简要介绍了采用汽轮机拖动高炉鼓风机调节与保护的要求、控制原理及其系统设置，并提出了应用中应注意的问题。
The regulation and protection requirements, control principle and system installation for BF blast are described in brief, and problem to be paid attention in application is put forth.
将燃烧控制开关3kk手柄先向右转45度到扫气档，接触器2jlc接通鼓风机运转。
Put burning control switch 3kk hand lever turns right 45 degree to scavenging shelve, contactor 2jlc collects and then air blower works.
叙述了鼓风返烟烧结机的投产实践，介绍了工艺参数的确定，生产过程的控制，出现的问题及解决措施。
The paper describes the practice of put into operation for up-draught gas back sintering machines; introduces technical parameters determined and production control and solve measures for problems.
整个控制系统由模糊控制器、鼓风曝气系统、频调速装置和溶解氧测试仪组成。
The control system consists of fuzzy controller, blast and aeration system, frequency control equipment and DO tester.
介绍了某镍冶炼厂鼓风炉控制系统。
The paper introduces the nickel smelting blast furnace control system.
结合高炉鼓风机系统的工作原理和控制目标，提出了高炉鼓风机控制系统的结构和总体设计方案。
Combined with the work principle and control target of the blast furnace blower system, the construction and the general design project of the control system are put forward.
煤气冷凝鼓风机组技术改造选用D750 -28型鼓风机，采用增速型液力偶合器调节负荷及计算机控制系统。
In a coal gas blower set for condensation were incorporated D750 28 blower and speed up hydraulic coupler to adjust load as well as computer control system.
本文介绍铜冶炼鼓风炉生产过程的自动控制要求以及小型集散控制系统在该过程的应用情况。
This article presents the requirement of automatic control for the production process of a copper smelting furnace and the application of DCS to process.
介绍了高炉鼓风机的防喘振控制流程图，重点阐述了SLPC可编程调节器的工作原理及功能。
Flow chart of anti_surge control for blast furnace blower is introduced, working principle and function of SLPC programmable governor is set forth.
在分析高炉鼓风机工作原理的基础上，提出了高炉鼓风机寻优控制策略及控制目标函数。
Based on studying the principles of the blast furnace blower, the optimal control strategies and objective function for controlling are presented in this paper.
该文简要介绍了变频调速节能原理及在罗茨式鼓风机控制系统采用变频调速的效果与优点。
This paper briefly introduces the principle of energy saving of frequency control and the result and advantages of application frequency control in the control system of Roots blower.
冷凝风扇，步进电机，控制面板（器），传感器，鼓风机等。
Fan(C&R) Module, Stepper motor, Control panel (device), Sensor, Blower Unit, etc.
通过对鼓风水平式空气冷却器制造全过程中出现的质量问题进行分析，并提出相应的控制措施。
Some corresponding control methods were proposed through the quality analyses in the total fabrication procedure of the blower horizontal air coolers.
介绍了高炉离心式鼓风机计算机控制系统的软、硬件设计。
The design of both software and hardware of the computer control system for the blast furnace centrifugal blower are introduced.
介绍了凤凰山矿洗煤厂罗茨鼓风机房内外采用先进的噪声控制技术，有效地降低了罗茨鼓风机及周围的环境噪声。
The noise produced by Roots blower was effectively reduced with advanced noise control techniques in the coal washing plant of Fenghuangshan Mine.
分析了国内某大型铝厂焙烧炉用特大型室外鼓风机组的噪声现状，制定了相应的噪声控制方案。
The noise properties of a very large type of outdoor air blower unit in a very big manufacturing aluminum factory are analyzed, so schemes of control for the noise are worked out.
介绍采用PLC控制的铅鼓风炉加料系统。
The article describes the use of charge system of lead last furnace by PLC control.
详细介绍了高炉鼓风机寻优控制的实现方法。
The realization of the optimal control for blast furnace blower is illustrated in details.
该文简要介绍了变频调速节能原理及在罗茨式鼓风机控制系统采用变频调速的效果与优点。
The paper introduces application of frequency converting technology in control system of Roots blower, and describes the effects of energy saving and economic benefit.
该文简要介绍了变频调速节能原理及在罗茨式鼓风机控制系统采用变频调速的效果与优点。
The paper introduces application of frequency converting technology in control system of Roots blower, and describes the effects of energy saving and economic benefit.
应用推荐