USB和串行计算机连接。
本文讨论了串行计算机的加速计算方法、流水线计算机的效率及其性能价格比。
This paper presents the computational method of serial computers, the efficiency of pipeline computers and their performance-cost ratio.
提出了一种基于椭圆曲线的流水线实现方法，来解决串行计算的效率低下问题。
In this paper, a pipelining approach for elliptic curve cryptography is proposed to solve the problem of low efficiency in sequential implementation.
针对通常的串行计算机的串行最短路径算法，几乎已经到达了理论上的时间复杂度极限。
The usual sequential shortest path algorithms executing on sequential computer have nearly reached their time complexity limits.
用传统的串行计算方法来处理参数率定问题，其计算时间过长，无法快速给出准确的模型。
The traditional serial computational method might meet with problems of needing too much time or resulting with an undetermined parameter.
串行计算由于受到物理极限的限制，使得为了满足人类这一无止境的追求——超高速，人们必然求助于并行计算。
On the account of physical extreme limit of serial computation, people ultimately resort to parallel computation to cater for the man's unending pursuit-ultrahigh speed.
目前大型数值模拟用串行计算需要花费大量的时间，而采用并行计算有可能提高FLUENT软件模拟计算的速度。
The large-scale computation needs to cost many time with the serial computing now. However it may enhance the computation speed of the FLUENT with the parallel computing.
瞬态响应分析是有限元动力分析的重要内容之一，而串行计算机上运行的有限元软件在解题规模和速度上都受到很大限制。
Transient response analysis is an important part of finite elements dynamic analysis. Problem scales and velocities of serial softwares are limited on serial computers.
本文描述SPESEC的设计目的、性能特点和SPESEC提供的并行程序环境，也给出在串行计算机上实现SPESEC的某些细节。
This paper describes the design goal and performance of SPESEC and the parallel programming environment with SPESEC. Some details of its implementation on the serial computer are also given.
在实现FIR滤波器及相关器的时候，我们合理使用了串行计算和串行与并行结合的方法，把大量数据存储在块ram中，合理利用了芯片的资源。
In implementing FIR filter and correlator, we use the resource rationally by using method of serial and combine of serial and parallel, and saving a lot of data in block RAM,.
新的个人计算机现在都有通用串行总线插孔。
有一点很重要，那就是要使用零调制解调器电缆，如果您使用普通的串行电缆，目标计算机则期望与串行设备通信，而不是与另一个串行端口通信，这样您就无法调试该计算机。
It is important that you use a null modem cable; if you use a typical serial cable, the target computer expects a serial device and not another serial port, and you cannot debug the computer.
当您使用零调制解调器电缆在两台计算机之间建立直接串行连接时，您的电缆必须按下面清单1中显示的方式连接。
When you use a null modem to make a direct serial connection between two computers, your cable must be wired, as shown in Listing 1 below.
终端机也已经可以通过几根简单的串行线或者更复杂的多点系统，在短距离内与大型计算机或微型计算机连接。
Terminals could also be hooked up to mainframe and minicomputers over relatively short distances with simple serial lines or with more complex multidrop systems.
像串行端口一样，计算机上每一个usb端口都由US b控制器指定了一个惟一的标识数字(端口id)。
Like a serial port, each USB port on a computer is assigned a unique identification number (port id) by the USB controller.
下面显示的行星，每个位串行加法器控制，显示的元素，太阳系仪，其中每一个对应计算出地球的轨道。
Below the planetary display, each bit serial adder controls one element of the display, the orrery, each of them corresponding to calculate that planet's orbit.
零调制解调器 (Null modem)是一种使用RS-232串行电缆连接两台计算机的通信方式。
Null modem is a communication method to connect two computers directly using a RS-232 serial cable.
在本例中，必须配置目标计算机以接受串行端口到串行端口的连接。
In this case, you must configure the target computer to accept a serial-port-to-serial-port connection.
从Arduino获得数据最简单的方式是让此单元直接连接到主机计算机的UniversalSerialBus (USB)接口，像串行连接那样读取数据。
The simplest way of getting the data from the Arduino is with the unit connected directly to a host computer Universal Serial Bus (USB) interface, reading the data as if it were a serial connection.
该位串行加法器系统是选择了一个由于齿轮数齿轮系统的正常需要，使时钟的计算。
The bit serial adder system was chosen over a normal gear system because of the number of gears it takes to make the clock's calculations.
如果设备具有通用接口总线或串行接口，你可以通过一个带有相似界面的计算机来控制。
If the instruments have a GPIB or serial interface, you can control them with a computer equipped with a similar interface.
串行通讯是计算机常用的通讯手段之一，但其通讯速率较低。
Serial communication is one of the common means in computer communications, but its rate is low.
介绍了一种基于计算机通用串行总线接口的指纹采集器的设计。
The paper introduces the design of the fingerprint reader based on computer universal serial bus interface.
使用并行或串行电缆连接到其他计算机上。
Provides a connection to other computers via a parallel or serial cable.
上海大学研制成功的球面机器人控制系统采用了基于VB与单片机的串行通信的两级计算机控制。
Shanghai University has developed a kind of robot, whose control system consists of a master-slave computer system based on the serial communication between VB and microcontroller.
根据关键路径法和串行调度原理，论述了先序活动和后序活动时间参数计算的方法，并以实例阐述了计算原理。
According to critical path method and serial scheduling, a schema was discussed for computing time parameters of transitive predecessors and transitive successors.
仪器具有标准串行通讯RS- 232c接口，可实现与电脑或计算机的通讯。
In apparatus having a standard serial communication RS-232C interface, can be realized with the computer or computer communication.
其中计算单元是传统串行程序模块。
提出了基于任意分割的规则获取方法和相应的串行进位链计算流程。
The method of rules extraction and calculating process with serial carry chain based on the arbitrary division are presented.
目前的多项式处理系统均采用表加工语言LISP或科学计算语言FORTRAN等，在一般串行机上实现。
At present nearly all systems of polynomial manipulation are written by LISP or FORTRAN, and run on a serial computer.
应用推荐