本文对阶跃载荷和冲击载荷给出了几个例子。
Examples are given for both cases of step-loading and impulsive loading.
主要的动态性能有：频率响应特性和阶跃响应特性。
Main dynamic performance is as follows, frequency response characteristic and steps response characteristic.
通过实验，对该动力机构阶跃响应特性进行了分析。
Through the experiments of the step response, the characteristics of the power mechanism was analysed.
通过试验得到了实测阶跃响应曲线和输出位移曲线。
The experimental curves of step response and output displacement were obtained.
倾斜和应变记录到同震阶跃，但持续时间相对较短。
The short coseismal step was recorded in tilt and strain data.
如果将一个阶跃电压施加到电路，会产生一个瞬态电流。
If a step voltage is applied to the circuit, a transient current is generated.
阶跃信号在地震仪的脉冲标定和检查中获得了广泛应用。
The step calibration signal has been widely used in seismograph calibration and check.
对自并励静止励磁系统发电机空载阶跃指标提出整定范围。
The setting range of no load voltage step response index for self excited shunt excitation system is put forward.
阶跃折射率光波导在理论上是所有其它光波导器件的基础。
The step index profile optical waveguide is the fundamentals of all other optical waveguide devices theoretically.
通过测试电烤箱的阶跃响应，用作图法得到电烤箱的模型。
From the step response of the electric oven, the model of the oven is obtained.
在目前这个设计中，阶跃输入信号限制在零点几毫伏以下。
In the present design, step inputs are restricted to a few tenths of millivolt.
第三章主要研究基于阶跃响应的系统动态特性的提取方法。
The method of extracting dynamic characteristics of system based on step response is researched mainly in chapter three.
通过动态标定实验，得到不同幅值的阶跃输入、输出数据。
Through the dynamic calibration experiments, the step input and output signals with different amplitudes are obtained.
分别考虑了两种简单情况下梁的响应：阶跃激励和脉冲激励。
Two simple cases, step and impulse function responses, were considered respectively.
利用线性系统的特点，给出使用阶跃响应获取阶跃力的技术。
Making use of the linearity of system, the technique of obtaining the step force from step response is developed.
由于屋脊边缘的特点不同于阶跃边缘，他们的检测方法也不同。
Because roof edge is different from step edge, their detection methods are different.
该控制算法，基于系统的阶跃响应，具有较强的稳定性和鲁棒性。
The control algorithm has the strong stability and the robust, based the system step response.
提出了一种基于最小二乘的多变量系统阶跃响应的模型辨识方法。
A model identification method on multivariate system step response based on least Square is given out.
将微波介质谐振器应用于阶跃管高次倍频器中，这是一种新的尝试。
Microwave dielectric resonators apply to SRD high-time frequency multiplier. This is a new try.
为了确定特定电压下的漏流，可以向该电路施加一个该幅值的阶跃电压。
To determine the leakage current at a particular voltage, apply a step voltage of this magnitude to the circuit.
通过各种阶跃输入下的开环响应试验，对烘干过程的动态特性作了调研。
The dynamics of drying process is investigated by step change response in a open-loop.
所得到的系统对阶跃输入，斜坡输入，正弦函数输入有很好的响应特性。
The system has obtained very good step response, ramp response and sine function response.
在阶跃轴压载荷情况下，动力载荷可能激发比静力载荷更高阶的屈曲模态。
Under the axial step load case, dynamic load tends to inspire a higher order buckling mode .
采用线性扫描伏安法和电位阶跃法，研究了锂离子在铝电极上的电极过程机理。
The Deposition mechanism of Lithium on aluminium electrode was studied by using linear sweep voltammetry and potential step method.
本文介绍了根据对象阶跃响应曲线进行数字PID调节器参数最优整定的方法。
This paper presents a method for optimizing the digital PID parameters on the basis of object unit-step response curve.
本文提出了在阶跃型及斜坡型参考输入及干扰下，鲁棒调节器的一种设计方法。
A robust controller design method for a system under step or ramp reference inputs or disturbances is presented in this paper.
接着推导了阶跃折射率平面介质波导和圆光纤的正交模式——包括束缚模式和辐射模式。
Then the mode series of step index planar dielectric waveguide and circular optical fiber are studied, including propagation modes and radiation modes.
相对于阶跃时刻，片层间距调整、界面平均生长速率与平均过冷度的变化均具有滞后性。
At the moment of step changing in velocity, the adjustment of lamellar spacing, the average velocity and the average interface undercooling characterize the hysteresis effect.
本文引入一种研究扩散光波导传播特性及设计计算的新方法——等效阶跃平板波导方法。
The equivalent step planar wave guide method is proposed to study the propagation properties and design of diffused planar wave guide.
本文引入一种研究扩散光波导传播特性及设计计算的新方法——等效阶跃平板波导方法。
The equivalent step planar wave guide method is proposed to study the propagation properties and design of diffused planar wave guide.
应用推荐