grid.
提出了以电流为反馈量进行负载跟踪，实现电机轻载节能的控制方法。
A control method of combining the current feedback and load tracking controller is presented.
TEA1061引脚说明：注4：负载电流静态电流增加，是指以地积比iload速冻。
TEA1061 Pinout: Note 4: Quiescent current increases with load current, refer to plot of IQF vs ILOAD.
优化匹配网络，减小负载电流和电压的相角，以减少负载反射功率；
Optimizing the matching net and reducing the phase angle between the output voltage and current to reduce the reflection power of the loads, iv.
注4：负载电流静态电流增加，是指以地积比iload速冻。
Note 4: Quiescent current increases with load current, refer to plot of IQF vs ILOAD.
MAX15058供给可选择的跳过模式功能，以削减电流耗损，实此刻轻输出负载更高的效率。
The MAX15058 offers selectable skip-mode functionality to reduce current consumption and achieve a higher efficiency at light output load.
本文以并联电流型有源滤波器的数学模型为基础，讨论了有源滤波器的控制方法。该方法由负载电流前馈、电源电流状态反馈和控制延迟补偿组成。
In this paper, the control method of the current-source active filter is discussed, which is made up of the state-feedback and delay compensation control.
本文以并联电流型有源滤波器的数学模型为基础，讨论了有源滤波器的控制方法。该方法由负载电流前馈、电源电流状态反馈和控制延迟补偿组成。
In this paper, the control method of the current-source active filter is discussed, which is made up of the state-feedback and delay compensation control.
应用推荐