计算所得的桨叶排出流的三维速度分布与实验结果大体一致。
The calculated three-dimensional velocity distribution of impeller discharge flow basicly meets the experiment results.
应用三维粒子动态分析仪 （3DPDA）测得了矩形截面三分支联接的三维速度分布。
The three dimensional velocities of the manifold junction with rectangular section are measured by use of three dimensional particle dynamic analyzer(3D-PDA).
利用ANSYS和MATLAB软件，对缩放型片材机头中熔体的速度、压力和剪切应力的分布进行三维有限元模拟和分析。
Softwares ANSYS and MATLAB were employed to analyze and simulate the velocity, pressure and shear stress distribution in sheet extruder dies based on the three-dimensional FEM.
通过求解三维层流N-S方程，得到了端面气膜稳态压力场及速度场分布，分析了气体在端面间隙内的流动形式。
The three-dimentional laminar Navier-Stokes equations were solved for getting the gas film pressure and velocity distributions in the steady state, and the flow styles in the clearance were analyzed.
本文利用ANSYS和MATLAB软件，对鱼尾型片材机头中熔体的速度、压力、剪切应力和粘度的分布进行三维有限元模拟和分析。
The software ANSYS and MATLAB were employed to analyze and simulate the velocity, pressure, shear stress and viscosity distribution in fishtail sheet extruder die based on the three-dimensional FEM.
还讨论了速度成像方法中速度分布校正和重构三维光电子动能分布及角分布等问题。
Some aspects about electron imaging, such as the calibration of electron velocity and the calculation of angular and kinetic energy distribution are also discussed.
试验可以得出颗粒三维运动的瞬时速度，初步试验得出颗粒的纵向平均速度遵循对数分布，颗粒速度小于相应水流的运动速度。
The results of preliminary experiments show that the distribution of stream-wise particle velocity follows the log-law, and the particle velocity is lower than the corresponding clean water flow.
然后用拟谱法求解PAM水溶液在圆管中流动，得到速度分布、应力分布，为三维模拟作准备。
Then it is used to solve the flow of PAM solution in a circular tube. The velocity and stress distributions obtained can be used for the three dimension numerical simulation in the future.
得到了连续挤压成形过程中任意步骤时的三维应力场分布、应变场分布、速度场分布情况。
Have gotten the 3d stress, strain and velocity distribution of arbitrary step in continuous extrusion course.
本文采用三维模拟方法，考虑保护气和侧吹气的影响，对激光感生等离子体中的温度与速度分布进行了研究。
The laser-induced plasma plume characteristics have been studied by use of a 3-D modeling approach including the effects of the coaxially and laterally injected gases on the plasma pl…
本文采用三维模拟方法，考虑保护气和侧吹气的影响，对激光感生等离子体中的温度与速度分布进行了研究。
The laser-induced plasma plume characteristics have been studied by use of a 3-D modeling approach including the effects of the coaxially and laterally injected gases on the plasma pl…
应用推荐