同时还分析了电负荷及排粉机投运对高温过热器区域烟气参数偏置的影响。
Also analysed was the effect of electrical load and the commissioning of pulverizer exhauster on gas parameter excursion in the high temperature superheater zone.
对于以高温过热器为代表的炉内承压部件，其寿命损耗的主要方式主要是长期蠕变。
The pressure component inside the boiler, represented by superheater, whose main reason of life loss is long- term creep.
热速处理后组织部分保留了高温过热时的特性，从而使镁合金的力学性能和铸件质量得到提高。
The microstructure of AZ91 alloy keeps some characteristics of the high temperature melt after thermal rate treatment, which improves the mechanical properties and casting quality of magnesium alloy.
我们知道，火电厂锅炉高温过热器的过热汽温是一类非线性、时变大、大时滞、大惯性的典型对象。
We know that the superheated steam temperature of boiler superheated system in the fired power plant has nonlinear, uncertain, large time-delay and large inertial characteristics.
过热也会造成耗油，因为汽油中的物质会在高温下分解。
Excess heat can also contribute to fuel inefficiency, because the substances in gasoline can decompose because of high temperatures.
过热蒸汽干燥技术是使用高温蒸汽将密闭的环境中的物料内部的水分蒸发出来的干燥技术，具有干燥速度快，干燥品质好，节能等特点。
Superheated steam drying is a drying technique of using high temperature steam to evaporate materials inner water, it has feature of drying quickly, quality good, saving Energy and so on.
挡风玻璃以及封闭(不通风)的车厢放大了极端高温的影响，造成了电池过热，引发了爆炸。
What triggers the explosion could be the overheated battery caused by extremely high temperature magnified by the windshield (glass) and the sealed (unventilated) vehicle cabin.
而一般过热的锻材可通过高温快冷正火处理来改善其显微组织，从而获得NADCA (ASTM)标准的合格级别组织。
Generally the microstructure of the overheated forging can be improved by means of high temperature fast cooling normalizing so that the qualified level from NADCA and ASTM standards can be obtained.
采用自制净化剂和循环过热相结合的办法，研究了不同净化剂对DZ125高温合金的净化效果，探讨了复合熔盐的净化机理。
The undercooled DZ125 superalloy was investigated by the method of glass and molten salt purification combined with cycled superheating, the mechanism of purification by compound salt was discussed.
采用熔盐净化剂与循环过热相结合的方法，对DZ125高温合金晶粒细化机制进行了系统研究。
The grain refinement mechanisms of undercooled DZ125 superalloy melt were systematically investigated by the method of molten salt purification combined with cycled superheating.
电烙铁等高温发热装置应与电解电容器塑料外壳保持适当的距离，以防止过热造成塑料套管破裂。
Heaters of high temperature, such as soldering irons, should be kept away from the vinyl insulation sleeve of capacitor which to avoid the cause made over heat or break down to sleeve.
高温蠕变损伤是由于过热引起的，过热使金相组织内部产生蠕变空洞，在热应力下空洞扩展连接而形成蠕变裂纹。
Creep damage is mainly caused by superheat. Because of superheat, creep cavities are formed inside microstructure, under heat stress condition, growth and join of cavities induce creep cracking.
水不亦过热，不然高温会破坏药物成分，影响减肥效果，水温在50- 70度之间即可！
Do not have hot water, or high temperature will destroy the drug ingredients, affect the weight loss, water temperature at 50-70 degrees can be!
针对某电厂异种钢焊接接头高温早期失效的过热器管件进行了调查研究和失效分析。
The early losing effectiveness causes of the superheater pipe welding joint were investigated and analysed.
小型液压挖掘机在高温环境下因出现发动机过热现象而无法正常工作。
Due to over-heat phenomenon under high temperature work conditions, small-sized hydraulic excavators can't properly operate.
这种阀门每小时排放高温蒸汽btu的能力必须超过热水器每小时产生热量的能力。
This valve must also have an hourly rated temperature steam BTU discharge capacity not less than the hourly input rating of the water heater.
本产品主要用于锅炉、过热器、热交换器、冷凝器、催化管等用的耐高温、耐高压、耐腐蚀的钢管。
The seamless stainless steel tubes are mainly Used in boiler, over-heater, heat exchanger, Condenser and catalyst as high temperature and Pressure resistant, and anti-corrosive tubes.
通过热固性硅树脂膜的控制裂解和活化，开发出一种新型的可用于高温气体分离的硅膜。
A new silicon membrane, which is employable in gas separation at higher temperature, is developed by control pyrolysis and activation of a thermosetting.
本课题选取适合寿命评估的高温高压部件，如主蒸汽管道及过热器管进行寿命管理研究。
In this paper, high temperature and high-pressure components fitting for life assessment such as main steam pipeline and boiler tube were selected for life management studying.
通过热固性硅树脂膜的控制裂解和活化，开发出一种新型的可用于高温气体分离的硅膜。
A new silicon membrane, which is employable in gas separation at higher temperature, is developed by control pyrolysis and activation of a thermosetting. silicon resin membrane.
研究了熔体过热处理对M963铸造镍基高温合金凝固偏析的影响。
The effect of melt overheating treatment on the solidification segregation of M963 cast Ni-base superalloy has been studied.
温度过高和电机高温表明压缩机存在过热问题。
High discharge temperature and hot motor winding indicate compressors overheating.
在蒸汽管道，伴热管线、小型加热设备，采暖设备，温度要求不高的用汽设备，应该选用热静力型疏水阀。3。在高温高压过热蒸汽管线和设备上，应该选用过热蒸汽专用疏水阀。
In steam pipes, coupled heat pipelines, small heating equipment, heating equipment, air temperatures do not ask for the use of equipment, it should be the choice of hot static type steam traps. 3.
分析循环流化床锅炉运行中出现的高温再热器、二级过热器爆管和给煤系统旋转给料阀经常堵煤等问题。
The causes of SH and RH tube explosion and coal feed system jamming in the operating CFBB are analyzed.
封釉——100圈套，那仅仅硬蜡之类的东西，需求用高温溶解才会亮光，这个进程会造成漆层过热内伤。
12-100 seal trap, the only hard wax like, demand for high temperature dissolution will light, this process will cause overheating of internal coating.
高温高压法加速腐蚀。结果表明，C4镍基合金热影响区奥氏体晶粒长大，X60钢过热区为大块铁素体组织。
The results show that the coarse austenite grain in heat affect zone (HAZ) of Ni-base alloy is observed, mass ferrite appears in HAZ of X60 steel.
这些耐高温的塑料漏斗，是完美的测量和浇注过热或过冷的液体，而烹饪。
These temperature resistant plastic funnels are perfect for measuring and pouring hot or cold liquids while cooking.
这些耐高温的塑料漏斗，是完美的测量和浇注过热或过冷的液体，而烹饪。
These temperature resistant plastic funnels are perfect for measuring and pouring hot or cold liquids while cooking.
应用推荐