对电容式加速度计，为测量其电容的变化，通常需要带直流偏置的交流电压信号来驱动。
For capacitive sensing, driving signal with DC bias voltage and ac voltage is usually necessary for the measurement of capacitance.
前人在研究驱动信号对传感器的静电力效应时，用偏置电压极性为正—负配置的驱动信号进行研究。
The effect of electrostatic force of the drive voltage on the accelerometer had been researched when the bias voltage polarity is positive-negative configuration.
给出了驱动线圈和偏置线圈结构参数的计算方法。
The method of calculation of the bias and driven solenoid coil structure parameters is given.
其特征是不要外接偏置电压源，而由一个特殊隔离变换器将输入逻辑信号变换为能快速开通或关断IGBT模块的驱动电力。
Its feature is that the input logical signal is converted to drive power by a special isolated converter, which makes a IGBT module turn on or off quickly, without any other biased voltage sources.
设计了信号偏置电路和伺服阀驱动电路。
Designing the sign transfer board and the driver board of electric and hydraulic servo mechanism.
其设计特点是采用了共源共栅电流镜，运放的输出作为驱动的同时还作为自身的偏置电路；其次是采用了带隙温度补偿技术。
The cascade current mirror was used in the circuit, and the output of the OPAMP was used for the bias of itself and to drive the next stage.
图1 - 24所示的脉冲驱动模式使微欧姆计能够消除被测未知电阻上的寄生偏置电压。
The pulsed drive mode, shown in Figure 1-24, allows the micro - ohmmeter to cancel stray offset voltages in the unknown resistance being measured.
简要介绍了半导体激光器的温度特性的后，分析了激光驱动器偏置电流提供和自动功率控制(APC)功能。
After the introduction of the characteristics of semiconductor laser diode, the bias current supply of the laser driver and the automatic power control (APC) function were analyzed.
理论分析表明，正弦信号、带直流偏置的正弦信号和方波对光调制器的驱动结果是完全不同的。
The theoretical research shows that the effect of the driving signals of the sinusoidal wave and the sinusoidal wave with a bias and the square wave on the optical modulator is completely different.
保险171也可以配置为偏见投入视频驱动时，偏置视频信号的需要。
Ia 171 can also be configured as bias inputs video driver when bias video signals are needed.
NPN晶体管开关应用中，接口电路和驱动电路的应用。内置偏置电阻(100和100科姆)。
NPN transistor for switching applications, interface circuit and driver circuit applications. With built-in bias resistors (100 and 100 kOm).
上述偏置电路根据上述存储电路存储的上述检测结果，使用于驱动上述静电型致动器的驱动电压变化。
The bias circuit changes, on the basis of the estimation result stored in the storage circuit, a drive voltage to drive the electrostatic actuator.
由偏置在AB类的电流驱动的共源放大器构成输出级；
A current-driven common source amplifier which is biased on class AB constitute the output stage.
其中包括时序逻辑驱动电路、直流偏置电压电路及单芯片焦平面温度控制电路。
The circuit includes a sequential logic drive circuit, a DC bias voltage circuit and a monolithic temperature control circuit for the focal plane array.
NPN晶体管开关应用中，接口电路和驱动电路的应用。借助内置的偏置电阻(2.2和2.2科姆)。
NPN transistor for switching applications, interface circuit and driver circuit applications. With built-in bias resistors (2.2 and 2.2 kOm).
偏置式驱动轮与万向轮相结合，增加车子在操作过程中的稳定性，同时减少了万向轮的维修频率。
Offset driving wheel in combination with castor wheel increase stability of truck during lifting, while minimize the maintenance frequency compared to a single central wheel.
为补偿波形直流偏置电压，放大器对2.6V内部模拟地基准进行缓冲，并驱动用作LVDT模拟地回路的输出管脚。
To compensate for the waveform's dc-offset voltage, an amplifier buffers the 2.6V internal analog-ground reference and drives an output pin that serves as the LVDT's analog-ground return.
使用终端电阻也有不利的一面，它（额外地）加重驱动器的负载，增加装置的复杂性，改变偏置条件和造成系统日后修改困难更大。
There are disadvantages of termination as well. Termination increases load on the drivers, increases installation complexity, changes biasing requirements and makes system modification more difficult.
使用终端电阻也有不利的一面，它（额外地）加重驱动器的负载，增加装置的复杂性，改变偏置条件和造成系统日后修改困难更大。
There are disadvantages of termination as well. Termination increases load on the drivers, increases installation complexity, changes biasing requirements and makes system modification more difficult.
应用推荐