这节课主要讨论速度和加速度。
目前为止，是关于速率，平均速度和加速度。
All right, so far, about speeds and average velocities and accelerations.
通常需要仔细地分析位移，速度和加速度。
Detailed analysis of displacements, velocities, and accelerations is usually required.
利用一、二阶影响系数矩阵分析速度和加速度。
Velocity and acceleration are analysised with frist and second-order effect coefficient matrix.
再来深入研究一下参数方程，我们以前还学过速度和加速度的。
Ok, so let me move on a bit and point out that with parametric equations, we've looked also at things like velocity and acceleration.
经插值后关节空间的速度和加速度的线图轨迹平滑。
The trajectories stand for the velocity and acceleration of joint space after interpolation are smooth.
龙门双驱结构，高阻尼床身，刚性好，速度和加速度高。
Gantry double driving structure, high damping bed, good rigidity, high speed and acceleration.
运用哥氏定理求解质点的速度和加速度，分析其物理内涵。
It also USES the Coriolis Theorem to find out the velocity and acceleration of them and to analyze their intension in physics.
应用转动规范理论建立惯性系与非惯性系之间速度和加速度转换关系式。
A method for transforming acceleration and velocity in inertia system to non-inertia system is presented based on rotor theory.
提出求解机器人臂平面多自由度机构的速度和加速度的CAD变量几何方法。
CAD variable geometric method was put forward to solve the velocity and acceleration of planar multi-DOF mechanism of robot arms.
根据该振动筛的工作原理，得出了筛箱运动位移、速度和加速度等运动方程。
According to working principle of the linear shale shaker, the movement equations about displacement, velocity and acceleration are given.
本文采用解析法导出了这种差动机构中拔取罗拉的位移，速度和加速度的方程式。
The analytical method is applied in deriving equations for the displacement, velocity and acceleration of the detaching roller installed in the differential mechanism.
二是可以适当的选择位置、速度和加速度反馈增益矩阵，从而加快误差收敛速度；
Second, the rate of error convergence may be guaranteed rapidly by setting appropriate angular position, velocity and acceleration feedback gain Matrices;
结果表明，该地下厂房主要部位的动应力、位移、速度和加速度幅值满足振动允许标准。
Results show that amplitudes of dynamic stress, displacement and acceleration meet the suggested vibration standard.
随着被测目标运动速度和加速度的不断提高，导致光电经纬仪电视跟踪的动态误差急剧增大。
With the increase of the velocity and acceleration of the moving target, it produces a large accretion of dynamic error of O-E theodolite.
在此基础上，讨论了机构参数对齿环滑块的速度和加速度、系杆的角速度和角加速度的影响。
And based on this condition, there is a discussion on the effect to the slider's velocity, acceleration, and rod's angular velocity and angular acceleration caused by mechanism parameters.
以可靠性工程和机构概率设计等理论为基础，详述了机构位移、速度和加速度的可靠性问题。
Based on the theory of reliability engineering and probability design of mechanism, the reliability problems of displacement, velocity and acceleration of mechanism are elaborated.
结果表明，阻尼器能有效地降低结构的位移响应，但对结构速度和加速度的控制效果不明显。
The analysis results indicate that the SMA damper can suppress structural displacement response effectively and can suppress structural acceleration response to a certain extent.
机器人的运动学分析，是求解机器人的输入与输出构件之间的位置、速度和加速度之间的关系。
The kinematics analysis of the robots will work out the relations between the positions, velocities and accelerations of the input and output components.
采用心内超声组织多普勒显像技术获取窦性心律上述各点的二维、M型心肌速度和加速度图像；
M mode and 2D TDI were obtained to map myocardial velocity and acceleration with normal sinus rhyme at different sites of cardiac conductive system described above.
在圆弧运动功能模块里面，用户可以指定运动的半径、初始角度、运动角度、运动速度和加速度。
In the curve movement control functional module, the user can define the radius, original Angle, movement Angle, speed and acceleration of movement.
还综述了柱塞冲程、速度和加速度的计算，为特种抽油泵结构和工作参数的正确选择提供了依据。
The calculations for the stroke, speed and acceleration of the plunger are summarized, providing a basis for selecting the structure and working parameters of the pump.
随着被测目标速度和加速度的提高，对光电跟踪伺服系统的快速捕获能力也提出了越来越高的要求。
The high ability of optoelectronic tracking servo system to tracking and acquiring fast moving targets is required , along with the rapid enhancement of target speed and acceleration .
每一步通过交互输出的速度和加速度的估计值来计算转弯速率，它的大小等于加速度和速度的比值。
The turning rate is calculated at each step from the velocity and acceleration estimates of interacting output as the magnitude of the acceleration divided by the speed of the target.
并对正常功率输出状态下曲柄活塞机构的运动进行了动力学分析，得出了活塞的速度和加速度分布。
By added the servo motor, the simulation is realized, and the dynamic analysis is reported, thereby the velocity and acceleration of piston in normal power export state is acquired.
与利用速度和加速度信息反演的结果相比，利用位移信息反演的结果具有较高的精度和抗噪声能力。
We also observe that the inversed results based on observed response of displacement are better than the results based on responses of velocity and acceleration.
同时，在燃料床上进行模拟实验，测取了林火自水平燃料床进入倾斜燃料床后的火蔓延速度和加速度。
The process of fire spread from the lowest point of a slope to the maximum acceleration instant was simulated in a fuel bed.
同时，在燃料床上进行模拟实验，测取了林火自水平燃料床进入倾斜燃料床后的火蔓延速度和加速度。
The process of fire spread from the lowest point of a slope to the maximum acceleration instant was simulated in a fuel bed.
应用推荐