An air bubble ascending from the ocean floor contorts and twists into a semicircle as a wave breaks in the background.
当波浪在背景中破碎时，从海底升起的气泡扭曲成半圆形。
You see that nice air bubble at the top?
看到顶部漂亮的气泡了吗？
聚乙烯气泡机；
A new model for mass transfer of air bubble in water is established.
建立了气泡传质的新的数学模型。
Wait, put down that syringe—a large air bubble in a blood vessel can kill you.
等等，放下注射器——血管里如果出现一个大气泡，则会致人死命。
This article introduces an air bubble method for low speed flow visualization in water tunnel.
本文介绍一种用于低速流动显示的空气泡方法。
Waterproof: for PEVA rubber material closed type air bubble structure, each of the gas chamber in close condition.
防水：材质为PEVA橡塑密闭型气泡结构，每个气室处于封闭状态。
The present invention provides an air-bubble atomizing device capable of effectively producing a plurality of fine air bubbles.
本发明提供一种能够高效率地大量产生微细气泡的气泡微细化器。
The porous concrete can be made up by using the natural zeolite as an air bubble carrier and carrying the air into the plaster.
利用天然沸石岩作为气体载体把气体带进料浆中配制成多孔混凝土。
The reasons of air bubble appearing in injection product were discussed from produce technology and the corresponding solutions were presented.
从注射成型的工艺过程入手，讨论了注塑制件气泡形成的原因，提出了相应的解决方法。
At the place of installation, level the balance using the leveling feet so that the air bubble is centered within the circle of the level indicator.
在电子天平使用地点调整地脚螺栓的高度，使水平仪内的空气泡正好位于圆环的中央。
The tests show: there are steady arc burning, fully fused weld joints, good connection between base metal and weld joint, no air bubble, cracks etc.
试验过程电弧燃烧稳定，焊接接头充分熔透，母材与焊缝连接良好，未见气孔、裂纹等缺陷。
Too much retract: Air bubble, burns, and unstable melt cushion.
回吸量太大：气泡，焦斑，料垫不稳。
According to the structure and technical requirements of pin terminator plastic products, the unqualified products such as surface air-bubble and long needle deflection are analyzed and improved.
根据端子产品塑件的结构、技术要求，对生产过程中产生的造成产品不合格的表面气泡和长针歪斜等因素进行了分析和改进。
According to the structure and technical requirements of pin terminator plastic products, the unqualified products such as surface air-bubble and long needle deflection are analyzed and improved.
根据端子产品塑件的结构、技术要求，对生产过程中产生的造成产品不合格的表面气泡和长针歪斜等因素进行了分析和改进。
应用推荐