由于拉伸件在拉伸后边缘不平整，一般需要修边才能达到要求，通常采用侧切和旋切模实现。
Because after being drawn the edge of a drawing piece is no flattening generally it needs edge trimming to meet the demand usually realized by side-cutting and turn-cutting dies.
负责南平整个工厂的营运，以达到在产品成本、质量和交货期方面超越竞争对手。
Responsible to manage the total factory operation in Nanping to out-perform our competition in Cost, Quality and Delivery.
基础设施达到“七通一平”：市政道路、供水、供电、供暖、排水、排污、电信(宽带)，土地平整。
Infrastructure to meet the "seven Qualcomm one leveling" : municipal roads, water supply, electricity, heating, drainage, sewerage, telecommunications (broadband), land formation.
构件的垂直、平整度达到中级抹灰质量标准。
The smooth and vertical degree reaches the quality standard of intermediate plastering.
贴标时容器精密定点旋转，稳定贴标达到贴标外观平整美观，重叠时精密度高。
Precision fixed-point rotation of containers and high overlapping precision during labeling to yield steady labeling, and smooth and aesthetic exterior appearance.
利用尖形模具吹喷蒸汽和热风，使衣物瞬间达到自然平整的熨烫效果，不易产生极光；
The steam and hot wind go out from the sharp mould, it can makes the garment very smoothly and natural.
丙烯酸油漆平整度相容性挖掘保持干燥，要清除浮尘、旧涂层等，且达到一定的平整度和粗糙度。
Keep dry, to remove the dust, the old coating, and achieve a certain flatness and roughness.
平整机生产过程中，合理地设定轧制规程是使平整生产能够达到优质、高产、低消耗的关键。
ABSTRACT The setup of rolling parameters is key to producing of skin pass mill for good quality and high produce.
本机采用高精度前规、拉规，纸张进入复膜时平整，搭边误差少，达到国内领先水平。
The high-precision front gauge and draw gauge are used with the machine, so the paper is flat while feeding and the errors of edge covering are few. The machine is advanced at home.
结果表明：钢水余热烧结衬瓷技术保证了浇铸时产生较少的气泡，且衬瓷面平整，达到了可以应用的程度。
The experimental results show that the present lining-ceramic sintering technology can effectively reduce gas bubbles formed during pouring.
腐蚀后芯片表面平整度、侧蚀等指标初步达到器件设计的要求。
After etching the surface of GaAs chip could be smooth and the isolation grooves have little edges, which can completely meet the requirements of device design.
腐蚀后芯片表面平整度、侧蚀等指标初步达到器件设计的要求。
After etching the surface of GaAs chip could be smooth and the isolation grooves have little edges, which can completely meet the requirements of device design.
应用推荐