文章给出了三角波的框图和原理。
Black diagram and the fundamentals of the triangular wave generator are given.
其波形有方波、正弦波、三角波和锯齿波等。
The waveform square wave, sine wave, triangle wave and the sawtooth wave, etc.
图5显示当电路输入采用三角波的输出电压。
Figure 5 shows the output voltage when you apply a triangular waveform at the circuit's input.
还有方波，三角波的不同的VHDL程序实现。
There square, triangular wave of the different VHDL program.
该函数信号发生器可输出三角波，方波和正弦波。
The generator can output three kinds of waves : sine wave , square wave , triangle wave.
三角波制取的膜层耐磨性能优于矩形波制取的膜层。
The wearing resistance of the coating made with triangular wave is better than that one made with rectangular wave.
最后得出谐波激励比对称三角波激励效果好的结论。
It is concluded that it is better to use harmonic wave as exciting wave than to employ symmetrical trigonometric wave.
介绍了机头的结构设计和应用三角波触动机械的方法。
The mechanical construction of transducer and its driving by triangle wave are illustrated.
系统地研究了三角波调制时分割乘法器的数学模型及误差。
The error and model of triangle modulated TDM were investigated systematically.
通过修改数据表可以产生方波、三角波或其他任意波形信号。
Square waveform, triangle waveform and arbitrary waveform may be obtained by modifying the look-up table.
电压信号可根据需要设置成脉冲波、三角波、直流等不同信号类型。
The voltage signal can be changed into a lot of wave forms such as pulse wave, delta wave, DC signal.
程序稍作修改还能生成并输出任意波形，如三角波、方波、锯齿波等。
If the programs are slightly changed, any waveform can be generated and output, such as triangle wave, square wave and zigzag wave, etc.
实验温度为室温，循环应变比和应力比均为0.1，载荷波形为三角波。
The fatigue tests were performed at room temperature and cyclic strain and stress ratio of 0.1 with triangle load wave.
经过实验验证，对于正弦波、三角波和方波，负载输出电流波形跟踪良好。
For sine wave, triangle wave, and square wave, the good performance of current output is proved by experiments.
该文还指明了系统设计要点及控制所采用的三角波调制pwm电流控制法。
The current control scheme with triangle-intersection-technique based PWM is adopted and analyzed, the key point for system design is point out.
驱动电机使用三角波驱动器控制角度，负载吸收电机通过矩形运动控制转矩。
The drive motor USES triangular wave drives for Angle control and the load absorption motor USES rectangular movements for torque control.
波整形电路从核心电路的锯齿波得到其他想要的波形——方波，脉冲波，三角波。
Wave shaping circuits derive the other desired waveforms — square, pulse, triangle, etc. — from the sawtooth output by the core circuit.
故基本选代学习控制是不能直接应用于类似于方波、三角波这样的曲线的跟踪中。
So basic iterative learning control algorithms can't be used in the case which the trajectory is square wave or triangle wave.
本文还详细分析了滞环比较控制方式以及三角波比较控制方式，并进行了仿真比较。
The hysteretic loop comparator control method and the triangular wave comparison control method have been analyzed in detail. The simulation and comparison is made.
采用比例控制算法研究行波超声波电机对三角波、正弦波曲线的快速位置轨迹控制。
Besides, the position tracking control of USM for triangle and sinusoid is studied by means of P-control.
通过对三角波扫场信号产生的分析，对其在光泵磁共振实验中的作用作了具体的解释。
The formation of the triangle scanning field signal used in optical pumped magnetic resonance is analyzed, and its function in the experiment is also explained concretely.
补偿电流跟踪控制选用三角波比较控制法，并采用带电压前馈控制的比例调节闭环控制。
Compensatory current control adopts triangle wave compare control, and DC voltage control adopts PI closed loop control.
小于0.5伏的三角波电压经放大后再显示，该电路可作为各种电化学仪器的显示单元。
The ramp voltage less than 0. 5v will be displayed after amplification. The circuit can be used as display unit for various electrochemical instruments.
且易于数字控制，实时性好，同时输出控制采用三角波比较方式，有效减小了输出的谐波。
It has good real-time performance and is easy of digital control. The triangular wave comparison mode is used in output control to decrease output harmonic effectively.
在充分油门，积分电压(1.45v)始终是上述三角波电压，使z 1 b仍然偏高。
At full throttle, the integrator voltage (1.45v) is always above the triangle wave voltage, so Z1B remains high.
由于坡道移动更远积极的，三角波的比例将超过坡道产生了广泛和更光明的光脉冲电压低。
As the ramp moves farther positive, a greater percentage of the triangle wave will be lower than the ramp voltage producing a wider pulse and brighter light.
在分析三角波调制的线性调频信号的基础上，提出了用DDR技术消除速度对测距的影响方法。
On the bases of analyzing triangle wave form modulated LFM, the method of using DDR (Dual Channel Directional Doppler range) technique to eliminate the influence of speed to range is presented.
当适当的调整，三角波(它会出现全国C3)的将振荡之间的大约为1.2v和1.4 v。
When properly adjusted, the triangle wave (which appears across C3) will oscillate between about 1.2v and 1.4v.
该方法利用三角波信号作为测试激励，采用码密度直方图分析方法快速计算ADC的各静态参数。
The static parameters of ADC were extracted from the histogram of ADCs out codes, which was stimulated with triangle-wave signal.
该方法利用三角波信号作为测试激励，采用码密度直方图分析方法快速计算ADC的各静态参数。
The static parameters of ADC were extracted from the histogram of ADCs out codes, which was stimulated with triangle-wave signal.
应用推荐