当臂杆运行到上下两个极限位置时，分别压下限位开关，切断主控电路，变幅电机停车，达到限位的作用。
When the arm runs to the upper and lower two limit position, respectively press the lower limit switch, cut off the main control circuit, variable amplitude motor parking, to limit the role.
各浮标的数据汇总到主控计算机，由主控机对数据进行综合、解算才能最终得到目标的位置。
Measurement data of buoys is collected for master computer, where target positions are obtained by synthesizing data and resolving equations.
介绍力-位置型力感觉系统的基本工作原理，阐述以8031单片机为主控制器的系统构成。
The basic operational principle of the force-position type sensing system is introduced and the composition of the system with 8031 single chip computer as the main controller is described.
该系统基于80C31单片机为主控制器，采用了混合式稀土永磁步进电机为执行部件，并以双通道旋转变压器为天线位置传感器。
The system adopts 80C31 MCU as the main controller, hybrid Rare-Earth permanent magnet stepper motor as the execution component, bio-passage rotary transformer as antenna position sensor.
在大规模的机群控制中，主控站必须了解各个控制车辆的位置和状态信息，以便对所有车辆进行调度和控制。
In the control of large scale group-machine, in order to control and dispatch mobile engineering machines, the control center must know the information about them.
固定信息站通过CAN总线把位置信息上传到井上主控PC机，在PC机上进行处理并在电子地图上显示出来。
The BS will send these information to main control PC computer on the ground through CAN bus, and the PC processes the data to get the MS location and displays it on the electronic map.
固定信息站通过CAN总线把位置信息上传到井上主控PC机，在PC机上进行处理并在电子地图上显示出来。
The BS will send these information to main control PC computer on the ground through CAN bus, and the PC processes the data to get the MS location and displays it on the electronic map.
应用推荐