He puts the hamster on the bar and it runs to the end of the bar, down a barstool, across the room, up the piano, jumps on the key board and starts playing Gershwin songs.
他把仓鼠放到吧台上，仓鼠嗖跑到吧台边上，跳到一把椅子上，然后穿过房间，上了钢琴，在琴键上跳着演奏‘格什温’的歌。
"You end up with a bar code situation, whereby each individual has a slightly different bar code," he says.
他说“最后每人有个条码系统，借此，不同个体的条码也有细微的差异。”
Bearings are located between the first end of the torsion bar and the center bore of the balance shaft, to center the torsion bar within the balance shaft.
多个轴承位于该扭力杆第一端与该平衡轴中心孔之间，将该扭力杆置于该平衡轴的中心。
Since the shadow is the same color as the side of the bar, our mind converts the whole bar on that end into a shadow.
而且因为阴影的颜色跟横木的颜色相同，我们的潜意识就把左边的整根横条看成了阴影。
When the novel pry bar is used, the front end of the bar body is inserted into one pry bar hole. The head of the hasp is clamped into the other pry bar hole.
本新型撬棒在使用时，将棒体前端插 于其中一个撬棒孔内，搭钩的头部卡入另一个撬棒孔中。
More than one elongated decompression planes on the surface of the intramedullary nail bar extend from the proximal end to the distal end of the intramedullary nail bar.
在髓内钉杆表面设有一条以上呈长条形的减压平面，减压平面可从髓内钉杆近端直至髓内钉杆远端。
III. The short sphere-end bar (short bar) is used to adjust the left-turn and right-turn springs for their same length.
用来调整左右旋弹簧螺旋长度不相等的调整部件。
The shield is slipped down over the bus bar conduit tube to expose the bus bar end connector.
护罩在母线导管上向下滑动，以露出母线端部连接器。
A limit baffle plate which is matched with the accelerator transmission bar is arranged on the brake transmission bar, and the upper end of the brake transmission bar is connected with a vehicle body.
在刹车传动杆上设有与油门传动杆相适配的限位挡板，刹车传动杆的上端与车体相接。
Within 200mm area of re-bar end surface, it should be free of rust, oil dirt, concrete slurry etc. The contaminated re-bar should be cleaned for electroslag welding.
钢筋端部200mm范围不应有锈蚀、油污、混凝土浆等污染，受污染的钢筋应清理干净后才能进行电渣压力焊焊接。
Within 200mm area of re-bar end surface, it should be free of rust, oil dirt, concrete slurry etc. The contaminated re-bar should be cleaned for electroslag welding.
钢筋端部200mm范围不应有锈蚀、油污、混凝土浆等污染，受污染的钢筋应清理干净后才能进行电渣压力焊焊接。
应用推荐