钢瓶可以配有用于气体提取的标准阀门或在内部连接到阀门的用于液体提取的虹吸管。
Cylinders can be supplied with standard valves for gas withdrawal or with siphon tubes connected internally to the valves for liquid withdrawal.
这些气体一般都是贮存在专用的高压气体钢瓶中。
These gases are generally stored in special high-pressure gas cylinders in the.
未经所有者同意重新灌装或运输压缩气体钢瓶是侵犯联邦法律的行为。
Refilling or shipping compressed gas cylinders without the consent of the owner is a violation of Federal law.
这些气体一般都是贮存在专用的高压气体钢瓶中。
These gases are generally stored in a dedicated high-pressure gas cylinders in the.
当有必要把钢瓶供应压力降到较低的使用压力时，下文对于用于易燃、氧化剂、腐蚀性、惰性或毒性气体的压力调整器是可以适用的。
The following is applicable to pressure regulators used with flammable, oxidant, corrosive, inert, or toxic gases, when it is necessary to reduce cylinder supply pressure to a lower use pressure.
使用减压调整器或单个的控制阀来安全地从钢瓶中排出气体。采用止回阀，防止回流入钢瓶。
Use a pressure reducing regulator or separate control valve to safely discharge gas from cylinders. Use a check valve to prevent reverse flow into the cylinder.
对于特种气体钢瓶，字母s G标在序列号之前。
The letters SG precede the serial Numbers for Specialty Gas cylinders.
图2上面是钢瓶的内部结构，左下是低压液体提取装置的俯视图，右下是液体和高压气体提取装置的俯视图。
FIG. 2 Internal Cylinder Configuration, top. Overhead view of low pressure liquid withdraw, bottom left. Overhead view of liquid and high pressure gas with-draw, bottom right.
未经所有者同意运输压缩气体钢瓶是侵犯联邦法律的行为。
Shipment of a compressed gas cylinder filled without the consent of the owner is a violation of Federal Law.
把易燃气体钢瓶与氧和其它氧化气体钢瓶分开储存。
Separate flammable gas cylinders from oxygen and other oxidizing gas cylinders during storage.
钢瓶可以单个使用，或者并联起来获得更大的气体储存容积。
Cylinders may be used individually or can be manifolded together to allow for larger gas storage volume.
这些气体是不可燃的，作为高压气体储存在钢瓶里。用于这些气体钢瓶的减压装置一般是CG - 1型。
These gases are nonflammable and stored in cylinders as high-pressure gases. The pressure-relief device used on these gas cylinders is normally Type CG-1.
每次钢瓶灌装时，要求压缩气体供应商检查钢瓶是否有可见的损伤。
Compressed gas suppliers are required to inspect cylinders for visual damage each time the cylinders are filled.
高压表的示值为钢瓶内贮存气体的压力。
High table showing the value stored in the gas pressure cylinder.
高压表的示值为钢瓶内贮存气体的压力。
High table showing the value stored in the gas cylinder pressure.
调整器的主要功能是，当钢瓶或过程管道内的高压气体从钢瓶流向设备时，把压力降到较低的可用的水平。
The primary function of a regulator is to reduce high-pressure gas in a cylinder or process line to a lower, usable level as it passes from the cylinder to a piece of equipment.
高压表的示值为钢瓶内贮存气体的压力。
Table showing the value of high-pressure storage of gas cylinder pressure.
二氧化碳作为液化压缩气体在空心钢瓶和铝瓶中运输和储存。
Carbon dioxide is shipped and stored as a liquefied compressed gas in hollow steel and aluminum cylinders.
通过水陆交通的二氧化碳气体钢瓶的运输必须符合DOT规范的49条，它说明了所要求的标签和鉴别。
The shipment of carbon dioxide gas cylinders by surface transportation must conform to DOT Regulations, Title49, which describes labeling and identification required.
大多数压缩气体钢瓶要求安装至少一个阀门。
Most compressed gas cylinders require the installation of at least one valve.
只有那些对危险十分熟悉且受到过正确操作技术训练的人才可以操作压缩气体钢瓶。
Compressed gas cylinders should be hanDled only by those familiar with the hazards and who are trained in the proper hanDling techniques.
只有那些对危险十分熟悉且受到过正确操作技术训练的人才可以操作压缩气体钢瓶。
Compressed gas cylinders should be hanDled only by those familiar with the hazards and who are trained in the proper hanDling techniques.
应用推荐