The remote intelligence resources can be seamlessly integrated in this framework, such as conception design, optimal design and the analysis of structural strength et al.
在此平台上可以将异地分布的各种智力资源，如支持概念设计、优化设计、强度分析等资源无缝连接起来。
The results prove that the initial bonding strength mostly depends on total reduction and heating temperature of al.
结果表明，轧制变形程度和铝层加热温度都是影响复合板初结合强度的主要因素。
Al-Mg alloy has good corrosion resistance and high low temperature strength, which is now widely used in oxygen preparation equipment of air separation plant.
铝镁合金具有良好的耐腐蚀性和较高的低温强度，目前广泛应用于空分装置的制氧设备中。
The uniform axis compression capability of spherical pore Al alloy foam was studied and the relationship between compression strength and relative density was acquired.
研究了球形孔泡沫铝合金的单轴压缩性能，得到了抗压强度与相对密度的关系；
The results show that interface element diffusion and reaction on interface in vacuum hot-pressing sintering processing improved interface strength. Fracture occurred mainly in Al matrix.
结果表明，真空烧结过程中出现了界面反应，改善了界面结合强度，断裂破坏主要在基体上进行。
Ta coating was prepared by plasma spraying, which composition and morphology were investigated using SEM, also the bonding strength between Ta coating and Al substrate was tested.
采用等离子喷涂法制备了钽金属涂层，用电子显微镜分析了不同工艺条件下钽涂层的化学成分、表面形貌，测试了涂层与基材的结合强度。
On the contrary, the strength of paper can be further improved when the amount of carboxyl groups in AL increases.
相反，增加碱木素中的竣基含量则能使纸页强度有所提高。
The orthogoi al multilayer sandwich plate which provides considerable strength, stiffness and stability has been used in some important engineering structures, such as the composite material bridge.
正交各向异性多层夹芯层板具有较好的强度、刚度和稳定综合性能，已在一些重要承力结构（如复合材料桥）中应用。
It was proved that high velocity arc spraying Ni-Al coating is one of best intermediate coatings with high adhesive strength and fine structure.
高速电弧喷涂镍铝涂层结合强度高，涂层组织致密，是优良的打底涂层。
Based on compression curves of spherical pores al foam measured, compressive yield strength and energy absorption were investigated.
在获得球形孔泡沫纯铝压缩应力-应变曲线基础上，研究了泡沫纯铝的压缩屈服强度、吸能能力。
Made of spaceflight Al-Ti alloy and super high strengthened alloy steel material, high strength, light weight.
采用航天铝钛合金及超高强度合金钢材料，强度高，重量轻。
The research of Al-based amorphous alloy is regarded in recent years because of the demand in high strength-low density materials.
铝基非晶合金的研究在最近些年得到了重视，这缘于人们对高强度低密度材料的需求。
The results show that RE-Al alloying can improve the hardness, the strength and the oxide film density of the piercing plug.
研究结果表明，稀土铝合金化可提高材料的硬度、强度及氧化膜的致密度。
PM high strength al alloy is very important light weight material in automobile.
粉末冶金高强度铝合金是重要的汽车轻量化材料。
The variation laws of microstructure and strength of 1420 Al Li alloy ingot during the heating were studied.
研究了 14 2 0铝锂合金铸锭在加热过程中组织和强度的变化规律。
Carbonation reduces the pore size distribution and porosity of carbonated and non-carbonated part, and affects the concrete weight, strength, alkalinity et al.
碳化减少碳化区和未碳化区孔径和孔隙率的同时也影响混凝土质量、强度和碱度等其它性能。
If the Al film on the bond pad is pierced through by the probe in wafer probing, the wire bonding strength and device reliability would be affected.
在芯片测试中，若引线焊盘上的铝层被探针扎穿，就会影响引线键合的牢固性和器件的可靠性。
The adherence characteristics have been investigated by measurement of adherence strength of Al-Zn alloy coated steel enamel samples.
通过对覆铝锌钢板搪瓷样品的密着测试，研究了搪瓷的密着性能。
In order to improve the mechanical properties of die cast aluminum alloy, trials of study on die cast and heat treatment of Al-Cu alloy which is of high strength and ductility have been carried out.
为了弥补目前压铸铝合金强韧性不足，进行了高强韧铝铜系合金的压铸及热处理的试探性研究。
Low temperature aging for die casting al alloy under appropriate technological condition can increase average strength and Brinell hardness more than 10% and 30% respectively.
对压铸铝合金进行低温时效，在最佳工艺条件下，合金的平均拉伸强度提高10 %以上，布氏硬度提高30 %以上。
Kim et al. compared trunk muscle strength between patients treated with open posterior spinal instrumentation and those managed with percutaneous instrumentation12.
Kim等对行开放式后路脊柱内固定患者与经皮内固定患者的躯干肌力进行对比12。
The principle of improving the strength and corrosion resistance of the al…
同时讨论了DSA处理改善合金强度和抗蚀性能的机理。
The equipment shall be suitable for welding high-strength steel, Ti alloy and Al alloy.
该套设备适用于高强钢、钛合金、铝合金等金属的焊接。
The casting properties of high strength Aluminum alloy ZL205A and the casting technology of complex Al Cu alloy stand casting were studied.
介绍高强ZL2 0 5A合金铸造特性，分析高强复杂铝铜合金支座铸件结构特点和工艺特性及支座铸件铸造工艺。
Strength(failure)theory for geomaterials is an important and essential problem in civil, hydraulic, mining, railway and highway engineering et al.
岩土类材料的强度理论是土木、水利、铁道、矿业等工程中的一个重要的基本问题。
Strength(failure)theory for geomaterials is an important and essential problem in civil, hydraulic, mining, railway and highway engineering et al.
岩土类材料的强度理论是土木、水利、铁道、矿业等工程中的一个重要的基本问题。
应用推荐