研究了串行输入，并行输出单向移位寄存器的功能。
The function of the single-direction shift register which is serial input and parallel output is mainly studied.
设计一种以串行输入为基础，串并混合方式输出的多路控制系统。
A multiplex control system based on serial entry and output in series-parallel mixed mode is designed.
在该编码器中，信号细分、码制变换、校正、显示、串行输入和输出均由单片机完成。
In the encoder, the microcomputer is programmed to perform subdivision, code conversion, correction, display, serial inputs and outputs.
检测的水表数据通过单片机串行输入到CAN总线驱动器并经过总线驱动器、中继器实现信息的网络传输。
The measured data of water meter is input by micro-computer to CAN Bus-driver serially. And, through Bus-driver and carrier, network transmission of information is realized.
其中有两个构造器：一个用于将MIDIShortMessage对象串行输入到字节阵列，而第二个用来将字节阵列和主题反序列化到MIDI ShortMessage中。
There are two constructors; one is used to serialize a MIDI ShortMessage object into a byte array whilst the second is used to deserialize a byte array and topic into a MIDI ShortMessage.
该串行数字高清视频信号将作为高清编码器的输入源，可以用于完成高清数字视频节目的制作。
The serial digital high definition video signal will be used as an input source for high definition encoder and generate high definition video programs.
输入/输出接口包括USB、CAN、以太网和串行数字输入输出，全部集成在一片比iPodNano还小的卡片上。
I/O options include USB, CAN, Ethernet, and SDIO, all packed into a card that is smaller than an iPod Nano.
采用自顶向下的设计方法，用原理图和VHDL语言这两种输入对串行通信接口芯片进行设计。
The serial communication interface chip design was realized by application of schematic diagram and VHDL language.
移位寄存器是一种能以串行和并行方式输入信息的装置。
The shift register is a device in which information may enter sequentially or in parallel.
实验结果表明，可以通过采集手写输入设备和通信电台的串行数据信息，实现交换控制的功能。
Experiment results show that exchange control can be realized through the collection of serial data of the handwritten input equipment and the communication radio.
简述了以串行方式输入8位数字信号、最大可控电流为2A的数控恒流器件的设计思想和性能。
This paper presented the design thoughts and character of digital control current regulators, using 8bit digital signal of DAC serial input data and about 2a supreme output current.
利用双向串行端口，可在软件中进行输入通道选择、增益设置和信号极性配置。
Input channel selection, gain Settings and signal polarity can be configured in software using the bidirectional serial port.
设计了PLC与PC机串行通讯口之间信号适配器硬件电路，包括输入接口电路、输出接口电路。
This research works out a design of signal adaptor circuit of serial communication port between PLC and PC, including input interface circuit and output interface circuit.
该系统可实现油温检测、闪点检测、加热器控制、键盘输入及LCD显示、RS- 232及RS - 485串行通讯等功能。
This system has functions of petroleum temperature measuring, PPCFP testing, heater control, keyboard input and LCD display, RS-232 and RS-485 serial communication and so on.
在串行数据输入（DI）或输出（DO）时使用的时钟信号。
Used as the synchronization clock when inputting (DI) or outputting (DO)serial data.
所设计的芯片是32个输入32个输出的交叉点开关阵列，每一个输出都能连接任何一路输入，采用串行数字控制方式。
The chip is a crosspoint array with 32 outputs, each of which can be connected to any one of 32 inputs. The chip is programmed in serial mode.
该编码器的信号输入包括两种类型，模拟音频信号的输入和串行数字音频信号的输入。
There are two kinds of input signals in this encoder: analog audio signal input and serial digital audio signal input.
两线串行接口，实现输出会被强制平仓，调整和上升和下降，在可编程的摆率与测序的延迟时间。 输入和输出电压，以及输入和输出电流和温度是可读的。
The two-wire serial interface enables outputs to be margined, tuned and ramped up and down at programmable slew rates with sequenced delay times.
请确保已正确输入串行。
有四个逻辑输入口和四个继电器，使界面连接闭包和RS- 232、RS - 485串行端口。
It offers four logical inputs and four relays for interfacing to contact closures and RS-232 and RS-485 serial ports.
有四个逻辑输入口和四个继电器，使界面连接闭包和RS- 232、RS - 485串行端口。
It offers four logical inputs and four relays for interfacing to contact closures and RS-232 and RS-485 serial ports.
应用推荐