失败的事件管理器处理。
“失败事件管理器”应用程序如图8 所示。
从而可以提高事件管理器自身的容错性及其可用性。
You therefore increase event manager's own fault tolerance, and hence, its availability.
JR 30198：失败的事件管理器目标重要性。
可以通过管理控制台或MBean接口访问失败事件管理器。
You can access the failed event manager via the administrative console or via an MBean interface.
图8所示的所有这些失败事件都存储在“失败事件管理器”应用程序中。
All of these failed events shown in Figure 8 are stored in the "FailedEventManager" application.
关于失败事件管理器接口的更多信息，请参见FailedEventManager interface。
For more information about the failed event manager interface, refer to FailedEventManager interface.
最后，本文列出了可能发生的错误条件，并说明如何从操作的角度识别它们(失败事件管理器、异常队列等等)。
Finally, it highlights the error conditions that can occur and shows how they can be identified (Failed Event Manager, Exceptions Queues, and so forth) from an operational point of view.
当运行时错误被处理后，管理员必须使用管理控制台或失败事件管理器(FEM)api脚本重新提交失败事件。
Once the runtime errors are resolved, the administrator will have to resubmit the failed events using either the admin console or scripts that use the failed event manager (FEM) API.
在V6.2中JMS绑定支持失败事件管理器，且在v7中增强了这种支持以便包括WebSphereMQ绑定。
In V6.2 the JMS binding supported the Failed Event Manager, and in V7 this support has been enhanced to include WebSphere MQ bindings.
如果你的事件管理器在后台线程火灾事件，你必须确保你的事件处理程序以某种方式阻止隔离被另一个线程处理。
If your event manager fires events on background threads, you have to make sure your event handler somehow prevents the isolate from being disposed from another thread.
DSP2812计算出光源空间位置，其比较差值直接送入DSP2812的事件管理器控制电机，实现快速定位和跟踪。
The DSP2812 calculates the lamp-house space position. Its compare difference is directly sent to the event manager control engine of DSP2812 and the fast orientation and tracking.
失败事件管理器支持—WebSphereESBV6.2引入了失败事件管理器，使异步发送的失败消息能够得到集中处理和管理。
Failed Event Manager support — WebSphere ESB V6.2 introduced the Failed Event Manager, enabling failure messages that were sent asynchronously to be held and managed centrally.
首先，本文在研究DSP原理的基础上，重点研究了事件管理器中通用定时器的比较操作与PW M波形输出原理以及捕捉单元工作原理。
Firstly, the paper studies the theory of the DSP, especially the theory of the compare operation and the PWM pulse outputting and catch cell.
关于失败事件管理器的更多信息，请参见WebSphereProcessServer 信息中心主题Failedeventmanager。
For more information about the failed event manager, refer to the WebSphere Process Server Information Center on Failed event manager.
它描述了允许服务管理其事件相关订阅的订阅管理器。
It describes subscription managers that allow a service to manage its subscriptions about events.
主要的区别在于，在该事件之后，将创建过程以确保队列管理器的所有实例保持同步，并将应用于一个实例的更改应用于所有的实例。
The main difference is that after the event, procedures are created to ensure that all instances of the queue manager remain in sync, and changes applied to one are applied to all.
收到这个通知后，连接管理器就会毁环发送事件的托管连接，这样就不会再使用它。
On receiving this notification, the connection manager destroys the managed connection that sent the event so that it isn't used again.
在您继续之前，等待直到“扫描管理器完成操作”信息出现在事件日志中为止。
Before you continue, wait until the "Scanner Manager is FINISHED" message is displayed in the Event Log.
一旦传递给了端点管理器，发送方可以确信消息将被传递或是将会引发一个明确的事件(超时)。
Once delivered to the end-point manager, the sender can be assured that the message will be delivered or a definite event (time out) will be raised.
如果必须将一个事件同时通知多个对象管理器，那么使用发布-订阅模型是最合适的。
When you have to notify multiple object managers of an event at the same time, a publish-subscribe paradigm is best suited for your communication needs.
对于大型团队和大量队列管理器的情况，在没有日志或日志分布在很多工作站时，可能追溯到具体的不良事件。
With a large team and lots of queue managers, tracking down a specific adverse event is a practical impossibility when there are no logs, or when the logs are distributed across many workstations.
如果使用持久化事件或活动，一定要记得调优mq队列管理器来优化日志。
If you're using persistent events or actions, it's important to tune the MQ queue manager to optimise logging.
该启动队列接收触发消息(由队列管理器创建)，这些触发消息指示消息到达队列的事件(在本例中为CICS02 . IN)。
The initiation queue receives trigger messages (created by the queue manager) indicating the event of the arrival of a message on a queue (in this case CICS02.IN).
队列管理器事件，例如创建或删除队列
若要为一个mq队列管理器启用事件消息，请遵循WebSphere MQ信息中心中的Controllingconfiguration,command,and loggerevents中的指导。
To enable event messages for an MQ queue manager, follow the instructions under Controlling configuration, command, and logger events in the WebSphere MQ information center.
远程管理器应用程序(或分布式服务)只能通过MBean的管理接口(已公开的属性、操作和事件)发现和访问MBean。
Remote manager applications (or distributed services) can discover and access an MBean only through its management interface (exposed attributes, operations, and events).
这个范围不需要事件，因为与它相关联的对象由垃圾收集器释放，而不是由对象管理器负责。
No event is necessary for this scope because objects associated with it are released by the garbage collector rather than object managers.
陷阱和通知目标以及事件订阅在向SNMP管理器发送事件警报中是必需的。
Trap and notification targets and event subscriptions are required in sending event alerts to an SNMP manager.
陷阱和通知目标以及事件订阅在向SNMP管理器发送事件警报中是必需的。
Trap and notification targets and event subscriptions are required in sending event alerts to an SNMP manager.
应用推荐